racing seat install questions
any of u guys had 6 point harness and racing seat installed on driver side ?
already bought seat and harness and resistor which is 3.3 oms 2w
my question is where u guys drill the holes for the harness
i am think to drill 4 holes on the floor
or
2 holes on the floor for the leg harness and 1 hole on the transmission
side with factor seat belt on the other side
still going to keep my stock seat belt for sure
any pictures will be helpfully
thx guys
update 2018 10 30
now i running a problem which my bracket is not allow me any lower
but it was just higher compare to stock seat position
any one using sparco ergo size m seat ?
i am using the sparco bracket they r not good for a tall guy
i am 183 cm
any one can help
i currently think to buy another bracket like buddy club or nagisa double lock bracket
the problem is buddy club my not solid with their rails
and nagisa seen be a best opinion, but when i connect to evasive they said it not going to fit my seat
i saw one guys using my seat with that bracket
i dont know neeed help
Last edited by jayliu.jiayu@gamil.com; 10-30-2018 at 11:59 PM.
|