Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post

zooki · 08-06-2012, 06:38 PM

OK, here's my question for the gurus:
I bought a set of Drag DR38 rims(17x7, 40mm offset). The front fit good, but the back look like they could be pushed out a bit more. Can I run a 5mm spacer in conjunction with the hub ring I needed to adapt the rims to the 56.1 center? Is there enough of a lip on the axle to properly center the hub ring even with the spacer installed? Thanks.

08-06-2012, 06:38 PM	#1
zooki Senior Member Join Date: Jun 2012 Drives: waiting on a 2021... Location: Texas Posts: 770 Thanks: 190 Thanked 410 Times in 233 Posts Mentioned: 3 Post(s) Tagged: 0 Thread(s)	5mm spacers and hub rings. OK, here's my question for the gurus: I bought a set of Drag DR38 rims(17x7, 40mm offset). The front fit good, but the back look like they could be pushed out a bit more. Can I run a 5mm spacer in conjunction with the hub ring I needed to adapt the rims to the 56.1 center? Is there enough of a lip on the axle to properly center the hub ring even with the spacer installed? Thanks.