I've been experimenting with load limits to fix that pesky 3000 - 3800 RPM range that always wants to go rich. Has anyone run into an issue where it seems like the load limits you set are ignored? For instance, I know that the load limit I set in the tune is 1.00 at 3800 RPMs, but when I review WOT logs after the fact, I see readings around 1.08 - 1.10 at that RPM point and I'm still a full point too rich.
I know you're probably thinking: "Did you flash the right tune?" And I'm certain that I did because I made changes to the KCA table in my tune and can see that change in my logs. I know that the actual load limit values get extrapolated between the RPM points, but when I have it set to 1.00 at 3800 RPMs, shouldn't I be getting much closer to 1.00 than the 1.08 to 1.10 I'm seeing? Anything else I could be missing?
|