Quote:
Originally Posted by spitsnaugle
I dropped the crossmember out. I'll try to document the bolts MM later. - One Plastic rivet each side at rear of crossmember
- One nut/bold to each to the LCA.
- Disconnected steering outer tie rods from hubs (at Castellated nut)
- Disconnected steering column, marked lines on column and rack to re-align splines.
- Disconnected sway bar from struts.
- Two bolts each side at rear of sway bar bracket.
- Two bolts each side of crossmember above LCA mount.
|
Quick question regarding the cross member. Nothing there that would melt if I did some welding on it in place is there??? Need a couple of brackets on the front.