Quote:
Originally Posted by jsimon7777
I haven't looked exactly at it, but i think it's just one wire. So get 3" of similarly gauged wired. Trim off insulation on both ends. Cut the current wire. Trim off insulation on both ends. Solder on both ends to extend. Wrap in a bit of electrical tape or shrink tubing. Plug back in.
If it's two wires, repeat all that but with two wires instead of one.
If you don't know how to solder, google it. It's not hard, and I suck at it.
|
or crimp. you can make a jumper to match the ends of the receiver and input