Like I had mentioned, the hard part was done. Ran the power to the factory amp (+12V Accessory)
and grounded it on one of the amp bolts. Ran the video wire up the drivers side of the car
(nice and neat) and under the dash to the back of the stereo. The Rydeen came with plenty of
cable to reach. Plugged the pins on the RCA from SVXdc in to the 16 pin harness as per SVXdc's
instructions and connected the camera.
Used the lines to back in to a spot, car was dead center in the spot. No need to adjust the lines
(close enough) since I put the camera where the head unit was expecting it.
First green line, about 7' from the curb
Yellow line, about 4' from the curb
Red line, about 3' from the curb
All in all this was not a difficult installation. Just be careful not to scratch anything when removing
/re-installing the trunk fascia and be careful when you have the stereo haning out of the dash
that it doesn't scratch the clock area and you should be good.