Swung by FT86MS and picked up whiteline trans bushing insert and Mtec shift springs.
Installed them after work. Both were much easier to install than I anticipated. Probably took me 2 hours from jacking the car up to bringing it down. 20-30 was fighting with a jack that didn't like being used with the lever arm at 70° while I was attempting to lift the transmission to slide the bushing in.
The 27mm bolt on the transmission was more difficult than it needed to be as I borrowed a shallow 27mm and needed to use a swivel which made it an awkward angle.
I used a drill wire brush to clean the loctite off the threads and the bolts went back in without issues.