Quote:
Originally Posted by jkr
I was told when the brake light switch is removed, the lights should turn on. Is that incorrect?
As of right now the lights don't do anything whether or not there is contact or not. Sorry if I was a little unclear.
|
Switch shows normally open on the lamp side, normally closed to the ECU. Unplugged lights will be off, ECU will show off as well. Switch should test O.L on pins 1-2, 0.0 on pins 3-4. Unplugging the switch will set a fault since the switches can never both be open.
Fuse is at the top left, 7.5A.
Power goes through the noise filter, out to the stop lamp switch and back in. Then out to the grey distribution on the bottom left, to the modules and physical lamps.
Triangle lines on the bottom row are grounds. Lines that cross with no dots are not connected, lines that intersect with a dot are connected.
I would start with that fuse, labeled STOP.