Made some progress on the AN lines today.
Earls 20AN thermostat housing Fragola low profile fittings and Russell’s pro classic II hose
Pulled the outlet off the waterpump and pressed in a CBM Motorsports 20AN outlet with red loctite
Going 10 AN compression fittings on the heater core.
They stick out a bit more than I wanted so I’ll back cut the fittings to get them closer to the firewall
Also working on four point steam pipe lines using Earls steam pipe fittings and 4AN lines
Deciding on if I want to run the lines over or under the wire harness
Fuel lines are 8AN for feed and 6AN for return
I’m running the lines up through the frame rail to keep them away from exhaust heat
Open up a hole under the car to feed the lines up into the frame rail
Lines come out under the brake booster
Radium Fuel filter is under the car.
I recessed a hump under the driver seat to make an area for the fuel filter to sit up and out of the way...per @
DustinS advice I’ll make some sort of cover/skid plate for it as well. The factory covers will go back on as well.