Quote:
Originally Posted by DustinS
I was just looking at those again and noticed that. Even better.
Edit: I really like the uncoated set. Interesting to note the 1 3/4 is the ID of the ports, whereas most headers are measured on the OD of the piping:
and for a super cheap solution that is 1 3/4 w/ 3" collector: $240
Found the 13/16 Master Should work just fine.
|
Hey, I found that the Hooker header does have 3" collectors
http://www.jegs.com/i/Hooker-Headers...301-R/10002/-1
I am inclined to go with these ones now, I revisited my cheap ebay ones and they were smaller than advertised. I really don't care much about the 3" collectors, I'm going with dual 2.5" all the way back anyway, but really interested in 1-7/8" on a shorty header.