Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post - F1point4's Asphalt FR-S 6MT

F1point4 · 06-15-2012, 06:58 PM

Took Lola to get the 3M Clear Bra installed today.

For those in Houston Area, Steve Perez and Matt @ http://invisishield.com/ does fantastic work. Everything is reasonably priced and ended up being much cheaper than the Scion package.

I got:
+ Front Bumper ( FR-S 2 piece template)
+ 1/3 of Hood and Fenders ( FR-S 3 piece template)
+ Door Cups ( Corolla template )
+ Mirrors ( FR-S 2 piece template )
+ Rear Fender Flare ( hand cut ) - The rear fenders flare out a little so they are susceptible to rock/bug damage

I can take closeup pictures of the work upon request.

First time on a lift!

3M Before by VictorN07, on Flickr

This is the coverage on the front. The front corner where the headlight goes into the bumper is not covered. ( I didn't get a finished picture)

3M Front Visible by VictorN07, on Flickr

Here is the finished rear fender. There wasn't a template so it was hand cut. The top of the film lines up with the top of the tire when its on a lift. Its damn hard to see. Closeups on my Flickr set

3M Full Rear Fender by VictorN07, on Flickr

Rear Fender Coverage

3M Rear Fender Visible by VictorN07, on Flickr

First Grocery Run. Very practical

FirstMarket by VictorN07, on Flickr

06-15-2012, 06:58 PM	#11
F1point4 Photo Specialist Join Date: Feb 2012 Drives: 2013 Toyota 86 DGM 6MT Location: Texas Posts: 1,152 Thanks: 587 Thanked 1,805 Times in 420 Posts Mentioned: 94 Post(s) Tagged: 0 Thread(s)	Took Lola to get the 3M Clear Bra installed today. For those in Houston Area, Steve Perez and Matt @ http://invisishield.com/ does fantastic work. Everything is reasonably priced and ended up being much cheaper than the Scion package. I got: + Front Bumper ( FR-S 2 piece template) + 1/3 of Hood and Fenders ( FR-S 3 piece template) + Door Cups ( Corolla template ) + Mirrors ( FR-S 2 piece template ) + Rear Fender Flare ( hand cut ) - The rear fenders flare out a little so they are susceptible to rock/bug damage I can take closeup pictures of the work upon request. First time on a lift! 3M Before by VictorN07, on Flickr This is the coverage on the front. The front corner where the headlight goes into the bumper is not covered. ( I didn't get a finished picture) 3M Front Visible by VictorN07, on Flickr Here is the finished rear fender. There wasn't a template so it was hand cut. The top of the film lines up with the top of the tire when its on a lift. Its damn hard to see. Closeups on my Flickr set 3M Full Rear Fender by VictorN07, on Flickr Rear Fender Coverage 3M Rear Fender Visible by VictorN07, on Flickr First Grocery Run. Very practical FirstMarket by VictorN07, on Flickr Last edited by F1point4; 06-15-2012 at 07:40 PM.