For whatever reason it looks like I can no longer access the original
FBM Walbro 485 fuel pump kit thread on this forum.
Anyway I purchased the kit a long time ago and I am finally getting ready to install it now. I have reviewed the
repair manual and DIY for the
Deastchwerks 265c but I still had some lingering questions. This is partly due to the additional metal ring and also because I have a trunk full of parts to sift through.
So the parts I have gathered for this install are as follows.
0. The pump, this only made the list because I know there is some smart ass out there like myself that would say it.
1. Metal ring with a rubber o-ring embedded (this is the main source of my confusion)
2. The metal retainer(not sure what else to call it) on the bottom of the pump where the filter goes
3. A bag of fasteners and brackets believed to be used for fastening the retainer to the pump
[picture of provided fasteners]
I'll add a picture momentarily so someone can yell at me if I grabbed the wrong bag of fasteners.
If the aforementioned bag of fasteners are correct I assume the install will not differ much from the DIY mentioned above. I am not sure about the ring though. Does this get sandwiched between the basket and the outer ring?
Given the size variance between the stock pump and the Walbro I can only surmise that this is a spacer of sorts. But I would like some guidance on how to properly set the ring; o-ring towards bucket, o-ring facing outer ring.
Any help/suggestions/tips would be greatly appreciated.
Thanks,
Ryan