Quote:
Originally Posted by SillySaxon
Wondering if I can get some help here.
I have wired in my WinJet set with the supplied switch and harness but I would like to use the switch harness that is already in the car (the grey one with white tape on it behind the trunk button).
This will fit in my switch.
The question I have is about wiring.
Currently the fogs are wired as so:
Red wire from Fog --TO --> Battery + terminal.
then on the other side Ground to Chassis
Red Wire from Fog --TO --> Yellow wire on Harness INSIDE Vehicle
On the inside, from the switch harness I have:
Yellow Wire from switch --TO --> Red wire to fogs through FW
Black Wire from switch --TO--> Ground
Brown Wire from switch --TO--> Purple ACC wire on other harness
Now, this all functions, but I'd rather keep it clean and use the already wired switch harness so I can also see the light on the dash.
I am assuming I'd need to rewire either one of both of the red wires from my fogs.
Where should I put them so that they have power when the lights are on and the switch is activated?
Thanks!
|
Throw the included winjet harness and switch away and buy this switch
http://www.ebay.com/itm/FOG-LIGHT-LA...3e77be&vxp=mtr
and u need to connect your fogs to factory wiring this way you will get the green fog indicator on the dash