|
Clutch Helper Spring Removal
Just tackled this myself, found it helps to remove the pin and clip on the other end of the clutch actuator where you would screw/unscrew the rod to adjust the pedal height.
The clutch will then hold in two positions, either all the way to the floor, or up touching the cruise control sensor. With the pedal to the floor, remove the pin and clip attached to the pedal.
Once removed, push up on the spring assembly with a screwdriver where it connects to the pedal and the whole thing should pop-off. Took some force at this point, the connection point is extremely tight with the spring on. Put everything back in reverse order, test and enjoy!
.ck
__________________
|| My Build Thread ||
 
|