follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
ACE Headers
Register Garage Members List Calendar Search Today's Posts Mark Forums Read

Go Back   Scion FR-S Forum | Subaru BRZ Forum | Toyota 86 GT 86 Forum | AS1 Forum - FT86CLUB > Search Forums


Showing results 1 to 30 of 44
Search took 0.00 seconds.
Search: Posts Made By: keen as
Forum: Forced Induction 08-31-2017, 01:19 AM
Replies: 10,691
Views: 2,236,287
Posted By keen as
this is a copy of my PM reply. My problem...

this is a copy of my PM reply.


My problem sounds different.
After I calibrated the throttle in the Procede Software, I didn't get full boost at full throttle. After a lot of time consuming...
Forum: Forced Induction 06-26-2016, 03:28 AM
Replies: 215
Views: 44,915
Posted By keen as
That all makes sense. KoolBRZ I don't expect...

That all makes sense. KoolBRZ

I don't expect any difference between 5.21v and 4.95V. After I get my dump pack back in, I'll log boost to see if there is any change when I switch from procede to...
Forum: Forced Induction 06-25-2016, 11:51 PM
Replies: 215
Views: 44,915
Posted By keen as
NO, that post describes an an UNcalibrated...

NO, that post describes an an UNcalibrated throttle. In the zero rpm row, I populated the 80 and 85 column cells with "100". That was the only change in the map and I attached the picture showing...
Forum: Forced Induction 06-25-2016, 03:59 AM
Replies: 215
Views: 44,915
Posted By keen as
KoolBRZ I had spare time to do some...

KoolBRZ
I had spare time to do some measurements.
I think they may be unreliable. Currently, my Dump pack is out of the car and the batteries are getting tested. While I am able to test the signal...
Forum: Forced Induction 06-22-2016, 12:16 AM
Replies: 215
Views: 44,915
Posted By keen as
I tested both original (non throttle calibrated)...

I tested both original (non throttle calibrated) map and then calibrated map. The problem (described previously of less boost) only occurs after throttle calibration.
Forum: Forced Induction 05-17-2016, 05:43 PM
Replies: 75
Views: 28,601
Posted By keen as
On a different, previous car I had, I covered the...

On a different, previous car I had, I covered the exposed air filter as a precaution. I didn't want to test for water reaching the air intake.


Otherwise, these vents look great and seem...
Forum: Forced Induction 05-16-2016, 02:07 AM
Replies: 75
Views: 28,601
Posted By keen as
May I suggest, I think it is best to somehow...

May I suggest, I think it is best to somehow cover your air filter to prevent water getting onto it.
Forum: Forced Induction 04-08-2016, 04:20 AM
Replies: 255
Views: 78,125
Posted By keen as
Big Thanks for data. Is the inlet...

Big Thanks for data.


Is the inlet manifold temps post intercooler?


Did the "inlet manifold" temps maintain stability until the end of the 13 lap stint? Were all 13 laps at full pace?
Forum: Forced Induction 04-05-2016, 08:53 PM
Replies: 255
Views: 78,125
Posted By keen as
It would be great if you have any racetrack data...

It would be great if you have any racetrack data to share. Specifically, when heat soaked, what are your air intake temps? Did it effect engine management, eg timing and presumably power? Do the...
Forum: Forced Induction 01-15-2016, 12:37 AM
Replies: 10,691
Views: 2,236,287
Posted By keen as
From website installation guide ...

From website installation guide
http://www.phantomsuperchargers.com/uploads/1/2/4/9/12496102/frs-brz4a.pdf
Forum: Forced Induction 01-06-2016, 05:39 PM
Replies: 1,173
Views: 228,039
Posted By keen as
Do what Gums said. The dump pack is separate and...

Do what Gums said. The dump pack is separate and does not get used or charged until the controller is on, when the car is on.


When my car is parked in my garage, I directly connect the starter...
Forum: Forced Induction 12-29-2015, 09:32 PM
Replies: 10,691
Views: 2,236,287
Posted By keen as
If using Procede, you can delete the Drag...

If using Procede, you can delete the Drag reduction tube connected from the controller to air intake pipe. The hole can be plugged. I can't remember the size of the fitting to screw in to plug it.
Forum: Forced Induction 10-17-2015, 07:44 AM
Replies: 1,173
Views: 228,039
Posted By keen as
Yes, I also found out that you can't copy a US...

Yes, I also found out that you can't copy a US ROM to Australian. There are probably undefined tables in the Australian ROM.

I am VERY DISAPPOINTED that Shiv and Openflash tablet are not...
Forum: Software Tuning 10-09-2015, 08:03 AM
Replies: 2
Views: 729
Posted By keen as
that fixed it, Thanks.

that fixed it, Thanks.
Forum: Forced Induction 09-22-2015, 06:00 AM
Replies: 1,173
Views: 228,039
Posted By keen as
Update ------ Rob suggested all the possible...

Update ------ Rob suggested all the possible reasons for my problem.

The problem was a connector at the electric motor.

The long story was I rechecked all connections, I reconditioned the...
Forum: Forced Induction 09-16-2015, 06:12 PM
Replies: 1,173
Views: 228,039
Posted By keen as
Also the controller with upgraded cooling has a...

Also the controller with upgraded cooling has a foam type air filter between the cooling fan and controller case. I thought this may inhibit cooling airflow. Is it now standard?
Forum: Engine, Exhaust, Transmission 09-16-2015, 01:39 AM
Replies: 184
Views: 61,753
Posted By keen as
My car is NA. These pics are the inside of the...

My car is NA.
These pics are the inside of the stock intake tube.
I'm getting a catch can for the crankcase vent.
Forum: Forced Induction 08-04-2015, 05:58 PM
Replies: 10,691
Views: 2,236,287
Posted By keen as
I bought a second hand unit. After one week, the...

I bought a second hand unit. After one week, the controller stopped working (no beeping after switching on/booting up). Rob is helping me resolve the issue.
Forum: Forced Induction 07-22-2015, 11:17 PM
Replies: 1,173
Views: 228,039
Posted By keen as
I installed a second hand USA kit from Gary in...

I installed a second hand USA kit from Gary in NJ, and made longer cables to fit RHD in Australia. Thanks Gums for giving me the dump cable and to dtek for converting the USA tune for my A01G ROM.
...
Forum: Forced Induction 05-08-2015, 04:07 AM
Replies: 255
Views: 78,125
Posted By keen as
https://www.facebook.com/harropperformance/photos/...

https://www.facebook.com/harropperformance/photos/a.161231640630974.42257.112028962217909/857663297654468/?type=1
Forum: Forced Induction 03-26-2015, 09:25 PM
Replies: 936
Views: 300,703
Posted By keen as
Twincharged with Sprintex supercharger ...

Twincharged with Sprintex supercharger
http://www.ft86club.com/forums/showthread.php?t=74059&highlight=twincharged

...
Forum: Software Tuning 03-11-2015, 06:45 PM
Replies: 95
Views: 24,117
Posted By keen as
Many thanks for a great update. And may I ask...

Many thanks for a great update.
And may I ask again for option of temperature in Degrees Celcius?
Forum: Forced Induction 12-05-2014, 12:54 AM
Replies: 936
Views: 300,703
Posted By keen as
from harrop facebook "2015 TVS Supercharger kit...

from harrop facebook
"2015 TVS Supercharger kit release sneak peak.."...
Forum: Engine, Exhaust, Transmission 09-03-2014, 08:54 PM
Replies: 92
Views: 29,811
Posted By keen as
see pic I borrowed in the preceeding post.

see pic I borrowed in the preceeding post.
Forum: Engine, Exhaust, Transmission 09-03-2014, 08:53 PM
Replies: 92
Views: 29,811
Posted By keen as
I borrowed a pic from the NSW club

I borrowed a pic from the NSW club
Forum: Engine, Exhaust, Transmission 08-31-2014, 02:16 AM
Replies: 92
Views: 29,811
Posted By keen as
i went to their facebook store. second from the...

i went to their facebook store. second from the top, listed at $450.
https://apps.facebook.com/aradium/?store=575575192519458
Forum: Forced Induction 08-18-2014, 02:21 AM
Replies: 10,691
Views: 2,236,287
Posted By keen as
I understand you want to assess the fitment of a...

I understand you want to assess the fitment of a Nth American version for Aussie.


For the Aussie version, I discussed wire runs with Rob in January. I also provided measurements and pictures of...
Forum: Engine, Exhaust, Transmission 08-11-2014, 10:00 PM
Replies: 67
Views: 31,489
Posted By keen as
Thanks for showing development. What worked...

Thanks for showing development.
What worked better, the air/fluid entering the can on the bronze filter side or entering the side with the small silver diverter?
Thanks
Forum: Forced Induction 08-06-2014, 10:21 PM
Replies: 10,691
Views: 2,236,287
Posted By keen as
Relevant article. About future Bugatti ...

Relevant article. About future Bugatti
http://www.drive.com.au/motor-news/new-bugatti-supercar-takes-shape-20140807-1019iy.html


"Further changes are also said to be in store for the induction...
Forum: Tracking / Autocross / HPDE / Drifting 07-07-2014, 10:02 PM
Replies: 12
Views: 2,616
Posted By keen as
So many different opinions 225 tyres. ...

So many different opinions


225 tyres. The camber bolts much better improvement for front grip, feel and less wear on the outside shoulder of tyre for me in an autoX setting. Suited my budget....
Showing results 1 to 30 of 44

 
Forum Jump

All times are GMT -4. The time now is 10:02 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Garage vBulletin Plugins by Drive Thru Online, Inc.