follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Members List Calendar Search Today's Posts Mark Forums Read

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 6 1 2345 Last »
Showing results 1 to 30 of 168
Search took 0.01 seconds. Search: Posts Made By: 504
Forum: Software Tuning 11-16-2020, 01:53 AM
Replies: 8
Views: 1,266
Posted By 504
Update to close thread. Problem solved,...

Update to close thread.

Problem solved, appears to be dirty maf and/or map sensor. Car running fantastic now particularly at very light loads
Forum: Software Tuning 11-13-2020, 08:47 PM
Replies: 8
Views: 1,266
Posted By 504
Maybe 10,000km ago or so, car is only on 55k km,...

Maybe 10,000km ago or so, car is only on 55k km, I would say it stays fairly clean due to the location and the small mods I did around the filter, good idea on that though

Just an update, I have...
Forum: Software Tuning 11-13-2020, 03:53 AM
Replies: 8
Views: 1,266
Posted By 504
It's a cone K&n filter sitting inside bumper....

It's a cone K&n filter sitting inside bumper. I've custom made an enclosure for it, doubt it's the filter to be honest, it's a high flow arrangement
Forum: Software Tuning 11-12-2020, 02:51 AM
Replies: 8
Views: 1,266
Posted By 504
Apparent rich misfire - help

Hi all,

Appreciate any guidance in advance

I've recently developed a highly rich condition with stft sitting at -29.9 at idle with12afr (commanded at 15), I'm beginning to suspect that a...
Forum: Software Tuning 01-12-2020, 05:45 PM
Replies: 23
Views: 5,403
Posted By 504
fellas its your base idle in gear timing, set too...

fellas its your base idle in gear timing, set too high. return to stock timing for these tables to resolve
Forum: Software Tuning 11-02-2019, 03:53 AM
Replies: 4
Views: 1,094
Posted By 504
I've got no way to measure ms unfortunately, this...

I've got no way to measure ms unfortunately, this is really good information though

Would I be safe running 50% on high load? and what do you estimate ms to be?

thanks guys
Forum: Software Tuning 11-01-2019, 05:59 PM
Replies: 4
Views: 1,094
Posted By 504
Boosted injector ratio

Hi folks,

coming up on my final ecutek tune revision hopefully. My tuner has the injector ratio raised on high loads upto 70% port as seen in the attachment. Question is, is this necessary for...
Forum: Software Tuning 10-08-2019, 01:26 AM
Replies: 18
Views: 5,767
Posted By 504
not expecting previous thread posters here to...

not expecting previous thread posters here to respond but perhaps another that will read this,

On E85 my car idles naturally at 20 degrees ignition

on 98 it sits around 16 but dips to 13...
Forum: Software Tuning 08-05-2019, 03:09 AM
Replies: 139
Views: 61,216
Posted By 504
Yeah I have fully unplugged the connector and...

Yeah I have fully unplugged the connector and tried to insert

The connector is the same as the one pictured by ztan
Forum: Software Tuning 08-04-2019, 06:16 PM
Replies: 139
Views: 61,216
Posted By 504
I made a serious attempt at getting this terminal...

I made a serious attempt at getting this terminal into the A35 plug with zero success. I have used the exact same connector pictured, but can't for the life of me get it to click in at all!!!
...
Forum: Software Tuning 07-06-2019, 11:19 PM
Replies: 39
Views: 11,606
Posted By 504
Thanks so much steve for the efforts, I...

Thanks so much steve for the efforts,

I have no issue also on e85, its only when I shoot under E8 or so on the flex sensor

6 corrections!? this is the first I hear on this. I have only found...
Forum: Software Tuning 07-05-2019, 06:31 AM
Replies: 39
Views: 11,606
Posted By 504
thoughts? I'm not clued into flex fuel tuning,...

thoughts? I'm not clued into flex fuel tuning, but assume that it utilises LTFT to account for fuelling differences?

pulled straight from the Proecu manual
Forum: Software Tuning 07-04-2019, 08:37 PM
Replies: 39
Views: 11,606
Posted By 504
Its very interesting that this issue is resolved...

Its very interesting that this issue is resolved with subaru wrx's through the above tables, but potentially not with 32bit ECUs?

We do know that a low voltage reading to the rear o2 will tell...
Forum: Software Tuning 07-04-2019, 06:43 AM
Replies: 39
Views: 11,606
Posted By 504
I dont have tune access, but am very confident...

I dont have tune access, but am very confident fuel comp tables are dead zero (i.e. stoich) at everything below 0.6 load. perhaps an issue of setting 0.000 rather than -0.029? seems unlikely

I...
Forum: Software Tuning 07-04-2019, 05:13 AM
Replies: 39
Views: 11,606
Posted By 504
so is there really zero solution at all to this...

so is there really zero solution at all to this issue?

really dont want to be running 10% rich now that eflex is not available .....

in that instance, how about forcing a minimum voltage...
Forum: Software Tuning 07-03-2019, 07:47 AM
Replies: 39
Views: 11,606
Posted By 504
may have resolved this fellas but no way to test...

may have resolved this fellas but no way to test until I visit my tuner again, basically need to be certain before I do that

see attachment below, set BOTH these tables to ZERO to remove all...
Forum: Software Tuning 06-17-2019, 06:24 PM
Replies: 39
Views: 11,606
Posted By 504
Makes sense, only really started happening under...

Makes sense, only really started happening under E5 ethanol reading, I wonder if a min voltage could be applied to maintain a minimum E reading to avoid such issue?
Forum: Software Tuning 06-16-2019, 06:24 PM
Replies: 39
Views: 11,606
Posted By 504
Did you find a solution to this? I'm having...

Did you find a solution to this? I'm having similar issue as my fuel goes down to E3 (flex tune). 13.7 commanded on light cruise then when idles, it shoots back to 14.7, it's pretty annoying
...
Forum: Software Tuning 03-08-2019, 04:26 AM
Replies: 5
Views: 1,143
Posted By 504
thanks so much fellas for the comments ...

thanks so much fellas for the comments

tOMM.brz

"star modifying what you dont have in ecutek, with romraider
then save, and reapply all other things in ecutek"

yeah man I've been doing this...
Forum: Software Tuning 03-08-2019, 12:18 AM
Replies: 5
Views: 1,143
Posted By 504
Ecutek missing tables

Hi all,

I'm just compiling a series of tables for edit with my tuner through ecutek but can't seem to find any form of hotstart enrichment tables in proecu at all?

Basically car stalls after...
Forum: Software Tuning 03-01-2019, 05:48 PM
Replies: 18
Views: 4,890
Posted By 504
So reckon it's be safe zeroing all loads less...

So reckon it's be safe zeroing all loads less than or equal to 0.6?

I wonder how tip in enrichment works also when there is a more significant DI only load region and having large PI injectors...
Forum: Software Tuning 02-26-2019, 04:00 AM
Replies: 18
Views: 4,890
Posted By 504
up to and including 0.6 LOAD? how much can the DI...

up to and including 0.6 LOAD? how much can the DI take before hitting duty cycle?
Forum: Software Tuning 01-09-2019, 04:11 PM
Replies: 16
Views: 4,663
Posted By 504
I'm more concerned with overrun timing as output...

I'm more concerned with overrun timing as output rather than base timing
Forum: Software Tuning 01-05-2019, 05:58 PM
Replies: 16
Views: 4,663
Posted By 504
exactly right, thats my dilemma also, wondering...

exactly right, thats my dilemma also, wondering also if the custom map allows for timed off such as one second post overrun to allow for smooth re entry into throttle
Forum: Software Tuning 01-04-2019, 10:01 PM
Replies: 16
Views: 4,663
Posted By 504
thanks for that, so CL is approximately 1.1-1.4...

thanks for that, so CL is approximately 1.1-1.4 points leaner than OL from my interpretation of that. And all I'll need to do is base it off Primary open loop fuelling table for my one and build the...
Forum: Software Tuning 01-04-2019, 07:49 PM
Replies: 16
Views: 4,663
Posted By 504
Thanks for your input Steve, yeah I have 3...

Thanks for your input Steve,

yeah I have 3 maps, pop tune is separate

"Id make your closed loop fuel tables taper richer similar to your open loop tables once you get past cruising loads like...
Forum: Software Tuning 01-04-2019, 07:34 PM
Replies: 16
Views: 4,663
Posted By 504
yeah im kinda gassing and watching afrs on my...

yeah im kinda gassing and watching afrs on my screen live, I'll try plug in the cable and see if i can get anything digitally for this. This is the table im referring to, since its boosted, I assume...
Forum: Software Tuning 01-04-2019, 05:28 PM
Replies: 16
Views: 4,663
Posted By 504
ecutek Turbo tune refinement

alright fellas

I'm looking to refine down by flex turbo tune and would be great to get some advice on some tables. Its custom tuned by my tuner but I'm doing drivability refinements

- I have...
Forum: Engine, Exhaust, Transmission 01-04-2019, 06:09 AM
Replies: 92
Views: 23,575
Posted By 504
still going strong, full time e85 and 360whp...

still going strong, full time e85 and 360whp stock block :thumbsup:
Forum: Software Tuning 01-04-2019, 05:59 AM
Replies: 10
Views: 2,850
Posted By 504
for the sake of avoiding another thread, I...

for the sake of avoiding another thread,

I have an ecutek licence and fully tuned by my tuner. Recently acquired a ecutek cable but a licence dongle of another car, can I plug this into my car...
Showing results 1 to 30 of 168
Page 1 of 6 1 2345 Last »

 
Forum Jump

All times are GMT -4. The time now is 05:13 PM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.