follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Members List Calendar Search Today's Posts Mark Forums Read

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 30 of 500
Search took 0.05 seconds.
Search: Posts Made By: Chad86
Forum: Forced Induction 03-02-2018, 11:04 PM
Replies: 9,139
Views: 2,790,832
Posted By Chad86
Everything was running fine on the Moto East tune...

Everything was running fine on the Moto East tune for 1-2,000KM. The motor only had about 11,500KM on it when it blew. Bad tune, over revving, and overextended dyno runs by the local shop. I had...
Forum: Forced Induction 02-28-2018, 10:23 PM
Replies: 9,139
Views: 2,790,832
Posted By Chad86
Thumbs down I recently went to a local shop to have my car...

I recently went to a local shop to have my car tuned on the dyno with my 335 and unfortunately they tuned improperly and pushed the car too hard blowing the engine throwing a rod through the block.
...
Forum: Forced Induction 01-26-2018, 11:13 AM
Replies: 9,139
Views: 2,790,832
Posted By Chad86
Yes, I have the dongle, software & tune file...

Yes, I have the dongle, software & tune file from moto-mike.
If it is locked what are my options with the local shop's dyno & tuner?
Forum: Forced Induction 01-25-2018, 09:40 PM
Replies: 9,139
Views: 2,790,832
Posted By Chad86
I'm going on the dyno this weekend to get my tune...

I'm going on the dyno this weekend to get my tune dialed in. Is the tune file locked from Moto-East?
Forum: Engine, Exhaust, Transmission 01-07-2018, 11:49 PM
Replies: 11
Views: 2,583
Posted By Chad86
I currently have the following and it is a bit...

I currently have the following and it is a bit too loud especially at startup.
JDL uncatted UEL header
JDL 3" catted OP/DP with resonator
Perrin 2.5" resonated

I think the 3" OP/DP is causing a...
Forum: Engine, Exhaust, Transmission 01-07-2018, 11:20 PM
Replies: 33
Views: 12,716
Posted By Chad86
Question My exhaust is a bit over the top right now and I...

My exhaust is a bit over the top right now and I would like to soften the noise a bit especially the start up.

JDL uncatted UEL header
JDL 3" catted OP/DP with resonator
Perrin 2.5" resonated...
Forum: Forced Induction 12-10-2017, 02:48 PM
Replies: 9,139
Views: 2,790,832
Posted By Chad86
Should the supercharger coolant bottle be at the...

Should the supercharger coolant bottle be at the low or high line when cold?
Forum: DIY (Do-It-Yourself) Guides 05-07-2017, 01:35 AM
Replies: 73
Views: 49,319
Posted By Chad86
I think I will just eventually wire this to turn...

I think I will just eventually wire this to turn on with the front fog lights.

http://www.ft86club.com/forums/showthread.php?t=37507
Forum: Member's Car Journals 05-07-2017, 01:11 AM
Replies: 43
Views: 18,453
Posted By Chad86
How did you end up carpeting the MSA pillar? I...

How did you end up carpeting the MSA pillar? I would like to carpet in one piece to hide the imperfections in the finishing.

Did you have to cut the carpet to get around the gauges or simply...
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 05-03-2017, 11:24 PM
Replies: 18
Views: 8,528
Posted By Chad86
Getting the shelf installed was fairly straight...

Getting the shelf installed was fairly straight forward.
The light bar isn't exactly plug and play so it looks like a glue gun should do the trick.
Forum: DIY (Do-It-Yourself) Guides 05-03-2017, 12:01 AM
Replies: 34
Views: 18,545
Posted By Chad86
Bump. I'm not sure what brand does a quick...

Bump. I'm not sure what brand does a quick strobe like this, but I'd like to know. Seems like it would draw less attention but still let people know you are braking.

GT86 - 3rd Brake Light...
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 05-02-2017, 11:38 PM
Replies: 18
Views: 8,528
Posted By Chad86
Any advice on installation? I'm starting my...

Any advice on installation? I'm starting my install now.
I have figured out how to remove the OEM shelf from the forums. Do I need to remove the OEM LED bar from the plastic housing and attach...
Forum: Scion FR-S / Toyota 86 GT86 General Forum 04-23-2017, 05:36 PM
Replies: 79
Views: 28,435
Posted By Chad86
Please provide missing registry details listed on...

Please provide missing registry details listed on page 1

lonewolfworks
Rakshaa
mrg666
kurtf114
Hoahao
Kaotic Lazagna
Detroiter
Forum: Issues | Warranty | Recalls / TSB 04-23-2017, 04:46 PM
Replies: 48
Views: 18,831
Posted By Chad86
Arrow Thanks Enalband24 I'm struggling to determine...

Thanks Enalband24
I'm struggling to determine the cause of CEL P0456 and I've noticed on occasion when my car is warm it struggles to turn over. I am thinking my issue is similar to yours in that...
Forum: Issues | Warranty | Recalls / TSB 03-16-2017, 01:06 AM
Replies: 23
Views: 9,794
Posted By Chad86
Battery reset cleared the CEL, but after a few...

Battery reset cleared the CEL, but after a few drives it has now returned! I will contact my shop as the install is still under warranty.

:sigh:
Forum: Issues | Warranty | Recalls / TSB 03-11-2017, 10:46 PM
Replies: 23
Views: 9,794
Posted By Chad86
Is it worth unplugging the battery to see if the...

Is it worth unplugging the battery to see if the code stays away? as I had the fuel leak fixed not that long ago.

I also have the Perrin CAI, not sure if this would affect this.
Forum: Issues | Warranty | Recalls / TSB 03-11-2017, 10:36 PM
Replies: 23
Views: 9,794
Posted By Chad86
I just took a look in the dark with a flashlight...

I just took a look in the dark with a flashlight and don't see anything unplugged. I will inspect in daylight tomorrow and report back.
Forum: Issues | Warranty | Recalls / TSB 03-11-2017, 10:24 PM
Replies: 23
Views: 9,794
Posted By Chad86
Thanks. I had a shop do the install. Is this...

Thanks. I had a shop do the install. Is this easy to spot myself?
Forum: Issues | Warranty | Recalls / TSB 03-11-2017, 09:54 PM
Replies: 23
Views: 9,794
Posted By Chad86
ProECU reads DTC P0456 (slow leak) I have...

ProECU reads DTC P0456 (slow leak)
I have upgraded fuel pump and injectors. Could this have anything to do with catless header?
Forum: Issues | Warranty | Recalls / TSB 03-11-2017, 08:57 PM
Replies: 23
Views: 9,794
Posted By Chad86
From the ring at the top of the gas tank. This...

From the ring at the top of the gas tank. This has been fixed, but I still have the CEL
Forum: Issues | Warranty | Recalls / TSB 03-11-2017, 08:13 PM
Replies: 23
Views: 9,794
Posted By Chad86
I have had the CEL come on ever since getting the...

I have had the CEL come on ever since getting the Sprintex supercharger installed. I found out it was a gas leak from the top seals as I have read about. When the gas leak was fixed I unplugged the...
Forum: FR-S & 86 Photos, Videos, Wallpapers, Gallery Forum 09-26-2016, 12:09 AM
Replies: 0
Views: 947
Posted By Chad86
86 vs 86

86 vs 86 - YouTube
Forum: FR-S & 86 Photos, Videos, Wallpapers, Gallery Forum 09-26-2016, 12:04 AM
Replies: 2
Views: 1,447
Posted By Chad86
Living the life: GT86

Living the life: GT86 - YouTube
Forum: Engine, Exhaust, Transmission 07-03-2016, 11:44 PM
Replies: 19
Views: 14,393
Posted By Chad86
Question I'm switching to a Perrin 2.5" resonated from a...

I'm switching to a Perrin 2.5" resonated from a full 3" setup as I have experienced the awfulness of drone and the intolerable loudness of 3"
With my current uncatted header and soon to install...
Forum: Australia Classifieds 06-12-2016, 06:07 PM
Replies: 41
Views: 14,635
Posted By Chad86
I will let you know my impressions when I have it...

I will let you know my impressions when I have it installed shortly.
Forum: Australia Classifieds 06-11-2016, 08:21 PM
Replies: 41
Views: 14,635
Posted By Chad86
Pulled the trigger on Perrin! :D Seems to be of...

Pulled the trigger on Perrin! :D
Seems to be of better value.
Forum: Engine, Exhaust, Transmission 06-10-2016, 01:18 AM
Replies: 15
Views: 7,808
Posted By Chad86
So I assume I can connect my 3" frontpipe to a...

So I assume I can connect my 3" frontpipe to a 2.5" midpipe for a 2.5" diameter exhaust. Will my garage have the flanges on hand for fitment?
Forum: Engine, Exhaust, Transmission 06-10-2016, 01:09 AM
Replies: 20
Views: 10,793
Posted By Chad86
Looks like I found a solution. I'm not sure this...

Looks like I found a solution. I'm not sure this is a forum member, but in their Perrin unboxing video (on right) at the end they state were running full 3" which was too loud so they switched to...
Forum: Engine, Exhaust, Transmission 06-08-2016, 11:08 PM
Replies: 30
Views: 33,150
Posted By Chad86
Yes, the JDL catback is resonated. I would...

Yes, the JDL catback is resonated. I would assume the 3" piping throughout including the catless header is producing a lot of noise. My only concern would be it being too loud with the 2.5"...
Forum: Engine, Exhaust, Transmission 06-08-2016, 11:00 PM
Replies: 36
Views: 19,732
Posted By Chad86
You probably have catted headers though, right?

You probably have catted headers though, right?
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -4. The time now is 12:39 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.