follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Xero Limit
Register Garage Members List Calendar Search Today's Posts Mark Forums Read

Go Back   Scion FR-S Forum | Subaru BRZ Forum | Toyota 86 GT 86 Forum | AS1 Forum - FT86CLUB > Search Forums


Showing results 1 to 30 of 500
Search took 0.08 seconds.
Search: Posts Made By: Fizz
Forum: Forced Induction 08-28-2019, 12:51 AM
Replies: 736
Views: 189,655
Posted By Fizz
Looking for feedback from anyone who have...

Looking for feedback from anyone who have upgraded to the RaceRom 10 (v25 onward) how did it feel compared to the older tune?
DeliciousTuning does your FnG tune work well with Australian cars and...
Forum: Forced Induction 07-22-2019, 04:41 AM
Replies: 2
Views: 505
Posted By Fizz
Upgraded fuel pump with stock injectors?

Hi guys, haven't been in here for awhile. It's time for me to replace my fuel filter, and I figured i might as well upgrade the pump whilst at it. However, is it possible to run a slightly bigger...
Forum: Engine, Exhaust, Transmission 08-18-2017, 04:49 AM
Replies: 1,365
Views: 380,678
Posted By Fizz
This might have been asked few times before, but...

This might have been asked few times before, but does the top end on CS400 noticeably compared lesser compared to the B250? If so, how much of a difference is there and at what rpm range (i.e....
Forum: Engine, Exhaust, Bolt-Ons 03-22-2017, 12:05 AM
Replies: 10
Views: 3,790
Posted By Fizz
Been a long time now....but is this still...

Been a long time now....but is this still available?
Forum: Software Tuning 01-08-2017, 09:43 PM
Replies: 6
Views: 1,598
Posted By Fizz
I had this exact problem recently with my ecutek...

I had this exact problem recently with my ecutek cable. What I did was to use one of those cheap OBD2 extension cables with (mine had an on/off switch) in between the car's OBD port and and ecutek...
Forum: Software Tuning 12-21-2016, 03:59 PM
Replies: 3
Views: 949
Posted By Fizz
I wasn't able to plug in the OFT to rule out...

I wasn't able to plug in the OFT to rule out ecutek cable issue as I've sold the OFT already. I've already successfully flashed 3 revisions and taken about 5 logs without issues on this cable without...
Forum: Software Tuning 12-21-2016, 11:57 AM
Replies: 3
Views: 949
Posted By Fizz
Replace faulty OBD2 port?

Apologies if this is in the wrong section....wasn't sure if I should post here or in the electronics section.

Need advice/help. I think I may possibly have a bad OBD2 port. I've been using the OFT...
Forum: Issues | Warranty | Recalls / TSB 12-13-2016, 06:42 AM
Replies: 11
Views: 1,931
Posted By Fizz
1) check if it has supercharger installed. 2)...

1) check if it has supercharger installed.
2) try double clutching, or maybe worn synchro, possibly abused by previous owner.
3) possibly previous owner had removed aftermarket coilovers, refitted...
Forum: Forced Induction 11-23-2016, 02:28 AM
Replies: 736
Views: 189,655
Posted By Fizz
Anyone here running the SBD turbo kit with this...

Anyone here running the SBD turbo kit with this tune? Would like to hear your experience with it in terms of how it drives etc.
Forum: Engine, Exhaust, Transmission 11-17-2016, 09:41 PM
Replies: 19
Views: 5,126
Posted By Fizz
I'm currently running turbo kit on pump 98. This...

I'm currently running turbo kit on pump 98. This may be a cost effective way of reducing some compression without going for a full bottom end rebuild. And with the heads out it would also be a good...
Forum: Engine, Exhaust, Transmission 11-17-2016, 04:15 AM
Replies: 19
Views: 5,126
Posted By Fizz
Any further update on this? What are the cons to...

Any further update on this? What are the cons to reducing CR with head gaskets?
Forum: Northern California 11-11-2016, 09:32 AM
Replies: 10
Views: 3,388
Posted By Fizz
Which Subaru dealer did you get yours from? Is...

Which Subaru dealer did you get yours from? Is that price for brand new?
Forum: Engine, Exhaust, Transmission 10-14-2016, 01:26 AM
Replies: 9
Views: 2,695
Posted By Fizz
Not sure about using nylon lock nuts on hot...

Not sure about using nylon lock nuts on hot exhaust though....they might melt? When I installed my turbo manifold I used these titanium lock nuts instead. Holding strong so far and no leaks.
...
Forum: AUSTRALIA 09-12-2016, 08:50 PM
Replies: 25
Views: 10,632
Posted By Fizz
All the interior trim pieces are interchangeable...

All the interior trim pieces are interchangeable with any 86 and BRZ model
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 09-10-2016, 12:09 PM
Replies: 118
Views: 40,643
Posted By Fizz
No change in ride height, as the springs...

No change in ride height, as the springs basically determine ride height.
Forum: User/Vendor/Sponsor Reviews, Feedback, Comments 08-31-2016, 07:16 AM
Replies: 6
Views: 1,816
Posted By Fizz
Received mine just the other day. Initially when...

Received mine just the other day. Initially when I placed my order I received an email status saying it is being made and to expect a small delay. Then I didn't receive any update or email for 4...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 08-31-2016, 03:24 AM
Replies: 11
Views: 2,103
Posted By Fizz
Ah you're right....just did some digging around....

Ah you're right....just did some digging around. Assuming the caliper/bracket mounting holes are the same (probably are seeing most Subaru's are the same), you'll need to get the rotors dual drilled...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 08-31-2016, 12:27 AM
Replies: 11
Views: 2,103
Posted By Fizz
I believe the GTS and BRZ models already run the...

I believe the GTS and BRZ models already run the exact same brakes on the WRX. GT spec models run slightly smaller brakes.
Forum: Software Tuning 08-25-2016, 09:53 PM
Replies: 719
Views: 258,951
Posted By Fizz
steve99 off topic question, but I'm thinking of...

steve99 off topic question, but I'm thinking of mixing some E85 into our (crappy) 98ron fuel to achieve approx E10....question is, how many litres of E85 would do you need to fill in order to achieve...
Forum: Forced Induction 08-23-2016, 01:24 AM
Replies: 24
Views: 11,873
Posted By Fizz
The SBD kit doesn't come with instruction manual,...

The SBD kit doesn't come with instruction manual, but you can download the Greddy turbo kit instructions here (http://www.greddy.com/upload/file/13-FRS_TK_T518Z.pdf)

There are some minor stuff...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 07-22-2016, 12:26 AM
Replies: 11
Views: 2,141
Posted By Fizz
Performs better for what type of driving?

Performs better for what type of driving?
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 07-12-2016, 08:52 PM
Replies: 319
Views: 112,843
Posted By Fizz
Answer 1: You'll need to get the correct DBA...

Answer 1: You'll need to get the correct DBA rotor to suit the handbrake mechanism. I forgot the part number but what you've mentioned seems familiar. Only thing you'll need to do is trim the stock...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 07-01-2016, 01:36 AM
Replies: 55
Views: 20,400
Posted By Fizz
Me....at least I used to before I took them off....

Me....at least I used to before I took them off. The 08+ rear brembo's are direct bolt on. No brackets required. The mounting holes are identical on the GT and GTS so it's irrelevant
...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 06-20-2016, 10:11 PM
Replies: 55
Views: 20,400
Posted By Fizz
Correct....the GTS calipers sit further away from...

Correct....the GTS calipers sit further away from the center of axle (front rotor size 276mm vs 294mm)

http://forums.nasioc.com/forums/showthread.php?t=1265631
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 06-20-2016, 05:05 AM
Replies: 55
Views: 20,400
Posted By Fizz
By the way you can't really just bolt on the wrx...

By the way you can't really just bolt on the wrx brakes and expect the brake bias to be similar....because they're not. Theoretically you'd get more front bias when used on the 86 due to differences...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 06-20-2016, 04:59 AM
Replies: 55
Views: 20,400
Posted By Fizz
Subaru has been using the same brembo front...

Subaru has been using the same brembo front calipers for about a decade and they're a direct bolt on to the 86 regardless of spec/versions. The front mounting holes on the hub carriers are identical....
Forum: Forced Induction 06-14-2016, 03:51 AM
Replies: 2
Views: 946
Posted By Fizz
Factory pan is steel. Are you referring to turbo...

Factory pan is steel. Are you referring to turbo oil return line? You can get aftermarket alum fittings to weld onto an alum pan, but I'm pretty sure the FBM cast pans already have an extra hole...
Forum: Engine, Exhaust, Transmission 05-29-2016, 05:08 AM
Replies: 9
Views: 2,996
Posted By Fizz
Does the panel sit lower thank the factory one?

Does the panel sit lower thank the factory one?
Forum: Engine, Exhaust, Transmission 05-27-2016, 03:23 AM
Replies: 11
Views: 1,478
Posted By Fizz
Thanks for the input guys. I'll be installing the...

Thanks for the input guys. I'll be installing the SBD kit, which has the intake pipe running above the turbine housing (the plan is to ceramic coat the manifold, dump, and turbo housing). I guess I...
Forum: Engine, Exhaust, Transmission 05-27-2016, 12:17 AM
Replies: 11
Views: 1,478
Posted By Fizz
Ceramic Coating - keeps heat in or out?

I'm getting my exhaust manifold ceramic coated, and was wondering if I should get my aluminum intake pipe coated as well? Would ceramic coating help insulate the intake pipe from external radiant...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -4. The time now is 05:55 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Garage vBulletin Plugins by Drive Thru Online, Inc.