follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 30 of 123
Search took 0.01 seconds.
Search: Posts Made By: demasrv
Forum: GR86 General Topics (2nd Gen 2022+ Toyota 86) 12-03-2023, 11:35 PM
Replies: 52
Views: 6,903
Posted By demasrv
Get the facelift. Car is mostly figured out by...

Get the facelift. Car is mostly figured out by now, even the facelift and the early models have issues. Engines aren't lasting.
Forum: BRZ First-Gen (2012+) -- General Topics 12-01-2023, 01:40 AM
Replies: 4
Views: 1,314
Posted By demasrv
Are your OCVs actuating? Or at least getting...

Are your OCVs actuating? Or at least getting signal? Might try replacing those.
Forum: Issues | Warranty | Recalls / TSB 11-06-2023, 12:30 AM
Replies: 11
Views: 1,234
Posted By demasrv
Good to know I'm not the only to run into this. I...

Good to know I'm not the only to run into this. I ended up just tightening them in a star-ish pattern. Tighten until it go hard to, then switch to another side until it was ready to torque down.
Forum: Issues | Warranty | Recalls / TSB 11-06-2023, 12:21 AM
Replies: 11
Views: 1,234
Posted By demasrv
First time I did timing on one of these I messed...

First time I did timing on one of these I messed it up and had one bank that was out 180. Double checked everything and fixed it before I put on the timing chain. Second time, it was just too easy.
...
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 11-06-2023, 12:06 AM
Replies: 41
Views: 3,308
Posted By demasrv
Will I be able to buy one of these in 20 years...

Will I be able to buy one of these in 20 years when my kids are in college to rebuild? Do you think I'll be able to get parts? I'll be selling my car in the next few months sadly to get something the...
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 11-06-2023, 12:05 AM
Replies: 41
Views: 3,308
Posted By demasrv
herr derr use the search function. Car is...

herr derr use the search function.


Car is getting older though and that has to be a big part of why. Feels like most of it has been figured out except spun rod bearings thing.
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 11-04-2023, 11:46 PM
Replies: 41
Views: 3,308
Posted By demasrv
What happened to this place?

It used to be pretty busy, but on several of the topic boards there is maybe 1 post a day. Is the car just "figured out" at this point?



I did see a gr86 forum on another site, but they don't...
Forum: Issues | Warranty | Recalls / TSB 11-04-2023, 11:43 PM
Replies: 11
Views: 1,234
Posted By demasrv
Well, I thought I had it supported. Just a jack...

Well, I thought I had it supported. Just a jack w/ a board keeping pressure on the headers/oil pan. I was able to get it close enough to use the bolts/nuts to pull it together today but loosening the...
Forum: Engine, Exhaust, Transmission 11-04-2023, 12:41 AM
Replies: 784
Views: 357,809
Posted By demasrv
Honestly, I don't know that the pump is the...

Honestly, I don't know that the pump is the problem. At higher RPMs it's moving a LOT of oil. From my experience, the heads receive enough oil. Problem seems to be that the bearings don't.
Forum: Engine, Exhaust, Transmission 11-03-2023, 01:43 AM
Replies: 7
Views: 871
Posted By demasrv
Man this is wild to me because it's so easy to...

Man this is wild to me because it's so easy to replace the clutch/pressure plate once you have the transmission dropped.
Forum: Engine, Exhaust, Transmission 11-03-2023, 01:11 AM
Replies: 20
Views: 2,972
Posted By demasrv
I had your opinion here until a buddy pushed me...

I had your opinion here until a buddy pushed me to just go for it. How long did you drive it after it was blown? I shut my car down within a minute, and the heads were super clean. There aren't THAT...
Forum: Issues | Warranty | Recalls / TSB 11-03-2023, 01:01 AM
Replies: 11
Views: 1,234
Posted By demasrv
Figured it out. Read some other posts...

Figured it out.



Read some other posts and I ended up dropping the transmission. The camshaft position plate/reluctor wheel wasn't aligned properly. The dowel pin for it was completely flat,...
Forum: Issues | Warranty | Recalls / TSB 10-29-2023, 09:36 PM
Replies: 34
Views: 8,973
Posted By demasrv
Mine blew up post-recall. I don't think it was...

Mine blew up post-recall. I don't think it was recall related since I also had an engine blow under warranty before the recall was done, but who knows?


Engine has now been out of my car 4 times.
Forum: Issues | Warranty | Recalls / TSB 10-29-2023, 09:30 PM
Replies: 43
Views: 8,666
Posted By demasrv
How does this happen? With the dowel I wouldn't...

How does this happen? With the dowel I wouldn't think it's possible...
Forum: Issues | Warranty | Recalls / TSB 10-29-2023, 09:24 PM
Replies: 4
Views: 1,069
Posted By demasrv
Man I buy almost everything from RockAuto and...

Man I buy almost everything from RockAuto and I've never had an issue. Did they handle it for you?
Forum: Issues | Warranty | Recalls / TSB 10-29-2023, 08:35 PM
Replies: 11
Views: 1,234
Posted By demasrv
I guess my timing could be out 180...but then the...

I guess my timing could be out 180...but then the arrows on the camshaft sprockets wouldn't have all been pointing at each other at the same time right? This really feels like a sensor or electrical...
Forum: Issues | Warranty | Recalls / TSB 10-29-2023, 08:00 PM
Replies: 11
Views: 1,234
Posted By demasrv
After new short block, car cranks but doesn't start

Hey all,


Just put in a new short block, finally got everything sealed up and connected and but the car won't start. I can hear the fuel pump priming, it turns over fine, once everything was...
Forum: Engine, Exhaust, Transmission 07-07-2022, 07:52 AM
Replies: 6
Views: 1,936
Posted By demasrv
These cars don't have head gasket problems. ...

These cars don't have head gasket problems.

Your coolant level was probably low. You said it yourself the radiator was leaking. Your car probably had a load of aftermarket stuff on it and was...
Forum: Issues | Warranty | Recalls / TSB 07-06-2022, 03:29 PM
Replies: 3
Views: 1,518
Posted By demasrv
Any high temp brake grease or a high temp lithium...

Any high temp brake grease or a high temp lithium grease should do the trick.

Sent from my Pixel 4 using Tapatalk
Forum: Engine, Exhaust, Transmission 05-31-2022, 12:31 PM
Replies: 2
Views: 517
Posted By demasrv
It doesn't matter. Sent from my Pixel 4...

It doesn't matter.

Sent from my Pixel 4 using Tapatalk
Forum: Engine, Exhaust, Transmission 05-25-2022, 02:17 PM
Replies: 14
Views: 1,980
Posted By demasrv
I have the blue tips! I'm going to go look at...

I have the blue tips! I'm going to go look at them when I get home and see.

Sent from my Pixel 4 using Tapatalk
Forum: Engine, Exhaust, Transmission 05-25-2022, 02:01 PM
Replies: 14
Views: 1,980
Posted By demasrv
Weird, I've had the q300 for 5ish years now and...

Weird, I've had the q300 for 5ish years now and I've never experienced the rattle.
Forum: Engine, Exhaust, Transmission 05-24-2022, 03:58 PM
Replies: 14
Views: 1,980
Posted By demasrv
Just fix the rivets! Sent from my Pixel 4...

Just fix the rivets!

Sent from my Pixel 4 using Tapatalk
Forum: Engine, Exhaust, Transmission 05-23-2022, 03:12 PM
Replies: 17
Views: 1,975
Posted By demasrv
Yeah that's a good point. They should really...

Yeah that's a good point. They should really check both.

I wouldn't rule out them messing up the timing either the first time around.

Sent from my Pixel 4 using Tapatalk
Forum: Engine, Exhaust, Transmission 05-23-2022, 03:02 PM
Replies: 17
Views: 1,975
Posted By demasrv
You can remove bolts from the back for the timing...

You can remove bolts from the back for the timing cover to see the oil pump and inspect the passages. Never heard of someone replacing the oil pump after a blown motor with these though.



Sent...
Forum: Engine, Exhaust, Transmission 05-23-2022, 09:44 AM
Replies: 17
Views: 1,975
Posted By demasrv
Having set the timing when I replaced my short...

Having set the timing when I replaced my short block, I'm not sure how you could verify it by just yanking the OCVs off. Especially since once you set the first bank (driver's side) and you're...
Forum: Engine, Exhaust, Transmission 05-22-2022, 09:31 PM
Replies: 17
Views: 1,975
Posted By demasrv
It sounds to me like they just messed up the...

It sounds to me like they just messed up the timing. Setting the timing on these can be a bit tricky. I'd be surprised if the oil pump is the culprit.

In my experience the OCVs throw codes if you...
Forum: Issues | Warranty | Recalls / TSB 05-12-2022, 02:55 PM
Replies: 60
Views: 6,417
Posted By demasrv
Oh it definitely doesn't have anything to do with...

Oh it definitely doesn't have anything to do with it. I thought I was replying to someone about a rough idle/vacuum leak.
Forum: Issues | Warranty | Recalls / TSB 05-06-2022, 09:37 AM
Replies: 58
Views: 24,199
Posted By demasrv
Depending on how many times the engine has been...

Depending on how many times the engine has been disassembled or a human has done the sealant, you might consider dropping the oil pan to and cleaning it out. Specifically looking at the oil pickup...
Forum: Issues | Warranty | Recalls / TSB 04-25-2022, 11:43 AM
Replies: 58
Views: 24,199
Posted By demasrv
I used some of the Permatex Right Stuff Black on...

I used some of the Permatex Right Stuff Black on some of the head assemblies in my engine and it's holding up just fine with no leaks. I was using the Grey but ran out of it so used what I had. I...
Showing results 1 to 30 of 123

 
Forum Jump

All times are GMT -4. The time now is 05:38 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.