follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 6 1 2345 Last »
Showing results 1 to 30 of 168
Search took 0.02 seconds. Search: Posts Made By: RevoG
Forum: Engine, Exhaust, Transmission 11-12-2021, 06:47 AM
Replies: 2
Views: 928
Posted By RevoG
Engine Harness swap

Good day,

I would like to know if I can swap the engine harness from a 17-19 into a 2013 GT86. I seem to have a cam issue, but it only throws the codes when at idle. Once driving and the code...
Forum: Forced Induction 01-11-2020, 04:48 AM
Replies: 62
Views: 23,398
Posted By RevoG
Yes, larger intercooler was installed. IAT is...

Yes, larger intercooler was installed. IAT is around 2-4C higher than ambient for normal driving. Also installed a water /meth kit to run on track to keep the temps down.

Did a boost leak down...
Forum: Forced Induction 01-10-2020, 02:11 AM
Replies: 62
Views: 23,398
Posted By RevoG
Currently around 320 WHP on a mainline dyno

Currently around 320 WHP on a mainline dyno
Forum: Forced Induction 01-10-2020, 02:10 AM
Replies: 62
Views: 23,398
Posted By RevoG
Boost is linear, no boost leaks

Boost is linear, no boost leaks
Forum: Forced Induction 01-09-2020, 03:22 AM
Replies: 62
Views: 23,398
Posted By RevoG
Good morning to all. Just found this thread and...

Good morning to all. Just found this thread and it seems to be what I am looking for. I have a question and hope someone on here can help my out. I'm running a JRSC kit with a C38 SC and a RS pulley....
Forum: Engine, Exhaust, Transmission 09-20-2018, 02:18 AM
Replies: 20
Views: 6,425
Posted By RevoG
Currently running JDL UEL catless header, JDL 3...

Currently running JDL UEL catless header, JDL 3 inch overpipe/front pipe combo with dual resonators and Perrin 3 inch resonated cat back exhaust. This set up is louder than my straight piped Invidia...
Forum: Forced Induction 12-13-2017, 03:51 AM
Replies: 8
Views: 4,165
Posted By RevoG
Mine sounds exactly like that. Thought it might...

Mine sounds exactly like that. Thought it might be fluid but the levels are perfect.

Suppose I need to send a clip to JR.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 10-09-2017, 06:29 AM
Replies: 144
Views: 62,880
Posted By RevoG
No, the column is not loose. Have checked that...

No, the column is not loose. Have checked that already. Too much lay in the internal gears is probably the problem but do I replace the EPS or the upper steering shaft.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 10-09-2017, 06:27 AM
Replies: 144
Views: 62,880
Posted By RevoG
Anyone have any update on this? Seeing as my car...

Anyone have any update on this? Seeing as my car is a Middle Eastern version I have several friends that all have the same problem. At the moment we have 5 cars with the same rattle, and some cars...
Forum: Forced Induction 05-31-2017, 04:29 AM
Replies: 6,004
Views: 2,049,824
Posted By RevoG
Yup, Had exactly the same thing. Replaced mine...

Yup, Had exactly the same thing. Replaced mine with a cheap Aluminium unit (XSPower) off ebay as a stop gap while I ordered a new one. Still on the car today after numerous track days and daily...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 03-21-2017, 09:06 AM
Replies: 144
Views: 62,880
Posted By RevoG
Electric Power Steering (EPS) noisy

Good day to all,

I have tried to research this but cannot find anyone with the same problem. So was hoping someone on here has had it or can help me out. When driving over uneven terrain, like...
Forum: Forced Induction 10-31-2016, 03:14 AM
Replies: 6,004
Views: 2,049,824
Posted By RevoG
Mail sent last Friday. Please advise if you have...

Mail sent last Friday. Please advise if you have received it.
Forum: Forced Induction 10-27-2016, 05:05 AM
Replies: 6,004
Views: 2,049,824
Posted By RevoG
I will definitely contact you guys directly. I...

I will definitely contact you guys directly. I will be picking up the car tonight from the workshop and will then be able to send you pics of the part.

I agree that the plate should not just bend...
Forum: Forced Induction 10-26-2016, 02:53 AM
Replies: 6,004
Views: 2,049,824
Posted By RevoG
No, just the JR High boost pulley. But it...

No, just the JR High boost pulley.

But it seems I have found the problem. The bracket holding the SC is bent. I have no idea how that is even possible. I am in the process of having one machined...
Forum: Forced Induction 10-24-2016, 06:58 AM
Replies: 6,004
Views: 2,049,824
Posted By RevoG
all 6 ribs are sitting fine but it looks like the...

all 6 ribs are sitting fine but it looks like the belt is being pushed in. Like the SC needs to be spaced out

Will try to get a pic and post it
Forum: Forced Induction 10-20-2016, 06:44 AM
Replies: 6,004
Views: 2,049,824
Posted By RevoG
Mike, how do I go about changing the alignment if...

Mike, how do I go about changing the alignment if it is out?
Forum: Forced Induction 10-10-2016, 04:24 AM
Replies: 6,004
Views: 2,049,824
Posted By RevoG
Got a quick question for everyone running the JR...

Got a quick question for everyone running the JR SC setup: Anyone ever had any problems with the pulleys supplied in the kit? I just replaced both pulleys as the bearings inside were shot. If you...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 04-21-2016, 12:51 AM
Replies: 129
Views: 119,816
Posted By RevoG
My contribution: Bridgestone RE 003 265/35/18,...

My contribution: Bridgestone RE 003 265/35/18, KW3 coilovers

http://i1246.photobucket.com/albums/gg610/Gustavm/PLA_1197%20Gustav.jpg
...
Forum: Electronics | Audio | NAV | Infotainment 10-05-2015, 01:00 AM
Replies: 16
Views: 3,626
Posted By RevoG
Yes, Revworks UEL catless.

Yes, Revworks UEL catless.
Forum: Electronics | Audio | NAV | Infotainment 09-30-2015, 05:50 AM
Replies: 16
Views: 3,626
Posted By RevoG
Yes I did, works perfect.

Yes I did, works perfect.
Forum: Electronics | Audio | NAV | Infotainment 09-30-2015, 02:24 AM
Replies: 16
Views: 3,626
Posted By RevoG
Got the AFR on a custom pod for the AC vent on...

Got the AFR on a custom pod for the AC vent on top of the dash and the Informeter just to the right of the instrument cluster. That was suppose to be a temp position but I quite like it there.

...
Forum: Electronics | Audio | NAV | Infotainment 09-29-2015, 09:24 AM
Replies: 16
Views: 3,626
Posted By RevoG
I'm running the same kit and went for a Greddy...

I'm running the same kit and went for a Greddy Informeter for oil, water and intake temps as well as oil pressure. Also added a stand alone Innovate AFR. So far very happy with both.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 09-29-2015, 09:17 AM
Replies: 2
Views: 2,327
Posted By RevoG
Thanks for this. I have been travelling so no...

Thanks for this. I have been travelling so no time to look at this.


I have contacted the supplier I have bought from and also RSR directly a week ago. My supplier only got back to me last night...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 09-21-2015, 02:13 AM
Replies: 2
Views: 2,327
Posted By RevoG
Help needed with KW V3 coil overs and RSR pillow ball top mounts

I need some help here since I am losing my mind. I am not a mechanic but have done everything on my car myself, with and without friend's assistance. But this one has me stumped.


I have bought...
Forum: Scion FR-S / Toyota 86 GT86 General Forum 07-15-2015, 04:17 PM
Replies: 43
Views: 17,860
Posted By RevoG
Dealer will not help you. I have asked and they...

Dealer will not help you. I have asked and they did nit know what I was talking about.

I do all the work on my car myself. I do not trust any garage and have not come across one that I would...
Forum: Scion FR-S / Toyota 86 GT86 General Forum 07-09-2015, 06:31 PM
Replies: 43
Views: 17,860
Posted By RevoG
Nope, speaker is mounted on the pc board for the...

Nope, speaker is mounted on the pc board for the instrument cluster.
Forum: Scion FR-S / Toyota 86 GT86 General Forum 07-09-2015, 02:31 PM
Replies: 43
Views: 17,860
Posted By RevoG
I have removed my chime by taking the instrument...

I have removed my chime by taking the instrument cluster apart and putting about 4 layers of ductape over it. It is barely audible now.
Forum: ASIA 07-08-2015, 12:16 PM
Replies: 25
Views: 22,141
Posted By RevoG
Yes, just take the instrument cluster out, take...

Yes, just take the instrument cluster out, take it apart and tape up or disable the speaker.
Forum: Engine, Exhaust, Transmission 06-20-2015, 11:30 PM
Replies: 5
Views: 1,685
Posted By RevoG
Had them, loved them. They are stupid expensive...

Had them, loved them. They are stupid expensive for what they are but does what it says on the box. Since I went FI they have been removed and fitted to a friends car. He also could not believe the...
Forum: Scion FR-S / Toyota 86 GT86 General Forum 06-14-2015, 03:25 PM
Replies: 24,604
Views: 7,225,239
Posted By RevoG
Removed and replaced the rear hubs on my 86....

Removed and replaced the rear hubs on my 86. Stupid gorilla with a impact wrench at the tire shop stripped 3 of the rear studs in the hub. No, they do not have to be torqued to 180 ft/lbs!!!
Showing results 1 to 30 of 168
Page 1 of 6 1 2345 Last »

 
Forum Jump

All times are GMT -4. The time now is 11:58 PM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.