follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Members List Calendar Search Today's Posts Mark Forums Read

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 30 of 338
Search took 2.01 seconds.
Search: Posts Made By: Craig
Forum: Forced Induction 04-09-2015, 10:18 AM
Replies: 190
Views: 106,962
Posted By Craig
^^

^^
Forum: Software Tuning 07-20-2014, 12:04 PM
Replies: 13
Views: 9,270
Posted By Craig
Its surprising so see these AT dynos, so similar...

Its surprising so see these AT dynos, so similar to the MT. It's only about a 8hp difference from the dynos I've seen.
Forum: Engine, Exhaust, Bolt-Ons 07-17-2014, 10:26 AM
Replies: 9
Views: 2,747
Posted By Craig
Like the placement of the grimmspeed bar there....

Like the placement of the grimmspeed bar there. ^_~
385 for the OFT Lmk
Forum: Engine, Exhaust, Transmission 07-17-2014, 10:10 AM
Replies: 90
Views: 55,175
Posted By Craig
Well, I went to mishifest and picked one up, I'll...

Well, I went to mishifest and picked one up, I'll post up a review after I put it in!
Forum: Engine, Exhaust, Transmission 07-10-2014, 10:47 AM
Replies: 90
Views: 55,175
Posted By Craig
Any independant tests on this intake? I saw one...

Any independant tests on this intake? I saw one of these at formula D Wall the other weekend and nearly picked it up.
Forum: Engine, Exhaust, Transmission 05-30-2014, 03:34 PM
Replies: 297
Views: 99,350
Posted By Craig
I'm confused is the thermostat just there to...

I'm confused is the thermostat just there to lower temps with the header? I've yet to see anyone else put something like that out in a 'power pack' so I'm trying to figure out the benefit of it (when...
Forum: Engine, Exhaust, Transmission 05-27-2014, 01:12 PM
Replies: 17
Views: 4,903
Posted By Craig
I use one of the Mishimoto cans, works perfectly...

I use one of the Mishimoto cans, works perfectly for me - I'm actually going to clean it out to see how much oil is in the can, I'm thinking about a cup or so
Forum: Engine, Exhaust, Transmission 05-10-2014, 03:52 PM
Replies: 4,525
Views: 1,371,034
Posted By Craig
Nameless has become less and less interactive on...

Nameless has become less and less interactive on this forum because of the way everyone jumps down their throat. It's like everyone expected to see a 50whp/1000wtq increase and are raged that its not...
Forum: Engine, Exhaust, Transmission 05-10-2014, 03:42 PM
Replies: 12
Views: 3,882
Posted By Craig
That things got to be close to if not over a grand

That things got to be close to if not over a grand
Forum: Engine, Exhaust, Bolt-Ons 05-10-2014, 03:39 PM
Replies: 1,902
Views: 403,927
Posted By Craig
So I got a new job and this intake is my first...

So I got a new job and this intake is my first purchase, I need to to be available ASAP O_o
Forum: Engine, Exhaust, Transmission 05-08-2014, 11:29 PM
Replies: 799
Views: 316,856
Posted By Craig
I have to be honest, I've had to change the way I...

I have to be honest, I've had to change the way I drive because the car pulls noticeably harder in the 2k-4k range. Not sure about top end because I don't really whip around up there much.
Forum: Engine, Exhaust, Transmission 05-01-2014, 11:30 PM
Replies: 799
Views: 316,856
Posted By Craig
+1 for blocks without logo, feel like I got...

+1 for blocks without logo, feel like I got jipped :/
Forum: Engine, Exhaust, Transmission 05-01-2014, 11:27 PM
Replies: 90
Views: 55,175
Posted By Craig
I'm saying I already see oil in the lines coming...

I'm saying I already see oil in the lines coming from the block to the bay. The hose on the intake side is already discolored and dirty, while the exhaust side (going into the throttle body) is much...
Forum: Engine, Exhaust, Transmission 04-29-2014, 02:50 PM
Replies: 14
Views: 4,563
Posted By Craig
Google? You highschool whippersnappers should be...

Google? You highschool whippersnappers should be pretty good at figuring things out that way.

Seriously though, the top of this forum has a diagram showing the breakdown of the frs/brz exhaust...
Forum: NY / NJ / CT / PA 04-23-2014, 02:31 AM
Replies: 13
Views: 3,065
Posted By Craig
May have two cars for the list! I'll reach out to...

May have two cars for the list! I'll reach out to james on Facebook tomorrow if we're coming!
Forum: DIY (Do-It-Yourself) Guides 04-20-2014, 03:41 AM
Replies: 51
Views: 26,268
Posted By Craig
Just make sure you check all wires and make sure...

Just make sure you check all wires and make sure they're out of the way. I ended up pulling a lot of wires and disconnecting a lot more than crawford implied. I'm not coming out against them, but if...
Forum: Engine, Exhaust, Transmission 04-19-2014, 05:42 PM
Replies: 799
Views: 316,856
Posted By Craig
I just installed these, I'm not sure if its an AT...

I just installed these, I'm not sure if its an AT issue but honestly there's a lot of wiring that I ended up having to move around to get these in.

I do feel some improvement on the low end - that...
Forum: DIY (Do-It-Yourself) Guides 04-18-2014, 08:56 PM
Replies: 51
Views: 26,268
Posted By Craig
Tried this tonight, I followed all directions yet...

Tried this tonight, I followed all directions yet the manifold still doesn't lift up enough to fit spacers underneath. I can't figure out what the issue is .... If anyone has input i'd greatly...
Forum: Engine, Exhaust, Transmission 04-11-2014, 02:51 PM
Replies: 0
Views: 2,902
Posted By Craig
Mishimoto oil catch can install / review

Alright, I'm pretty pissed because I typed up a whole review of the Mishimoto oil catch can and the site timed out and I lost it all. I'm going to do my best to remember what I wrote...

Over the...
Forum: Engine, Exhaust, Transmission 04-10-2014, 05:42 PM
Replies: 90
Views: 55,175
Posted By Craig
No problem, I'll snap a decent picture when I get...

No problem, I'll snap a decent picture when I get home, at work right now.
Forum: Engine, Exhaust, Transmission 04-10-2014, 05:41 PM
Replies: 4,525
Views: 1,371,034
Posted By Craig
Guess I just like rasp because that sounds...

Guess I just like rasp because that sounds amazing to me
Forum: Engine, Exhaust, Transmission 04-10-2014, 10:10 AM
Replies: 90
Views: 55,175
Posted By Craig
Yes sir! Put maybe 600 miles on it and already...

Yes sir! Put maybe 600 miles on it and already seeing oil in the lines. Everyone should have one! Not to mention it spiced up the bay!


Sent from my iPhone using Tapatalk
Forum: Engine, Exhaust, Transmission 04-10-2014, 12:18 AM
Replies: 90
Views: 55,175
Posted By Craig
Awesome! Glad to see another company throw its...

Awesome! Glad to see another company throw its hat into the ring... Not gonna lie, a Mishimoto intake would look great next to my catch can!!
Forum: Engine, Exhaust, Transmission 04-10-2014, 12:15 AM
Replies: 17
Views: 4,317
Posted By Craig
I have the 4", sound great idle (once cold start...

I have the 4", sound great idle (once cold start is over) and beautiful at WOT / during shifts.
Forum: User/Vendor/Sponsor Reviews, Feedback, Comments 04-10-2014, 12:13 AM
Replies: 69
Views: 15,220
Posted By Craig
:popcorn:

:popcorn:
Forum: Groupbuys 04-08-2014, 12:43 PM
Replies: 425
Views: 58,647
Posted By Craig
Count me in! Black please!

Count me in! Black please!
Forum: Scion FR-S / Toyota 86 GT86 General Forum 04-05-2014, 12:59 PM
Replies: 347
Views: 67,245
Posted By Craig
I'm saying NYC or NJ, a five hour bubble around...

I'm saying NYC or NJ, a five hour bubble around NYC will garner a lot more people than a five hour radius around Florida or the Carolina's.


Sent from my iPhone using Tapatalk
Forum: Engine, Exhaust, Bolt-Ons 04-04-2014, 01:32 PM
Replies: 1,902
Views: 403,927
Posted By Craig
I'm going to agree, allen or torx. It probably...

I'm going to agree, allen or torx. It probably wouldn't hurt to let the purchaser choose the color at time of order. Offer 3 colors black/red/stainless imo.
Forum: Engine, Exhaust, Transmission 04-03-2014, 07:00 PM
Replies: 8
Views: 5,886
Posted By Craig
Think the evidence is in the variation in...

Think the evidence is in the variation in aftermarket headers gains. There may be some hp lost by the stock cat, but the reality is there's much more left on the table from optimizing the design.
...
Forum: Engine, Exhaust, Bolt-Ons 04-03-2014, 11:38 AM
Replies: 1,902
Views: 403,927
Posted By Craig
Thanks, I cut the quote down to size, don't worry...

Thanks, I cut the quote down to size, don't worry I used MLA format.

I can say that I'm in the group-buy for the spacers, will be purchasing your intake, and getting your pully cover/tooltray (I...
Showing results 1 to 30 of 338

 
Forum Jump

All times are GMT -4. The time now is 09:02 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.