Ls3, LT4 z06 size difference
Im thinking about doing a swap but before you tell me to just buy a corvette I live in australia and Z06 here starts at about $200k.
What I want to know is what the physical size difference between an LS3 and an LT4 is. The reason im interested in the LT4 is because the blower set up makes it appear to be shorter than an LSA so it might still fit under the bonnet but I just dont know, or will I an LSA fit anyway? Sent from my SM-G950F using Tapatalk |
Simple, a used Z06 would cost a lost less. Just say'n
Also your google-fu is super weak. Took me 2 seconds to type in ls3 dimensions and got my answer. You can do the same. Unless you want me to hold your hand while doing it. Honestly it all comes down to time and money. If you got both any engine combinations is possible. Good luck. Happy googling. |
Quote:
Sent from my SM-G965U using Tapatalk |
My LT4 is scheduled to arrive Monday. I will be starting the swap around the 20th after I return from vacation. I will be posting the build on my build page. I can tell you if the mounts bolt up this week.
|
Quote:
Sent from my SM-G950F using Tapatalk |
Bolt pattern is not going to work on the Vorshlag mounts for an LT motor. The LT pattern is taller and wider. I will get a measurement later this week. I just held it up to the block to get the will it bolt straight up or not question answered.
|
Quote:
try this mount https://www.dirtydingo.com/shop/prod...oducts_id=1621 https://www.amazon.com/2014-up-Engin.../dp/B01FG3MVDO |
Quote:
|
Quote:
Sent from my SM-G950F using Tapatalk |
Don't know how to post a link. Member car journal (long term build)
|
The LT bolt pattern measurement I got was
4 3\4" X 3 5/8" center to center on the holes. I was measuring it still on the pallet at an awkward angle, but I think it was accurate. I'm going to try to make some plates using those measurements. I will post pics of them bolted up when completed as well as any adj to my numbers. |
The LT bolt pattern measurement I got was
4 3\4" X 3 5/8" center to center on the holes. I was measuring it still on the pallet at an awkward angle, but I think it was accurate. I'm going to try to make some plates using those measurements. I will post pics of them bolted up when completed as well as any adj to my numbers. |
1 Attachment(s)
I drew up the design for the plate just need to make it now.
Vorshlag plate in picture center to center on the holes is 4 13/32" X 3 3/2". That was what I got anyway. |
1 Attachment(s)
Vorshlag plate set on drawing. Not to far off but not enough material to modify it
|
All times are GMT -4. The time now is 09:47 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by
Advanced User Tagging v3.3.0 (Lite) -
vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.