CEL but no DTCs detected?
I'm seeing a permanent CEL on my dash, but upon doing a vehicle DTC scan via the EcuTek app, I don't see any codes displayed.
Oddly enough, performing the OBD readiness scan does show "1 emissions-related DTC" next to the CHECK ENGINE checkbox, but it doesn't provide me with any way to view it. Any ideas on why I can't see the code? I cleared all DTCs just to see if it would come back, and nothing showed up after a 10 min cruise around town. I did check the gas cap :) Powertrain mods on my car (2017 BRZ): Delicious Stage 2 Tune JDL Catless UEL Headers Jackson Racing oil cooler |
Tune related most likely.
|
Quote:
Quote:
Get a different scan tool or go to autozone and borrow one. I have a feeling its p0420 and it might be a tune issue |
Quote:
|
Delicious probably forgot to turn off the emissions related codes in the tune.
|
Are you flex fuel with pressure sensor? Could be fuel pressure related to the D box.
|
Quote:
|
If it's EcuTek tuned then it could be that the CEL is set to come on for some reason when a Custom Map is triggered. That will not pop a code. EcuTek is normally very good for viewing DTCs.
|
All times are GMT -4. The time now is 10:46 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by
Advanced User Tagging v3.3.0 (Lite) -
vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.