Fs: custom turbo setup. GT3076R and more
 

$2200obo. Up for sale is my custom built turbo setup. It is a near battery mounted Garrett gt3076r with precision housings. The turbine housing is a dsm flanged 20g sized and the compressor housing is .60ar. I had it installed for around 15k miles before I removed it to have the uppipe reworked then I never got around to reinstalling it. I'm selling because I'm trading my brz for a new wrx (time to grow up... a little). I was never able to get hp figures but with the right tuning you should be around 270whp if not more. This setup allows you to retain the factory exhaust system with the exception of the over pipe. It is a blow through system with an Omni 3 bar MAP sensor. The FMIC allows you to keep the washer bottle in its factory location. The turbocharger sits slightly above the engine allowing the oil return to gravity drain into the rear cam plate so you won't have to tap your oil pan. You will have everything you need to have a boosted FRS or BRZ.
Included in the kit:
Garrett gt3076r
2.25in. Uppipe
2.25in. Downpipe
Tial 38mm wastegate with 7psi spring
Turbosmart Vee port pro BOV
FMIC with 2.5in charge pipes
Map pipe with flange
Omni 3 bar MAP sensor
PTuning cam plate for oil return
Oil and water fittings and hoses
SS braided oil feed sourced from front oil galley plug
Aem failsafe Guage and wideband
Vent pod to mount wideband gauge
Vacuum block
Battery heat shielding plate
Extra 4 ply silicone couplers and t bolt clamps

http://i47.photobucket.com/albums/f1...610_031626.jpg
http://i47.photobucket.com/albums/f1...611_094147.jpg

what the hell?

Interested in AEM failsafe and vent pod

What does the FMIC look like through the grill?

Price???

Can't see it much other than the clamps on the right side.
http://i47.photobucket.com/albums/f1...2595061386.jpg

Looking for $2500 shipped.

Very interested what did you use for tuning ? And is that for sale?

@raven1231 I have ecutek so unfortunately I can't sell the license with the kit. If I had to do it again I'd go with oft for resale value.

I have an OFT. Is it able to tune custom kits like this?

Also what was wrong with the uppipe?

From what I've read the oft either does or is close to having wideband compatibility so a competent tuner should be able to. My basemap was done on ecuflash and oft tuned the sbd kit so it's definitely possible.
also the uppipe was too close to the cam plate and frame so I had it re-welded.

Pm'd

You've been running unfiltered air through that car for how long? Or I'm missing something