Visconti EBC
 

I received my electronic boost controller today. I know how to rig up my hoses but where do i plug it in? I know i need to disconect something but what?

Edit: i believe i dont need to hook up the intake pipe but just the wastegate and compressor, am i wrong?

http://i65.photobucket.com/albums/h2...ps3c557427.jpg




edit:
,
here is a picture installed.. I did not want to drill any holes in the car just like the rest of the setup, everything is reversible fairly easily.. I will also add a video pretty soon

http://i65.photobucket.com/albums/h2...ps857ddc0c.jpg

Need to disconnect the purge valve solenoid, start reading from this post down.


http://www.ft86club.com/forums/showp...0&postcount=49

Damn i was wondering where u were! What took you so long to reply?? ;) thanks brahhhh

LOL!! You welcome!!

After going through the thread I linked, I have the same question. IMHO, the intake port should be plugged. LMK when you find out.

I asked the wife to blow in that port, cuz i aint blowin nothin, but its sealed and compressor and wastegate are open!

LMAO fuc*ing funny!

GREAT to know!! I am almost set on getting this, EBC FTW!

Yeah well it did not answer everything but so far it was the most usefull tread. I ll edit my original post here when done eith diy, perhaps install vid

same ebc i have. how much was it?

Where did u get yours, and wont ask you how its hooked up u dont even have an engine! ;)

i got mine from tactrix

http://www.tactrix.com/index.php?pag...mart&Itemid=53

Awesome to know!! Might have to use yours and buy you a new one if I cant get it by next Friday... ;)

thats fine with me. order it and have it sent to tony lol

Thanks. I'll check up with him tomorrow.