Dash blinker stay on after installing leds
 

How do i get them to turn off... I have the relay for leds installed too

And the tail light blinkers stay solid as well but blink when i use the signals
Attachment 65020
Attachment 65021

Sent from my SGH-T989 using Tapatalk 2

Bad flasher maybe? As easy as those things are to install it'd be hard to mess up.

What LED's did you replace?

I would also be guessing faulty flasher module.

Got it fixed, apparently having both front and back turn signals led amber messes with the car

Sent from my SGH-T989 using Tapatalk 2

i have the same problem. what's your "fix"?

the vendors i bought from said that only switch backs work with another set of leds
so i put switch backs in the front and amber leds in the back and that fixed the problem
having amber leds in front and back is what causes the problem

i already have switchbacks. :( guess i'll just contact the vendor i bought from and see what they have to say. @Diode Dynamics any ideas?

yea you should probably ask them, idk they also work with one set of leds in the back and stock bulbs up front

It might just be a bad flasher module or perhaps it's not creating enough resistance for the bulbs to operate correctly.

Our flasher module works with LED's up front and normal bulbs in the rear etc...so I'd PM the vendor and see if they will send you a new flasher

Hopefully that helps a bit

Nick C.

rats. I have buddy club tail lights and diode dynamics switchbacks to install. now I have to pick one...

The flasher that comes with the Buddy Club tails should be a LED capable relay (the one that came with my BC tails is) that technically should work fine.

I have the TapTurn flasher in atm that I installed before I got my Diode Dynamics switchbacks, but it won't be difficult to switch the BC flasher back in for a bit to test. Won't be able to do that until about noon tomorrow though.

Sent from my Nexus 7 using Tapatalk

I have LEDs front and rear...no problems with resistors in at both ends.

So is it impossible to have LED's front and rear with only a flasher module? I have 2 I can try. The Buddy Club one and also the CF18 from Diode Dynamics.

All you need is a flasher module designed for use with LED's, or inline resistors. One or the other, not both. (Although I'm not sure if it'll work with both). I have LED turn signals front and rear with an LED flasher module and all is well