follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Members List Calendar Search Today's Posts Mark Forums Read

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 8 1 2345 Last »
Showing results 1 to 30 of 220
Search took 0.02 seconds. Search: Posts Made By: Breadman
Forum: Engine, Exhaust, Transmission 03-24-2024, 11:23 AM
Replies: 12
Views: 774
Posted By Breadman
After breaking something in my AC while swapping...

After breaking something in my AC while swapping blocks, I finally removed the heat exchanger for it and it has helped all my temps a decent amount. Not sure if you can do that but it has seemed to...
Forum: NY / NJ / CT / PA 03-07-2024, 08:15 AM
Replies: 12
Views: 534
Posted By Breadman
Boxerfest is in york, and I agree with doing it...

Boxerfest is in york, and I agree with doing it outside of pittsburgh. I finally escaped the city alive after nearly a decade and never want to go back.
Forum: BRZ First-Gen (2012+) -- General Topics 01-07-2024, 11:17 AM
Replies: 14
Views: 1,610
Posted By Breadman
I had a provent 200 on my diesel truck before i...

I had a provent 200 on my diesel truck before i sold it but it is way overkill for an NA brz. If you are looking for catch cans I would recommend radium. The only issue they have caused was a fitting...
Forum: Engine, Exhaust, Transmission 12-05-2023, 09:40 AM
Replies: 13
Views: 1,242
Posted By Breadman
I had this issue with the HF transmission jack...

I had this issue with the HF transmission jack and opted to just replace the fork, tob, and clutch plate under the car. Having an additional floor jack was also nice to get the angle correct.
Forum: Forced Induction 09-22-2023, 04:34 PM
Replies: 16
Views: 1,510
Posted By Breadman
I just got off the phone with jackson racing and...

I just got off the phone with jackson racing and this is what they recommended. I thought it originally sounded too dumb to work but that's 2 parties that said its good so that is what I'll do. I'm...
Forum: Software Tuning 08-27-2023, 10:21 AM
Replies: 10
Views: 1,622
Posted By Breadman
Zach from CSG

Zach from CSG
Forum: Software Tuning 08-20-2023, 07:38 PM
Replies: 6
Views: 1,077
Posted By Breadman
I currently have it inside a KVM, but i'm going...

I currently have it inside a KVM, but i'm going to move it to a windows laptop and I guess use virtual box. The jist of it is as long as the usb controller is passed into the guest, ecutek is non the...
Forum: Software Tuning 08-20-2023, 11:24 AM
Replies: 6
Views: 1,077
Posted By Breadman
This is not a vendor recommended best practice,...

This is not a vendor recommended best practice, but i run my tuning machine inside a VM and when i need a new laptop I just move the VM. I have been doing this for years and the only issue I ever had...
Forum: Tracking / Autocross / HPDE / Drifting 07-25-2023, 08:09 AM
Replies: 20
Views: 1,652
Posted By Breadman
I have a small rubbermade with 2 wrenches and a...

I have a small rubbermade with 2 wrenches and a few sockets as well as a light and random fluids. Just enough to change a tire or tighten up some bolts. If stuff goes really south it will be getting...
Forum: Engine, Exhaust, Transmission 07-15-2023, 10:34 AM
Replies: 69
Views: 10,516
Posted By Breadman
They source their coolers from here iirc...

They source their coolers from here iirc https://setrabusa.com/collections/proline-std-oil-coolers?grid_list=grid-view&filter.v.price.gte=&filter.v.price.lte=


if you all you would need is to...
Forum: Forced Induction 06-21-2023, 02:50 PM
Replies: 40
Views: 3,202
Posted By Breadman
Doesn't that hose need vacuum? That goes into my...

Doesn't that hose need vacuum? That goes into my 2nd catch can then around to my intake before my supercharger. Not sure if it has to do with the sound, just taking stabs in the dark.
Forum: Tracking / Autocross / HPDE / Drifting 06-20-2023, 10:55 AM
Replies: 8
Views: 1,537
Posted By Breadman
I run 10w40 as the builder recommends and on cold...

I run 10w40 as the builder recommends and on cold start in cold weather it can be north of 100psi measured from the top block port. Once it reaches operating temp it idles at 20psi.
Forum: Member's Car Journals 06-19-2023, 08:08 AM
Replies: 43
Views: 6,071
Posted By Breadman
I run 27psi square. It worked out for me when NA...

I run 27psi square. It worked out for me when NA on REs but now both those changed. The wear looks good but I havent thought about it much.


Also I will not be autocrossing the wrx. I just wanted...
Forum: Member's Car Journals 06-19-2023, 07:30 AM
Replies: 43
Views: 6,071
Posted By Breadman
All the real power is 5.5k and above. I took a...

All the real power is 5.5k and above. I took a few events to actually start going for it. It looks like the trans and axles are holding so that is good. It does feel a bit understeery and that was...
Forum: Member's Car Journals 06-18-2023, 09:43 PM
Replies: 43
Views: 6,071
Posted By Breadman
Yeah so a bunch of stuff happened and now it is...

Yeah so a bunch of stuff happened and now it is running. Still getting use to the car, but it feels a little more understeery than I remember. Here was my fastest run which was a middle pax
...
Forum: Engine, Exhaust, Transmission 06-18-2023, 09:22 PM
Replies: 69
Views: 10,516
Posted By Breadman
I believe there was an oil port blocked in the...

I believe there was an oil port blocked in the upper oil pan or something. They fixed that but then said the oil pump was bad or something. I had to pay for that out of pocket. Overall i was very...
Forum: Engine, Exhaust, Transmission 06-18-2023, 11:10 AM
Replies: 69
Views: 10,516
Posted By Breadman
I wouldn't drive on that at all. My IAG block...

I wouldn't drive on that at all. My IAG block made 0psi when i tried to crank it over. It is fixed now but with 10w40 like you said it is nearly 100psi cold start and takes quite a bit of time to...
Forum: Engine, Exhaust, Transmission 06-09-2023, 09:07 PM
Replies: 13
Views: 1,045
Posted By Breadman
When I installed mine in my IAG block all i did...

When I installed mine in my IAG block all i did was put a little bit of oil on it like the manual said and then popped them in with a wood block behind it.
Forum: Engine, Exhaust, Transmission 05-26-2023, 01:16 PM
Replies: 12
Views: 966
Posted By Breadman
Because SOA is complete dogshit. Customer service...

Because SOA is complete dogshit. Customer service is clearly something they cost cut.
Forum: Engine, Exhaust, Transmission 05-21-2023, 09:28 PM
Replies: 25
Views: 2,164
Posted By Breadman
They told me there weren't any fa20 motors in the...

They told me there weren't any fa20 motors in the us but they could build one if i wanted a quote. I asked for a quote and wasnt prepared for 21k + labor. I have never been so insulted in my life.
Forum: Engine, Exhaust, Transmission 05-21-2023, 07:55 PM
Replies: 25
Views: 2,164
Posted By Breadman
When I had to deal with SoA, it was a cluster...

When I had to deal with SoA, it was a cluster fuck. Pissing into the wind would be more productive.
Forum: BRZ First-Gen (2012+) -- General Topics 05-12-2023, 07:36 PM
Replies: 12
Views: 1,421
Posted By Breadman
I just got some konig hexaforms with continential...

I just got some konig hexaforms with continential ecs2. I wish they were more gold but would recommend both the wheel and...
Forum: Scion FR-S / Toyota 86 GT86 General Forum 05-12-2023, 05:22 PM
Replies: 17
Views: 2,239
Posted By Breadman
I actually went back and checked no my old engine...

I actually went back and checked no my old engine since i just got my trucks oil back and i did have some. Id still recommend the heavier oil if you autocross tho
Forum: Wheels and Tires 05-06-2023, 08:36 PM
Replies: 12
Views: 2,472
Posted By Breadman
949 Racing 6UL 17x9 +40 with tire 500$ *NO TPMS*

This is a 17x9 +40 6UL set of wheels with Indy500s in 255/40/17. There is no tpms in any of the wheels. The tires have about 5mm of tread left. These where my dailies and I kept them pretty clean and...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 05-01-2023, 01:31 PM
Replies: 9
Views: 1,469
Posted By Breadman
You don't really want to be testing things with...

You don't really want to be testing things with multiple independent variables
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 05-01-2023, 08:39 AM
Replies: 9
Views: 1,469
Posted By Breadman
On average people are too dumb to understand what...

On average people are too dumb to understand what rotational inertia is, that is why just weight (technically it should list mass instead) is listed. I=mr^2 so for a given mass as the distance from...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 04-13-2023, 09:44 PM
Replies: 59
Views: 9,182
Posted By Breadman
Im probably going to get some hexagrams because i...

Im probably going to get some hexagrams because i need new daily tires anyway and my black 6uls arent doing it for me anymore
Forum: Engine, Exhaust, Transmission 04-11-2023, 01:08 PM
Replies: 16
Views: 2,287
Posted By Breadman
I still have my blown engine in my garage. Pretty...

I still have my blown engine in my garage. Pretty much everyone i talked to said not to DIY it. I honestly think I could have done it myself too but it saved me a lot of trouble having pros do it for...
Forum: Engine, Exhaust, Transmission 04-11-2023, 07:49 AM
Replies: 16
Views: 2,287
Posted By Breadman
My IAG stage 2 was 12.5:1 compression ratio and i...

My IAG stage 2 was 12.5:1 compression ratio and i run a flex tune with 93/e85 but mostly e85. I did get the gsc valve spring titanium retainers. They told me that it could handle 8200rpm and 20psi...
Forum: Forced Induction 04-11-2023, 07:31 AM
Replies: 10
Views: 1,288
Posted By Breadman
I have a koyo rad, then a jackson racing...

I have a koyo rad, then a jackson racing supercharger fluid cooler, and a jackson racing oil cooler that both go on the same mounting bar that slide in right in front of the AC. so it goes the 2...
Showing results 1 to 30 of 220
Page 1 of 8 1 2345 Last »

 
Forum Jump

All times are GMT -4. The time now is 03:17 PM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.