follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.61 seconds. Search: Posts Made By: Sportsguy83
Forum: Engine Swaps 05-05-2021, 08:38 AM
Replies: 32
Views: 13,410
Posted By Ashikabi
Thing is, for the price. You can buy a pretty new...

Thing is, for the price. You can buy a pretty new vette. I have an LS swapped FRS. It was very very expensive to put together and I'm still shoveling money into it(I'll never be satisfied). With what...
Forum: Forced Induction 04-23-2021, 03:18 PM
Replies: 186
Views: 30,811
Posted By Lantanafrs2
How is any fa20 worth 43 grand?

How is any fa20 worth 43 grand?
Forum: Engine Swaps 03-27-2021, 07:38 AM
Replies: 7
Views: 2,110
Posted By steve99
The 2013 ecu calibration will work fine in 2016...

The 2013 ecu calibration will work fine in 2016 car, as long as both manual or both auto.


If you were using a 2016 ecu calibration in a 2013 car it would thow some cel code re dash and...
Forum: Engine, Exhaust, Transmission 12-15-2020, 09:57 PM
Replies: 283
Views: 52,787
Posted By mav1178
a good explanation of why OEMs spend so much time...

a good explanation of why OEMs spend so much time and money on R&D.
Forum: Engine Swaps 11-30-2020, 02:36 PM
Replies: 1,305
Views: 320,626
Posted By DustinS
Black Friday was a bit of a mess for me. Spent...

Black Friday was a bit of a mess for me. Spent way too much money, but most parts should be on their way for the car.

Emtron KV8 w/ FRS canbus
Emtron Flying lead harness
Haltech IC-7 Dash...
Forum: Forced Induction 07-15-2020, 03:24 PM
Replies: 64
Views: 8,291
Posted By CSG Mike
^ I'm inclined to agree. I fell into 350whp and...

^ I'm inclined to agree. I fell into 350whp and have sort of sat there.
Forum: Forced Induction 07-01-2020, 09:59 AM
Replies: 64
Views: 8,291
Posted By DarkPira7e
In my opinion, 300-330whp feels perfect for me. ...

In my opinion, 300-330whp feels perfect for me. Enough to get excited under any circumstance (straight road or cornering) but not so much that it requires extensive modifications to support it.
Forum: Engine Swaps 06-17-2020, 02:09 PM
Replies: 16
Views: 8,513
Posted By spitsnaugle
Skip Sikky- just go to WiringSpecialities direct....

Skip Sikky- just go to WiringSpecialities direct. Sikky is just reselling their harnesses.
Forum: Engine Swaps 06-16-2020, 02:58 PM
Replies: 40
Views: 10,449
Posted By mrg666
I have also found myself checking C7 Grand Sports...

I have also found myself checking C7 Grand Sports several times. Hope you get one!
Forum: Engine Swaps 06-15-2020, 11:07 AM
Replies: 40
Views: 10,449
Posted By gtpvette
Now you're talking......

Now you're talking......
Forum: Engine Swaps 06-13-2020, 11:02 PM
Replies: 40
Views: 10,449
Posted By solidsnake11
Yes, that would have been great or any other...

Yes, that would have been great or any other tuner inline 4. If they would have turned the boxer into a v4 it would have been great. I'm not so much into spending hours to change spark plugs. If I...
Forum: Issues | Warranty | Recalls / TSB 05-23-2020, 07:01 PM
Replies: 37
Views: 10,991
Posted By norcalpb
Well guys I finally solved it. Hallelujah. The...

Well guys I finally solved it. Hallelujah. The car drives so smoothly now lol, it almost brought a tear to my eye to finally fix this.

This is mostly an installation error on my part after I...
Forum: Issues | Warranty | Recalls / TSB 05-17-2020, 10:34 PM
Replies: 2
Views: 1,697
Posted By humfrz
I'd suggest you make sure the ECU is grounded...

I'd suggest you make sure the ECU is grounded good.
Forum: Engine, Exhaust, Transmission 05-11-2020, 08:15 PM
Replies: 91
Views: 10,693
Posted By Pat
This thread is not what I expected based on the...

This thread is not what I expected based on the subject line.
Forum: Engine Swaps 04-29-2020, 04:06 PM
Replies: 10
Views: 4,711
Posted By spitsnaugle
This^ Do it right once. I used an LS2 and if...

This^
Do it right once.
I used an LS2 and if I did it over, would have went LS3.
Forum: Engine Swaps 04-26-2020, 01:29 PM
Replies: 99
Views: 37,191
Posted By TRS
Not yet, I need to slow the progress down a...

Not yet, I need to slow the progress down a little since my budget for that project is limitted and I had some unplaned efforts due to the Magnum F. (When I calculated the budget it was planed to use...
Forum: Engine Swaps 04-24-2020, 11:19 AM
Replies: 99
Views: 37,191
Posted By TRS
Finally I had the chance to do a short...

Finally I had the chance to do a short walkthrough of my project and upload it to youtube. Here you go:


https://youtu.be/Xdlml9k7404
Forum: Engine Swaps 04-18-2020, 05:31 PM
Replies: 423
Views: 183,755
Posted By gtpvette
Work continues. Lots of small tasks to complete,,...

Work continues. Lots of small tasks to complete,, basically a punch list before I try to start. Tomorrow I'll finish up a few then pull the motor hopefully for the last time. The biggest tasks are...
Forum: Software Tuning 04-16-2020, 08:44 PM
Replies: 44
Views: 25,739
Posted By Wayno
Fans are on/off. The table with the lower...

Fans are on/off.
The table with the lower values is for AC ON, the other is for AC OFF.
Forum: Software Tuning 04-16-2020, 04:33 AM
Replies: 44
Views: 25,739
Posted By steve99
I've never seen a fan speed setting table, it...

I've never seen a fan speed setting table, it might be there just not defined
Forum: Software Tuning 04-15-2020, 05:50 PM
Replies: 44
Views: 25,739
Posted By steve99
All you should need is to change the fan mode A...

All you should need is to change the fan mode A and B tables , use the lower ones that start at 190 F, just be careful your definition is in F as well and not C.


If your A\C is struggling that...
Forum: Software Tuning 04-15-2020, 05:17 AM
Replies: 56
Views: 64,683
Posted By steve99
https://www.ft86club.com/forums/attachment.php?att...

https://www.ft86club.com/forums/attachment.php?attachmentid=102492&stc=1&d=1423785966 Use the tables that start with 190.4, just make both fan tables same


Just change fan modes tables A and B
Forum: Software Tuning 03-30-2020, 04:36 PM
Replies: 32
Views: 8,640
Posted By Kodename47
Actual live tuning is now available...

Actual live tuning is now available (https://us7.campaign-archive.com/?u=3293297053d29d26e037ea32b&id=ca5d3ebac1) on EcuTek. No need for CPC or O2 sensor hacks or anything.
Forum: Engine Swaps 03-16-2020, 12:21 PM
Replies: 423
Views: 183,755
Posted By gtpvette
Thanks,,, it'll double as a Covid-19 isolation...

Thanks,,, it'll double as a Covid-19 isolation ward. :thumbsup:
Forum: Engine Swaps 03-15-2020, 09:26 PM
Replies: 423
Views: 183,755
Posted By gtpvette
Moving forward with paint work. Made a paint...

Moving forward with paint work. Made a paint booth,,, sort of. I don't have a garage as my home is on stilts. I wrapped four stilts with palate wrap to create a paint booth of sorts. Not perfect but...
Forum: Engine Swaps 02-24-2020, 01:42 PM
Replies: 423
Views: 183,755
Posted By gtpvette
A few updates. I’ve been moving closer to paint...

A few updates. I’ve been moving closer to paint but the amount of water I’m getting when shooting primer had become a problem. I opted to make a water separator out of ¾” copper pipes,, saw it on the...
Forum: Engine Swaps 02-19-2020, 03:46 PM
Replies: 37
Views: 8,158
Posted By Tcoat
Yep that and maybe another half dozen or so...

Yep that and maybe another half dozen or so possibilities in descending order of probability.
Forum: Forced Induction 02-07-2020, 01:21 PM
Replies: 60
Views: 7,839
Posted By DarkPira7e
I know it's not apples to apples, but I have a...

I know it's not apples to apples, but I have a bigger turbo in my car than the Greddy ( location may not be the same though). I just trimmed/cut a portion of the fan "guard" that the compressor...
Forum: Forced Induction 02-04-2020, 07:52 PM
Replies: 60
Views: 7,839
Posted By Kiske
Damn ghost in hear. Been quite a while since your...

Damn ghost in hear. Been quite a while since your username has popped up in the FI section! :)

Also don't forget, the whole reason for the FBM fan kit existing wasn't to improve on cooling but, to...
Forum: Forced Induction 01-30-2020, 09:07 PM
Replies: 60
Views: 7,839
Posted By 86MLR
This? ...

This?

https://www.verus-engineering.com/shop/product/a0045a-high-performance-radiator-brz-frs-gt86-358?category=41

Note:
1. Designed for motorsport? Not stop start traffic
2. Car on website...
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -4. The time now is 08:59 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.