follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 13 of 13
Search took 2.02 seconds.
Search: Posts Made By: Redbrz
Forum: Forced Induction 11-19-2015, 04:36 PM
Replies: 76
Views: 43,701
Posted By Drift-Office
So here's the results from the second E-Force...

So here's the results from the second E-Force install we did.


6MT FRS
Chevron 92 Pump Gas
Gruppe-S UEL Header*
Stock Clutch
Stock OP / Stock FP
Perrin 2.5 Inch CBE
Forum: Forced Induction 10-24-2015, 01:33 AM
Replies: 76
Views: 43,701
Posted By Drift-Office
We got the non-tuner kit, so that means no CARB...

We got the non-tuner kit, so that means no CARB tune but that didn't stop a discussion we had with Edelbrock, who sent us their CARB calibration to check it when used with 92 Octane...

123434
...
Forum: Forced Induction 10-23-2015, 01:07 PM
Replies: 76
Views: 43,701
Posted By j123ic
The unit Drift-Office received is currently...

The unit Drift-Office received is currently running the 3.25" supercharger pulley. The E-Force 1320 supercharger is nowhere near its capacity with the 3.25" pulley being used. There's still a 3.00",...
Forum: Forced Induction 10-21-2015, 05:12 PM
Replies: 76
Views: 43,701
Posted By djdnz
Drift-Office Quit teasing, show off the...

Drift-Office

Quit teasing, show off the goods! :)
Forum: Forced Induction 10-10-2015, 01:14 AM
Replies: 153
Views: 109,174
Posted By NotSoJDM
Review: Edelbrock Supercharger Kit

Hey Guys! I recently had the opportunity to install my Edelbrock kit on my 2013 Subaru BRZ. Below are my initial impressions of the kit from installation to first drive, and will update this thread...
Forum: Forced Induction 10-03-2015, 05:42 PM
Replies: 76
Views: 43,701
Posted By Drift-Office
123351 123350 Hardware and Install...

123351

123350


Hardware and Install Notes:

Took roughly 8 hours. We spent more time trying out different hose routing ideas to see which one would end up cleaner. The included binder is...
Forum: Forced Induction 10-03-2015, 05:41 PM
Replies: 76
Views: 43,701
Posted By Drift-Office
Drift-Office : Edelbrock E-Force Supercharged!

Hey all - just posting up pics where and when I can. Recently had one shipped over to us and this thing is AWESOME and COOL looking as we already know. I'll leave my comments in the tuning segment of...
Forum: Northwest 05-09-2015, 05:46 AM
Replies: 32
Views: 10,910
Posted By Andrew025
My god, I can only imagine how loud that would be...

My god, I can only imagine how loud that would be on cold starts.
I just put a single exit muffler delete with stock header and it's pretty loud. It's pretty annoying going down/up 26 to Portland in...
Forum: Northwest 05-05-2015, 12:25 PM
Replies: 32
Views: 10,910
Posted By RobertPaulson
very nice, here's mine stock tune with drop in...

very nice, here's mine stock tune with drop in filter, catless fp and perrin cbe vs tuned with tomei uel, perrin op and the rest of the mods from the stock run. I'm most impressed with the gain of...
Forum: Northwest 05-04-2015, 11:41 PM
Replies: 32
Views: 10,910
Posted By Zaneman
Here is my car. Catted JDL EL header with a...

Here is my car. Catted JDL EL header with a catted mid pipe as well.

This is a 3rd gear run comparing my off the shelf Perrin tune to one done by Bob. http://i62.tinypic.com/30w1f1t.jpg

Here...
Forum: Northwest 05-04-2015, 08:28 PM
Replies: 32
Views: 10,910
Posted By Jmonty
Header did a nice job getting rid of the TQ dip,...

Header did a nice job getting rid of the TQ dip, and the nice tune as well
Forum: Northwest 05-04-2015, 06:10 PM
Replies: 32
Views: 10,910
Posted By OoLong
+1 I climb that HW 26 hill after the tunnel...

+1

I climb that HW 26 hill after the tunnel on my Perrin 3inch catback and it is super uncomfortable (not to mention the pressure change). Props to you for handling that exhaust and no going...
Forum: Northwest 05-03-2015, 01:49 PM
Replies: 32
Views: 10,910
Posted By Imrac
+1 Pretty sure I have the exact same exhaust...

+1

Pretty sure I have the exact same exhaust pieces as you :) good taste.
Showing results 1 to 13 of 13

 
Forum Jump

All times are GMT -4. The time now is 07:41 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.