follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Members List Calendar Search Today's Posts Mark Forums Read

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 16 1 234511 Last »
Showing results 1 to 30 of 480
Search took 0.90 seconds. Search: Posts Made By: Keenercarguy
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 07-26-2019, 10:23 AM
Replies: 22
Views: 9,247
Posted By AT-JeffT
Thanks for posting this. I had some very minor...

Thanks for posting this. I had some very minor (but annoying) noise when reversing out of parking spots, especially if there was some incline. The bushings looked mostly fine. Only a small gap...
Forum: Brakes, Suspension, Chassis 07-09-2019, 07:26 AM
Replies: 4
Views: 1,201
Posted By KDad2
From the manufacturer: These camber plates are...

From the manufacturer:
These camber plates are direct replacements for the OEM top hats and retain the same installed height as the OEM units. Machined from 6061-T6 and anodized for corrosion...
Forum: Wheels and Tires 05-16-2019, 09:37 PM
Replies: 16
Views: 4,989
Posted By invaliduser
So here's the the thing... I could have posted...

So here's the the thing...
I could have posted these for sale and not mentioned anything about a wheel being tough to balance. Because most people don't have the equipment or knowledge on mounting...
Forum: Wheels and Tires 10-08-2018, 06:23 PM
Replies: 10
Views: 2,835
Posted By Sportsguy83
You need a new wife :slap:

You need a new wife :slap:
Forum: Brakes, Suspension, Chassis 08-06-2018, 12:06 PM
Replies: 9
Views: 2,092
Posted By eb66
Pm'd you

Pm'd you
Forum: Brakes, Suspension, Chassis 08-03-2018, 10:53 AM
Replies: 7
Views: 2,483
Posted By dstrout
HVT non rising Camber Plates

I bought these camber plates last week:

http://www.ft86club.com/forums/showthread.php?t=128140

and then found a full set of coilovers, so I don't need them. Blatantly stolen description:


...
Forum: Engine, Exhaust, Bolt-Ons 07-01-2018, 03:36 PM
Replies: 23
Views: 4,593
Posted By bfsnail
Exedy Clutch and Flex Fuel - CHEAP!

-Exedy stage 2 clutch - 7000 miles - $150 Shipped SOLD
-Flex Fuel Sensor and display - SOLD

Located in Omaha, NE.
Forum: Engine, Exhaust, Transmission 05-16-2018, 06:45 PM
Replies: 8
Views: 1,557
Posted By JacksTrans
agreed, it should be fine

agreed, it should be fine
Forum: Engine, Exhaust, Transmission 05-16-2018, 06:32 AM
Replies: 8
Views: 1,557
Posted By Tcoat
It will be fine. Do not buy one that was stored...

It will be fine. Do not buy one that was stored is a swamp in Louisiana though.
Forum: Engine, Exhaust, Transmission 05-14-2018, 08:26 PM
Replies: 8
Views: 1,557
Posted By JacksTrans
how long has it been stored?

how long has it been stored?
Forum: Engine, Exhaust, Transmission 05-11-2018, 02:05 PM
Replies: 8
Views: 1,557
Posted By Grady
Yes gears are hardened steel that are verry...

Yes gears are hardened steel that are verry susceptible to rust. Roller bearing are even worse. Where was the diff stored and what are the average weather conditions of the location? By the coast, in...
Forum: Wheels and Tires 04-02-2018, 01:10 PM
Replies: 14
Views: 4,285
Posted By XanRules
Spacers sold this morning, sorry Keenercarguy!

Spacers sold this morning, sorry Keenercarguy!
Forum: Engine, Exhaust, Bolt-Ons 03-22-2018, 08:10 PM
Replies: 25
Views: 9,027
Posted By D K
Supermassive track car part-out

Yep. This is fianally happening.

Im sure a lot of people on here know this car, so it goes without saying that everything listed is unique, bespoke, one of a kind, top notch quality, track ready...
Forum: Issues | Warranty | Recalls / TSB 02-27-2018, 01:01 PM
Replies: 24
Views: 6,089
Posted By strat61caster
Might've been a few decades since you've been out...

Might've been a few decades since you've been out that way, some parts of NC are nicer than anything in SF proper imho, much less the crap places I can afford.
Forum: Issues | Warranty | Recalls / TSB 02-27-2018, 11:57 AM
Replies: 24
Views: 6,089
Posted By strat61caster
No, every time I comparison shop parts at my...

No, every time I comparison shop parts at my local dealer vs. a dealer in Florida or Michigan it's always cheaper to ship it across the country.

ymmv

Check the parts list and get the highest...
Forum: Brakes, Suspension, Chassis 02-16-2018, 03:36 PM
Replies: 21
Views: 10,165
Posted By D_Thissen
1195 CAD lol.

1195 CAD lol.
Forum: Brakes, Suspension, Chassis 02-16-2018, 01:55 PM
Replies: 21
Views: 10,165
Posted By subaruMike
I'd offer $1,195... the brakes are not worth 10%...

I'd offer $1,195... the brakes are not worth 10% the cars value.
Forum: Brakes, Suspension, Chassis 10-28-2017, 08:51 AM
Replies: 7
Views: 1,452
Posted By Lunatic
My Mistake, they are the HPS 5.0 pads

My Mistake, they are the HPS 5.0 pads
Forum: Engine, Exhaust, Transmission 10-20-2017, 09:46 AM
Replies: 5
Views: 2,064
Posted By Icecreamtruk
https://www.pointmeby.com/2017/09/10/86-brz-frs-p0...

https://www.pointmeby.com/2017/09/10/86-brz-frs-p0351-cel-p0353-coil-pack-how-fix/

Knock yourself out, be patient, its a hard to reach place, but tell yourself that it is still the easiest to...
Forum: Engine, Exhaust, Transmission 10-20-2017, 07:55 AM
Replies: 5
Views: 2,064
Posted By steve99
http://www.ft86club.com/forums/showthread.php?t=88...

http://www.ft86club.com/forums/showthread.php?t=88906
Forum: Engine, Exhaust, Transmission 10-20-2017, 06:38 AM
Replies: 5
Views: 2,064
Posted By Merlinop2000
You don’t really need a diy cylinder 1 is the...

You don’t really need a diy cylinder 1 is the passanger front so u have to take the injector ecu and fuel rail cover off to get to it. It’s really tight and frustrating but other than that is like a...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 10-06-2017, 11:13 AM
Replies: 30
Views: 10,579
Posted By Stang70Fastback
My apologies for the delayed response to your...

My apologies for the delayed response to your questions. When you started talking about a scale compared to stock, I thought about it, and realized that I wouldn't be able to give you a very good...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 10-05-2017, 04:04 PM
Replies: 30
Views: 10,579
Posted By Stang70Fastback
Hello! I have the KW V3s. I've had them for 1.5...

Hello! I have the KW V3s. I've had them for 1.5 years now. My goals were similar to yours. My car is a year-round DD, and I wanted comfortable coilovers (for miserable Chicago roads) that would cope...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 10-05-2017, 03:46 PM
Replies: 30
Views: 10,579
Posted By wparsons
And yet again RCE comes off as awesome even if it...

And yet again RCE comes off as awesome even if it means not selling their own product :thumbsup:
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 10-04-2017, 10:42 PM
Replies: 30
Views: 10,579
Posted By Turdinator
Not sure what you budget is but the Ohlins R&T...

Not sure what you budget is but the Ohlins R&T might work for you, especially with the softer spring rates they now have.
Forum: Engine, Exhaust, Transmission 09-01-2017, 01:23 AM
Replies: 138
Views: 21,084
Posted By Ultramaroon
On top of tossing in an insulting jab about...

On top of tossing in an insulting jab about double clutching being pointless you've ignored my point. How much torque do you think it takes to spool the gears while it's in neutral? Rhetorical...
Forum: Engine, Exhaust, Transmission 08-26-2017, 04:00 PM
Replies: 138
Views: 21,084
Posted By Tcoat
There are maybe 3 confirmed cases on here where a...

There are maybe 3 confirmed cases on here where a synchro broke on a stock car. If you are double clutching up shifts you are doing it wrong. Really really wrong.
Forum: Engine, Exhaust, Transmission 08-26-2017, 03:06 PM
Replies: 138
Views: 21,084
Posted By Ultramaroon
How do you shift? ☑Granny shift ☐Rev match...

How do you shift?

☑Granny shift
☐Rev match Only
☐Double clutch like you should
Forum: Engine, Exhaust, Transmission 08-26-2017, 02:46 PM
Replies: 138
Views: 21,084
Posted By humfrz
I haven't double clutched a MT since the 1940s...

I haven't double clutched a MT since the 1940s ......:iono:


humfrz
Forum: Engine, Exhaust, Transmission 08-26-2017, 01:22 PM
Replies: 138
Views: 21,084
Posted By TommyW
Why would you double clutch a modern transmission?

Why would you double clutch a modern transmission?
Showing results 1 to 30 of 480
Page 1 of 16 1 234511 Last »

 
Forum Jump

All times are GMT -4. The time now is 04:16 PM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.