follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 5 1 2345
Showing results 1 to 30 of 129
Search took 1.22 seconds. Search: Posts Made By: Khyron686
Forum: Engine, Exhaust, Transmission 08-21-2016, 11:23 AM
Replies: 3
Views: 1,414
Posted By Spartarus
Yes, M10 x 1.25 Thread OD is .393, close...

Yes, M10 x 1.25

Thread OD is .393, close enough to M10

6 threads measure .294 inches = 7.4676mm / 6 = 1.2446 close enough to 1.25

Close enough for an analog caliper. It's all I had on my...
Forum: Forced Induction 11-21-2015, 03:17 PM
Replies: 11,295
Views: 3,413,576
Posted By Sojhinn
Slight increase with the new dump batteries, but...

Slight increase with the new dump batteries, but easier wiring. I wouldn't recommend it since the cost to performance increase isn't huge for you.


Sent from my iPhone using Tapatalk
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 05-07-2015, 05:04 PM
Replies: 2,548
Views: 1,736,613
Posted By tahdizzle
Appropriate sidewall is key. 275/35/19 is...

Appropriate sidewall is key.

275/35/19 is not meaty in my opinion. not at all.

Do i think a 245/40/17 is meaty?

yes I do, on a twin. Maybe not on a Nissan Maxima, but on a small car like...
Forum: Forced Induction 05-06-2015, 02:45 PM
Replies: 11,295
Views: 3,413,576
Posted By Sojhinn
Don't NEED it. Just requires tapping a wire at...

Don't NEED it. Just requires tapping a wire at the controller instead of plugging in an adapter.


Sent from my iPhone using Tapatalk
Forum: Forced Induction 04-16-2015, 12:26 PM
Replies: 11,295
Views: 3,413,576
Posted By Shiv@Openflash
Just talked with Rob. For v1 guys: Using a...

Just talked with Rob. For v1 guys:

Using a voltmeter measure the voltage of both wires going into the microswitch. With the switch off (throttle not pressed):
One wire will read ~0v.
The...
Forum: Tracking / Autocross / HPDE / Drifting 02-25-2015, 04:55 PM
Replies: 5,068
Views: 1,318,422
Posted By CSG Mike
AutoX? Go with the wider tire. You may need a...

AutoX? Go with the wider tire. You may need a spacer, but is that legal for your AutoX setup? If you get spacers, get ARP extended studs and open ended lugnuts.

I believe the RE71R supercedes...
Forum: Forced Induction 09-16-2014, 06:14 PM
Replies: 1,206
Views: 358,471
Posted By Shiv@Openflash
You don't need to send your stock file to me...

You don't need to send your stock file to me (Shiv :)) if you see your CAL ID supported in the ESC map download folder. It's only if you have a currently unsupported ROM do you need to send me your...
Forum: Forced Induction 07-11-2014, 04:53 PM
Replies: 226
Views: 60,187
Posted By Shiv@Openflash
The factory sensor isn't a true wideband. Not is...

The factory sensor isn't a true wideband. Not is it a narrow band. It's a broad response narrow band sensor that is reasonable accurate down to ~11.5 or so. This is why the o2 sensor calibration...
Forum: Forced Induction 07-10-2014, 02:47 AM
Replies: 226
Views: 60,187
Posted By Shiv@Openflash
JUST RELEASED: v2.0 OTS tunes for ESC w/ 1.5 dump + OFH

Hi guys,

Thanks for all the positive feedback on these Beta maps we released last week. Now they are officially non-BETA (v1.6) as reflected on the website. No changes to the mapping, just the...
Forum: Forced Induction 07-08-2014, 08:02 PM
Replies: 226
Views: 60,187
Posted By Shiv@Openflash
I've tested almost all the available UEL and EL...

I've tested almost all the available UEL and EL headers available. Both in NA and ESC application and UEL, on the whole, is generally superior. The don't make the dip worse and earlier in the rpm...
Forum: Forced Induction 07-04-2014, 09:36 PM
Replies: 226
Views: 60,187
Posted By fenton
That's as far as our narrow band can read. Max...

That's as far as our narrow band can read. Max resolution of the sensor.
Forum: Forced Induction 07-04-2014, 04:20 PM
Replies: 226
Views: 60,187
Posted By nlowell
Wow Shiv, these are some smooth tunes! The AFR...

Wow Shiv, these are some smooth tunes! The AFR spike under 4k is gone. I loaded the 91 tune and let the car run for a good 10-15 minutes before driving off. I don't see any knock so I bet I could...
Forum: Forced Induction 07-04-2014, 04:40 AM
Replies: 1,206
Views: 358,471
Posted By Shiv@Openflash
BAM!...

BAM! (http://www.ft86club.com/forums/showthread.php?p=1829494#post1829494)

:thumbup:
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 06-26-2014, 02:39 PM
Replies: 36
Views: 15,246
Posted By CSG David
Brake Pad Manufacturer (F/R): Winmax / Winmax ...

Brake Pad Manufacturer (F/R): Winmax / Winmax
Caliper (F/R): Stock / Stock
Rotor Size (F/R - IE OEM or specify): OEM / OEM
Compound (F/R): W4 / W4
Tires: Michelin Primacy HP 215/45/17 F/R ||...
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 06-19-2014, 11:24 AM
Replies: 9
Views: 3,107
Posted By Figo
http://img1.wikia.nocookie.net/__cb20120121210255/...

http://img1.wikia.nocookie.net/__cb20120121210255/walkingdead/images/f/fa/Hammer.jpg

Bring a hammer with you or keep it in your car.

If you see another FR-S with winjet headlight on the street,...
Forum: Scion FR-S / Toyota 86 GT86 General Forum 06-13-2014, 02:03 AM
Replies: 417
Views: 285,666
Posted By luelanski
I've had my FRS for a while now and I just...

I've had my FRS for a while now and I just discovered this hidden feature

I believe it the BRZ also has this.

Open the driver or passenger side door and lift up the latch under the seat, and...
Forum: Forced Induction 06-09-2014, 12:51 PM
Replies: 11,295
Views: 3,413,576
Posted By shif7i7down
I agree, but there are others that don't, I'll do...

I agree, but there are others that don't, I'll do roughly 3 runs from a dig at different rpm also. Maybe it'll help others with their launch. Not that i am a pro, but it might be of some use to others
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 06-05-2014, 10:07 PM
Replies: 2,548
Views: 1,736,613
Posted By Apoc
This may only register 4.0 on the meaty Richter...

This may only register 4.0 on the meaty Richter Scale but it's my meaty. Kosei K4R 17x8 with 245/40/17 Continental ExtremeContact DWs. Also lowered an inch with Bilstein B14s.
Forum: Forced Induction 05-26-2014, 01:47 AM
Replies: 221
Views: 57,405
Posted By pmccut
No problems so far. Probably only at 250wtq right...

No problems so far. Probably only at 250wtq right now though. Still the easiest and most ddable clutch.
Forum: Engine, Exhaust, Bolt-Ons 05-25-2014, 01:10 AM
Replies: 2,334
Views: 346,121
Posted By Andrew025
Stage 1 is just the flash Stage 2 UEL is...

Stage 1 is just the flash
Stage 2 UEL is catless UEL header
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 05-15-2014, 10:50 PM
Replies: 39
Views: 19,233
Posted By cycleboy
Mine are in the directory, but I'll take a closer...

Mine are in the directory, but I'll take a closer up pic tomorrow. 8.5 w/ 245's.
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 05-15-2014, 10:15 AM
Replies: 39
Views: 19,233
Posted By 5hairpins
http://www.ft86club.com/forums/showthread.php?t=64...

http://www.ft86club.com/forums/showthread.php?t=64193&highlight=axis+xcite

This is my setup, rims are 7.5 inches wide. Tires are stock size.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 04-21-2014, 08:51 PM
Replies: 0
Views: 1,218
Posted By PITTFRS
Stoptech Stainless Steel lines review

Hello everyone, over the weekend I officially installed first mod on my fr-s. As the title suggests they were stoptech SS lines (I also painted my calipers and upgraded brake fluid while I was at...
Forum: Forced Induction 03-28-2014, 05:50 PM
Replies: 55
Views: 18,700
Posted By Pure Automotive
We just finished our shop car: ...

We just finished our shop car:

http://youtu.be/ikbniJJppcQ



It's a much bigger project than you realize and it gets really expensive to do it right. If someone off the street came to me and...
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 03-21-2014, 09:38 AM
Replies: 483
Views: 348,671
Posted By choi0706
ordered it, fitment is perfect.. looks great and...

ordered it, fitment is perfect.. looks great and easy install too..

http://i140.photobucket.com/albums/r10/choi0706/Mobile%20Uploads/20140321_000309_zps1orrfezs.jpg
...
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 03-21-2014, 01:17 AM
Replies: 27
Views: 6,486
Posted By cncnjn
New shiftknob!

New Shiftknob :D What do you guys think? The leverage i get from it is awesome:)
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 03-17-2014, 03:06 PM
Replies: 2
Views: 3,394
Posted By Msnicoleeeee
I emailed them a few days ago about the above and...

I emailed them a few days ago about the above and this is what they emailed back. Hope this helps.
Forum: CANADA 03-03-2014, 02:38 PM
Replies: 2,017
Views: 456,081
Posted By Joe-G
Kinda tough to say. Most shops in town will rape...

Kinda tough to say. Most shops in town will rape you on pricing.

If anything, give Rhys a shout. He can get you almost anything you need at comparable prices to the internet. He doesn't operate...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 02-24-2014, 01:12 PM
Replies: 163
Views: 157,727
Posted By enouf
Here you go, enjoy!

Here you go, enjoy!
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 02-23-2014, 11:05 PM
Replies: 27
Views: 9,339
Posted By cycleboy
I just got A/S 3's a couple of weeks ago and so...

I just got A/S 3's a couple of weeks ago and so far I really like them. We have had nice weather w/ chilly mornings (mid-30's is chilly here!). I went up 30mm in width to 245's.

Haven't had them...
Showing results 1 to 30 of 129
Page 1 of 5 1 2345

 
Forum Jump

All times are GMT -4. The time now is 09:15 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.