follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 8 1 2345 Last »
Showing results 1 to 30 of 235
Search took 0.76 seconds. Search: Posts Made By: twag4
Forum: Engine, Exhaust, Transmission 07-22-2018, 10:18 AM
Replies: 19
Views: 4,328
Posted By twag4
And it is a one piece carbon fiber driveshaft

And it is a one piece carbon fiber driveshaft
Forum: Engine, Exhaust, Transmission 07-22-2018, 10:18 AM
Replies: 19
Views: 4,328
Posted By twag4
Yes MazWerks kit. There is really not enough room...

Yes MazWerks kit. There is really not enough room to manipulate the transmission much. The overpipe will hit either the body of th car or the sway bar. I tried to just match the original engine...
Forum: Engine, Exhaust, Transmission 07-14-2018, 06:52 PM
Replies: 10
Views: 7,288
Posted By twag4
Top is port, middle DI, and bottom is evap

Top is port, middle DI, and bottom is evap
Forum: Transmission and Driveline 07-12-2018, 11:00 PM
Replies: 13
Views: 4,299
Posted By twag4
Yeah, it was an ad on. The buyer can authenticate...

Yeah, it was an ad on. The buyer can authenticate that it was legitimate. I simply forgot about that rule. I won’t forget again.
Forum: Forced Induction 06-09-2018, 11:58 AM
Replies: 32
Views: 19,981
Posted By twag4
I didn’t read that into it at all. Just saying...

I didn’t read that into it at all. Just saying that the rods are the weak link. I don’t blame the tune quality at all. Everything within my engine was sound- except for the carnage caused by a rod...
Forum: Forced Induction 06-08-2018, 07:34 AM
Replies: 32
Views: 19,981
Posted By twag4
Delicious on ecutek

Delicious on ecutek
Forum: Forced Induction 06-08-2018, 12:45 AM
Replies: 32
Views: 19,981
Posted By twag4
If you can do flex fuel, you’ll exceed that....

If you can do flex fuel, you’ll exceed that. It’ll be less by some margin if you do 93 octane and a good header. I was a spec over 280 with that setup on 93 octane and ace header
Forum: Forced Induction 06-07-2018, 03:34 PM
Replies: 32
Views: 19,981
Posted By twag4
I’m gonna rock the boat and say no. I was on c30...

I’m gonna rock the boat and say no. I was on c30 with standard pulley, ace type a350, and flexfuel, and a rod broke at probably 2500rpm. It was massive catastrophic damage. Only one head blank could...
Forum: Engine, Exhaust, Bolt-Ons 06-07-2018, 12:15 AM
Replies: 5
Views: 1,263
Posted By twag4
Should be picking it up any time now.

Should be picking it up any time now.
Forum: Engine, Exhaust, Transmission 06-05-2018, 11:27 AM
Replies: 58
Views: 10,807
Posted By twag4
This is incorrect. The crank pulley being smaller...

This is incorrect. The crank pulley being smaller means the other components spin at lesser RPM compared to engine rpm.
Forum: Engine, Exhaust, Transmission 03-27-2018, 06:52 PM
Replies: 12
Views: 2,969
Posted By twag4
I had an ace header, JDL ultra quiet front pipe,...

I had an ace header, JDL ultra quiet front pipe, and corsa catback. It was brutally loud. Stupid loud. Insanely loud.
Forum: Engine, Exhaust, Transmission 03-22-2018, 01:41 PM
Replies: 19
Views: 5,256
Posted By twag4
Gears kicking out of a gear is normally an...

Gears kicking out of a gear is normally an excessively worn or bent shift fork.
Forum: Engine, Exhaust, Transmission 02-19-2018, 11:27 PM
Replies: 62
Views: 28,207
Posted By twag4
Some pics of the and after the installation:

Some pics of the and after the installation:
Forum: Engine, Exhaust, Transmission 02-18-2018, 02:14 PM
Replies: 62
Views: 28,207
Posted By twag4
I was seriously looking at going with a quaife...

I was seriously looking at going with a quaife sequential, but I wasn’t sure I would want to live with it using it on the street. This was a big welcome option!
Forum: Engine, Exhaust, Transmission 02-18-2018, 02:29 AM
Replies: 62
Views: 28,207
Posted By twag4
The production parts are much nicer than those...

The production parts are much nicer than those used in the photos on their site. You can see that in my photos. What you cannot see is the nice energy suspension rear mount that attaches the...
Forum: Engine, Exhaust, Transmission 02-18-2018, 02:25 AM
Replies: 62
Views: 28,207
Posted By twag4
The transmission mount in the tunnel has to be...

The transmission mount in the tunnel has to be totally modified, some of it removed. The new mounts have to be welded in place of some of the removed part of the original mounting configuration. It...
Forum: Engine, Exhaust, Transmission 02-17-2018, 11:07 PM
Replies: 62
Views: 28,207
Posted By twag4
three comparison pics:

three comparison pics:
Forum: Forced Induction 02-17-2018, 10:30 PM
Replies: 6,004
Views: 2,053,746
Posted By twag4
You will love the c30 kit! I ran it until I added...

You will love the c30 kit! I ran it until I added flex fuel tune, then blew my engine. Now I am swapping to the c38 and a different transmission. Going the full monty! I believe the c30 with standard...
Forum: Engine, Exhaust, Transmission 02-17-2018, 01:10 PM
Replies: 62
Views: 28,207
Posted By twag4
It is a brand new Nissan vq cd009 transmission....

It is a brand new Nissan vq cd009 transmission. (Same as found in last two years of 350z/g35, and 370z/g37) It is not a custom gearing setup, although aftermarket gear sets are made for it. It has...
Forum: Engine, Exhaust, Transmission 02-17-2018, 10:33 AM
Replies: 62
Views: 28,207
Posted By twag4
Just got my cd009 transmission delivered. It came...

Just got my cd009 transmission delivered. It came with a beautiful PST carbon fiber one piece driveshaft as icing on the cake. I will let you guys know how it goes in the weeks to come! Now I have to...
Forum: User/Vendor/Sponsor Reviews, Feedback, Comments 02-07-2018, 09:24 AM
Replies: 27
Views: 6,318
Posted By twag4
Yes, I was complaining!!

Yes, I was complaining!!
Forum: User/Vendor/Sponsor Reviews, Feedback, Comments 02-06-2018, 08:00 PM
Replies: 27
Views: 6,318
Posted By twag4
I just did. No matter where you go, have an...

I just did. No matter where you go, have an agreement. There, helped.
Forum: User/Vendor/Sponsor Reviews, Feedback, Comments 02-06-2018, 07:22 PM
Replies: 27
Views: 6,318
Posted By twag4
Well, I gave my word. That is important to me....

Well, I gave my word. That is important to me. I’m not screwing anyone. Make sure you have a firm agreement on a reasonable expectation of a time frame at the time you commit to doing this kind of...
Forum: User/Vendor/Sponsor Reviews, Feedback, Comments 02-06-2018, 05:50 PM
Replies: 27
Views: 6,318
Posted By twag4
If you look above, I explained why I haven’t...

If you look above, I explained why I haven’t gotten it fully installed yet. I am happy with the outcome, and I do believe quality will be there. I got some nice upgrades that they threw in for free,...
Forum: User/Vendor/Sponsor Reviews, Feedback, Comments 02-06-2018, 05:43 PM
Replies: 27
Views: 6,318
Posted By twag4
Sorry! I’ve been busy. Had surgery just after...

Sorry! I’ve been busy. Had surgery just after getting the engine, my German Shepherd died, then a dog ran into me mid corner while I was riding my motorcycle to work- got a separated right shoulder...
Forum: Engine, Exhaust, Transmission 01-15-2018, 12:20 AM
Replies: 23
Views: 3,841
Posted By twag4
I just removed the four bolts on the rear trans...

I just removed the four bolts on the rear trans mount, unbolted the front pipe hanger and a few other small things, and dropped the rear of the transmission down enough to drive it on with a rubber...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 12-16-2017, 10:58 AM
Replies: 119
Views: 94,123
Posted By twag4
I run continentals on the street, Bridgestone...

I run continentals on the street, Bridgestone RE71 autocross, and also have Hoosier R7 for a super grippy concrete autocross location and track. I only have wilwood’s BP10 and BP20 compounds for the...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 12-16-2017, 07:57 AM
Replies: 119
Views: 94,123
Posted By twag4
I have Wilwood front and rear, I honestly chose...

I have Wilwood front and rear, I honestly chose them because of price, and prior experience with Wilwood. I’ve had great luck with them. With both front and rear kits, braking is exceptional. More...
Forum: Forced Induction 11-20-2017, 11:50 PM
Replies: 6,004
Views: 2,053,746
Posted By twag4
I’m one of “that guy” ‘s! I also had/have ace...

I’m one of “that guy” ‘s! I also had/have ace type A 350 header/over pipe and full exhaust. I had no oil related failures. My #2 rod just snapped. Not one bearing in my engine was spun. I was on a...
Forum: Engine, Exhaust, Transmission 11-05-2017, 11:06 AM
Replies: 62
Views: 28,207
Posted By twag4
A new transmission option

Hopefully they will post on here, but here it is. Comes with CF drive shaft, brand new Nissan cd009 transmission, and good for 800+ hp and 800+ ft/lbs torque. All that for less than the cost of a...
Showing results 1 to 30 of 235
Page 1 of 8 1 2345 Last »

 
Forum Jump

All times are GMT -4. The time now is 06:16 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.