follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Members List Calendar Search Today's Posts Mark Forums Read

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 9 1 2345 Last »
Showing results 1 to 30 of 249
Search took 0.02 seconds. Search: Posts Made By: ILLSMOQ
Forum: Engine Swaps 11-24-2022, 07:01 PM
Replies: 172
Views: 77,882
Posted By ILLSMOQ
Sorry, I don’t get back here often lol. The car...

Sorry, I don’t get back here often lol. The car is awesome, been having a blast with it.

I usually stick to Instagram these days. @ls3brz

Since 2018 I’ve done a lot with it. Dry sump 434...
Forum: Engine Swaps 05-01-2021, 09:12 AM
Replies: 99
Views: 37,072
Posted By ILLSMOQ
You will want to insulate your exhaust as best...

You will want to insulate your exhaust as best you can particularly near the area where the aluminum flanges are joined to the carbon.

I also had a Carbon Shaft from DSS. Beautiful piece, but the...
Forum: Engine Swaps 04-21-2021, 09:58 AM
Replies: 86
Views: 23,579
Posted By ILLSMOQ
Check your throttle travel/calibration I...

Check your throttle travel/calibration

I ran into throttle issues in the beginning as well with my motec build. I discovered as I went to WOT, if I pushed the pedal harder, the floor board (where...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-08-2019, 10:20 PM
Replies: 30
Views: 10,884
Posted By ILLSMOQ
I’ll also tell you that while the 18x10 +40 is...

I’ll also tell you that while the 18x10 +40 is cool 18x9.5 +40 works a little bit better, and still fits the 285 perfectly
Forum: Engine Swaps 10-23-2019, 10:22 AM
Replies: 236
Views: 51,693
Posted By ILLSMOQ
Can you get a base map from someone that you know...

Can you get a base map from someone that you know for sure works? At least to get you close.
Forum: Engine Swaps 08-15-2019, 01:42 PM
Replies: 5
Views: 2,002
Posted By ILLSMOQ
I bought the radium filter and mount. ...

I bought the radium filter and mount. Massaged(pounded) the floorboard in under the driver seat to get it up above the lower points of the floor board. Then I made an cover/skid plate for it all...
Forum: Engine Swaps 06-18-2019, 10:20 AM
Replies: 1,305
Views: 320,108
Posted By ILLSMOQ
1500 miles lol. The engine builder said those...

1500 miles lol. The engine builder said those cracks were common and superficial on the PRC heads though. :wub:
Forum: Engine Swaps 03-04-2019, 11:06 AM
Replies: 36
Views: 12,214
Posted By ILLSMOQ
Is this a 4.125 bore 427? Square, Rectangle or...

Is this a 4.125 bore 427? Square, Rectangle or Cathedral on the heads? I’m interested to see how your build progresses. After I get the get the track day bug out of my system, I’d like to switch...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 01-16-2019, 05:37 PM
Replies: 15
Views: 5,227
Posted By ILLSMOQ
Are you just trying to go straight or do you want...

Are you just trying to go straight or do you want it to handle too?

For my street setup I run 285/30/18 re71r’s on two different sets 18x10’s and 18x9.5’s both +40. The grip on the turns is...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 01-16-2019, 12:36 PM
Replies: 2,548
Views: 1,734,045
Posted By ILLSMOQ
18x9.5 +40 would give you the same look with out...

18x9.5 +40 would give you the same look with out having to do all the extra stuff to tuck the 10’s

Here is how mine looks with 18x9.5 +40 and 285/30/19. They would poke out a touch more without...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 01-16-2019, 11:38 AM
Replies: 2,548
Views: 1,734,045
Posted By ILLSMOQ
+40:thumbup: Also needed to narrow the track...

+40:thumbup:

Also needed to narrow the track to tuck them under the fenders.

http://www.ft86club.com/forums/showthread.php?t=122384
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 12-27-2018, 07:57 PM
Replies: 2,548
Views: 1,734,045
Posted By ILLSMOQ
Different kind of meat. :burnrubber: 17x9...

Different kind of meat. :burnrubber:

17x9 +40 Konig Ultraform - clears 345mm rear brembo GT Brakes
275/40R17 Hoosier DR2

https://i.imgur.com/xgM4lFF.jpg

https://i.imgur.com/yz1oYgt.jpg
...
Forum: Northern California 12-11-2018, 12:37 PM
Replies: 0
Views: 1,470
Posted By ILLSMOQ
$200.00 for some help in San Jose

I need access to a 2017 or newer 86 to pull airbag data from the ecu.

I have an LS Swapped 2017 BRZ running a motec ecu. The Motec unit was setup using earlier 86 firmware and since the ‘17 and...
Forum: Engine Swaps 12-05-2018, 10:19 AM
Replies: 172
Views: 77,882
Posted By ILLSMOQ
Thanks! I see 6 mpg when I check the gauge lol. ...

Thanks! I see 6 mpg when I check the gauge lol. But I can’t keep my foot out of it.
Forum: Engine Swaps 10-23-2018, 01:09 PM
Replies: 172
Views: 77,882
Posted By ILLSMOQ
Tried drifting...didn’t work out so good. Not as...

Tried drifting...didn’t work out so good. Not as easy as I thought it would be.

https://youtu.be/rq4FO9kYsoo
Forum: Engine Swaps 10-22-2018, 08:11 PM
Replies: 173
Views: 56,451
Posted By ILLSMOQ
:thumbup: hahaha!

:thumbup: hahaha!
Forum: Engine Swaps 10-20-2018, 11:37 PM
Replies: 173
Views: 56,451
Posted By ILLSMOQ
Lol. Mines kinda big, makes me smile a lot :) ...

Lol. Mines kinda big, makes me smile a lot :)

https://i.imgur.com/EZqtfTe.jpg
Forum: Engine Swaps 10-18-2018, 10:39 PM
Replies: 173
Views: 56,451
Posted By ILLSMOQ
Smart move, sending it to Pure. Should save you...

Smart move, sending it to Pure. Should save you alot off headaches. Buy a new motor if you can swing it to try eliminate unknown issues with a used motor.

I have a Ford 8.8 rear, which can...
Forum: Engine Swaps 10-17-2018, 12:03 AM
Replies: 216
Views: 177,819
Posted By ILLSMOQ
Whatch the other bolts in the tunnel too, parking...

Whatch the other bolts in the tunnel too, parking brake etc.
Forum: Engine Swaps 10-16-2018, 10:47 PM
Replies: 172
Views: 77,882
Posted By ILLSMOQ
Engine was heating up during extended aggressive...

Engine was heating up during extended aggressive backroads driving on 90 degree+ days. Worked on some ducting to get more air through the radiator.

Had the engine cooler mounted to the factory...
Forum: Engine Swaps 10-15-2018, 02:36 PM
Replies: 22
Views: 10,877
Posted By ILLSMOQ
Let’s see it!

Let’s see it!
Forum: Engine Swaps 09-25-2018, 06:08 PM
Replies: 186
Views: 87,065
Posted By ILLSMOQ
Definitely a keeper! Awesome build, even more...

Definitely a keeper! Awesome build, even more awesome when your girl is in it with you!

My wife made our whole little family shirts haha. :thumbup:

https://i.imgur.com/bbpzQ3I.jpg
Forum: Engine Swaps 09-21-2018, 02:42 PM
Replies: 9
Views: 4,242
Posted By ILLSMOQ
I have the full blown rad and fan shroud kit. ...

I have the full blown rad and fan shroud kit. 900 cfm fans were not up to the job. I upgraded to the 1300 cfm fans and it does great except for extended aggressive back roads driving where after...
Forum: Engine Swaps 09-19-2018, 12:31 PM
Replies: 1,305
Views: 320,108
Posted By ILLSMOQ
You know, mine (same motor as Dustin) used to be...

You know, mine (same motor as Dustin) used to be loud and I also was uncomfortable with the noise but it has since quieted down...I used the “drive it like I stole it” method to break it in.
Forum: Engine Swaps 09-13-2018, 10:18 PM
Replies: 172
Views: 77,882
Posted By ILLSMOQ
https://youtu.be/8SCv0UukKec I’ll leave this...

https://youtu.be/8SCv0UukKec

I’ll leave this here.
Forum: Engine Swaps 09-13-2018, 10:01 PM
Replies: 42
Views: 11,891
Posted By ILLSMOQ
https://www.summitracing.com/parts/ear-at165010erl...

https://www.summitracing.com/parts/ear-at165010erl/overview/

I used those and AN’d the whole thing
Forum: Engine Swaps 09-13-2018, 09:22 PM
Replies: 4
Views: 2,191
Posted By ILLSMOQ
What Sports guy said. Pure automotive motec

What Sports guy said. Pure automotive motec
Forum: Engine Swaps 09-07-2018, 11:46 AM
Replies: 181
Views: 53,001
Posted By ILLSMOQ
Awesome stuff, for being a busy shop and...

Awesome stuff, for being a busy shop and developing these different swaps, you doing a great job covering all the bases. Keep it up! And thanks!
Forum: Engine Swaps 08-14-2018, 10:50 AM
Replies: 236
Views: 51,693
Posted By ILLSMOQ
Big difference between stacked plate and tube and...

Big difference between stacked plate and tube and fin. Get the stacked plate cooler.
Forum: Engine Swaps 07-30-2018, 04:45 PM
Replies: 23
Views: 6,750
Posted By ILLSMOQ
If you’re going motec, regardless of the motor,...

If you’re going motec, regardless of the motor, with the amount of tuning required after the swap is completed, shipping your car to Pure to have them do everything will save you lots money in the...
Showing results 1 to 30 of 249
Page 1 of 9 1 2345 Last »

 
Forum Jump

All times are GMT -4. The time now is 02:20 PM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.