follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.75 seconds. Search: Posts Made By: Dipstik-sportech
Forum: Forced Induction 07-29-2017, 04:46 PM
Replies: 1,372
Views: 389,462
Posted By xwd
I'm hoping to make 425-450WHP on E85-R using the...

I'm hoping to make 425-450WHP on E85-R using the TRD S/C, which also has the TVS1320. It has a larger throttle body, snout, and plenum than the Edelbrock/Harrop kits so the airflow is probably a...
Forum: Forced Induction 08-20-2016, 11:55 PM
Replies: 218
Views: 46,070
Posted By CSG Mike
Since you obviously don't get it, let me just...

Since you obviously don't get it, let me just tell you.

I can increase boost by heating up the air. That increased boost still did not increase the mass of air going into the engine.

I get...
Forum: Forced Induction 08-20-2016, 11:53 PM
Replies: 218
Views: 46,070
Posted By CSG Mike
Let me sell you a blowtorch.

Let me sell you a blowtorch.
Forum: Forced Induction 08-20-2016, 02:19 PM
Replies: 218
Views: 46,070
Posted By cdrazic93
oh sweet jesus, lots of juicy ban material I...

oh sweet jesus, lots of juicy ban material I hope. This is great! very entertaining :D :popcorn:
Forum: Forced Induction 08-19-2016, 08:30 PM
Replies: 218
Views: 46,070
Posted By CSG Mike
Your prowess as an engineer is made apparent by...

Your prowess as an engineer is made apparent by your overabundance of speculation paired with sore lack of results.

As I've previously said, I'll gladly eat my words if you can provide a proof of...
Forum: Forced Induction 08-19-2016, 06:28 PM
Replies: 218
Views: 46,070
Posted By Toyarzee
Your prowess as an engineer is very apparent with...

Your prowess as an engineer is very apparent with your technical discussion of cock sucking



Uh.... you sure?



Honestly, monkey math was putting it nicely. You promised to stop posting btw
Forum: Forced Induction 08-19-2016, 05:42 PM
Replies: 218
Views: 46,070
Posted By weederr33
Come at me, bro!

Come at me, bro!
Forum: Forced Induction 08-19-2016, 03:54 AM
Replies: 218
Views: 46,070
Posted By Sargy
This thread is epic. I need more monkey math. ...

This thread is epic. I need more monkey math.

Aside from that very useful info. Wish I had the money to endure a project like this.
Forum: Forced Induction 08-19-2016, 12:09 AM
Replies: 218
Views: 46,070
Posted By EAGLE5
https://s-media-cache-ak0.pinimg.com/564x/86/e1/e5...

https://s-media-cache-ak0.pinimg.com/564x/86/e1/e5/86e1e51b3a589c01235a73fe015fe1ca.jpg
Forum: Forced Induction 08-18-2016, 11:53 PM
Replies: 218
Views: 46,070
Posted By FRS Justin
here is some useless info but interesting ...

here is some useless info but interesting


Here are the ten most powerful ones on the market today :
2015 Mercedes-Benz GLA 45 AMG...
Forum: Forced Induction 08-18-2016, 11:51 PM
Replies: 218
Views: 46,070
Posted By Spartarus
Ok, you learned to look at a compressor map,...

Ok, you learned to look at a compressor map, swallowed a blue pill, and woke up in the matrix.

You don't know kung fu.

Stop.

Yes, compound boost is an interesting topic, but you need to be...
Forum: Forced Induction 08-18-2016, 11:01 PM
Replies: 218
Views: 46,070
Posted By CSG Mike
One day, you'll realize that this whole post is...

One day, you'll realize that this whole post is monkey math.

I recommend you revisit high school chemistry and study some gas law. Then, take some upper division collegiate level fluid dynamics...
Forum: Forced Induction 08-18-2016, 06:32 PM
Replies: 218
Views: 46,070
Posted By CSG Mike
I don't even know why you keep bringing up psi...

I don't even know why you keep bringing up psi when you're already measuring the air by mass... psi is irrelevant, relatively speaking, if you know how much air mass is going into the engine.

I'd...
Forum: Forced Induction 08-18-2016, 03:50 PM
Replies: 218
Views: 46,070
Posted By CSG Mike
The monkey math is in the part where you think...

The monkey math is in the part where you think 500hp at 3800rpm is possible. That's nearly 700 lb/ft of torque.

There are no existing components for the FA20 that can even handle that sort of...
Forum: Member's Car Journals 05-18-2015, 02:04 AM
Replies: 43
Views: 19,115
Posted By #maverick#
So I got my car tuned a few weeks ago at FBM. ...

So I got my car tuned a few weeks ago at FBM.

I made around 400 on e60 with conservative timing at the recommendation of LJ to help preserve my motor as long as possible. LJ @FullBlown is a hell...
Forum: Engine, Exhaust, Transmission 05-14-2015, 03:00 PM
Replies: 26
Views: 12,633
Posted By wparsons
If the EBC relies on a vacuum line and that line...

If the EBC relies on a vacuum line and that line pops off it's no help either.

You would need the EBC to be totally controlled by the ECU using the MAP sensor to avoid that.
Forum: Engine, Exhaust, Transmission 05-14-2015, 07:04 AM
Replies: 26
Views: 12,633
Posted By wparsons
And yet you didn't go to them to talk about the...

And yet you didn't go to them to talk about the "bad tune", instead you just made a post blaming their tune for your engine blowing. Even though a vacuum line popping off isn't the fault of the tune...
Forum: Engine, Exhaust, Transmission 05-10-2015, 06:03 PM
Replies: 26
Views: 12,633
Posted By stugray
:iono: Didnt I actually mention that BEFORE...

:iono:

Didnt I actually mention that BEFORE you threw a rod?

Knock, Knock!

Who's there?

A ROD!!!
Forum: Engine, Exhaust, Transmission 05-09-2015, 12:18 PM
Replies: 45
Views: 12,483
Posted By sw20kosh
Why did OP go with Crawford? NO one on this forum...

Why did OP go with Crawford? NO one on this forum recommends Crawford...
Forum: Forced Induction 05-08-2015, 10:20 PM
Replies: 255
Views: 106,052
Posted By Decay107
http://i0.kym-cdn.com/photos/images/newsfeed/000/1...

http://i0.kym-cdn.com/photos/images/newsfeed/000/131/351/eb6.jpg?1307463786

Looks basically OEM to me. :wub:
Forum: Engine, Exhaust, Transmission 05-08-2015, 04:35 PM
Replies: 29
Views: 9,396
Posted By King Tut
Wait so OP first found weird things in his catch...

Wait so OP first found weird things in his catch can to include what looked like fuel, then he blew a headgasket and found oil in his coolant, then he proceeded to window the block. I just want to...
Forum: Engine, Exhaust, Transmission 05-08-2015, 04:26 PM
Replies: 45
Views: 12,483
Posted By King Tut
OP windowed his block. No need to worry about...

OP windowed his block. No need to worry about his cams any longer.
Forum: CANADA 04-27-2015, 12:07 PM
Replies: 32
Views: 9,790
Posted By wparsons
He's not entirely wrong though... :D

He's not entirely wrong though... :D
Forum: CANADA 04-26-2015, 11:09 AM
Replies: 32
Views: 9,790
Posted By D_Thissen
Ahahahaha.. Smart ass

Ahahahaha.. Smart ass
Forum: Engine, Exhaust, Transmission 04-24-2015, 02:52 PM
Replies: 73
Views: 24,220
Posted By Kostamojen
Ressearch first, ask questions second. Then you...

Ressearch first, ask questions second. Then you won't be treated like an idiot on the internet.
Forum: BRZ First-Gen (2012+) -- General Topics 04-20-2015, 07:54 PM
Replies: 85
Views: 28,225
Posted By Tcoat
That "article" doesn't confirm shit! Yet another...

That "article" doesn't confirm shit! Yet another click bait blog quoting another click bait blog that the over eager want to believe. They just took some parts of quotes on the New York concept and...
Forum: Great Lakes 04-18-2015, 05:02 PM
Replies: 4,441
Views: 822,792
Posted By jdnguyen
Awesome numbers! Congrats! Sent from my...

Awesome numbers! Congrats!


Sent from my iPhone using Tapatalk
Forum: Great Lakes 04-18-2015, 04:59 PM
Replies: 4,441
Views: 822,792
Posted By Gopherboy6956
Tuning all finished yesterday at FBM. Ended at...

Tuning all finished yesterday at FBM. Ended at 276hp / 199tq.

Baseline with Perrin e-Tune was 234hp / 181tq

Only main mods are Vortech Kit (stayed with original pulley) P&L header, Over, Front...
Forum: Engine Swaps 04-16-2015, 07:40 PM
Replies: 749
Views: 305,960
Posted By cdrazic93
im with Brian

im with Brian
Forum: BRZ First-Gen (2012+) -- General Topics 04-14-2015, 07:08 PM
Replies: 166
Views: 121,294
Posted By Poodles
Why are you comparing to a kit that hasn't really...

Why are you comparing to a kit that hasn't really been proven while there are kits out there that have already been proven for FAR cheaper?

Not to mention DI only engines are known for being...
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -4. The time now is 11:32 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.