follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Members List Calendar Search Today's Posts Mark Forums Read

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 30 of 500
Search took 2.73 seconds.
Search: Posts Made By: ILLSMOQ
Forum: Engine Swaps 07-31-2021, 05:50 PM
Replies: 86
Views: 23,576
Posted By kask2_6.0
Needed a new project... LS3 soon!

Finally got around to fitting the strut braces. Had to make brackets to offset the firewall side of the oem braces up about 1” to clear the coils. With different coil mounting locations this wouldn’t...
Forum: Engine Swaps 05-10-2021, 12:22 PM
Replies: 86
Views: 23,576
Posted By kask2_6.0
The hose clamps are gates power grip heat shrink...

The hose clamps are gates power grip heat shrink clamps: https://www.summitracing.com/parts/aaf-all30257 They work pretty well as they have very wide clamping area and uniform clamping forces. Can...
Forum: Engine Swaps 05-10-2021, 01:00 AM
Replies: 86
Views: 23,576
Posted By kask2_6.0
I haven’t had any overheating problems but just...

I haven’t had any overheating problems but just preparing for sitting in traffic in 90+ degree temps. Made some new mounts and swapped out my slim fans for high output units. With the fans being...
Forum: Engine Swaps 03-29-2021, 12:56 AM
Replies: 86
Views: 23,576
Posted By kask2_6.0
https://uploads.tapatalk-cdn.com/20210329/b23dbb87...

https://uploads.tapatalk-cdn.com/20210329/b23dbb87cbc985bc553d0aab8b370cfe.jpg


Sent from my iPhone using Tapatalk
Forum: Engine Swaps 02-01-2021, 07:41 AM
Replies: 87
Views: 11,185
Posted By Clash0901
I've been running this setup for a year now....

I've been running this setup for a year now. Short of some occasional big bumps, it doesn't really rub. And if it does, it just hits the rear bumper corner where the bumper mounts to the body near...
Forum: Engine Swaps 01-25-2021, 03:08 PM
Replies: 87
Views: 11,185
Posted By pope
An incomplete and mildly facetious list of...

An incomplete and mildly facetious list of possible solutions in increasing order of cost/complexity:


Turn down the boost until the tires can handle it. Numbers on paper are just bench racing...
Forum: Engine Swaps 12-01-2020, 01:04 PM
Replies: 86
Views: 23,576
Posted By DustinS
Really amazing work. Excited to see more.

Really amazing work. Excited to see more.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-10-2019, 11:48 PM
Replies: 30
Views: 10,883
Posted By pgranberg11
thanks I'll give you a follow! and I currently...

thanks I'll give you a follow! and I currently have 9.5 rpf1s, and 285 on a 9.5 is too much bulge for me. I won't be able to take advantage of the full contact patch on 9.5 with a 285. It's good to...
Forum: Engine Swaps 10-04-2019, 09:24 AM
Replies: 1,305
Views: 320,066
Posted By DustinS
Well I think the Turbo build has commenced. Turbo...

Well I think the Turbo build has commenced. Turbo manifolds are on their way ($95 on eBay right now with good reviews lol)

Waiting to hear back on a friend of mine who recently started selling...
Forum: Engine Swaps 08-30-2019, 12:25 AM
Replies: 173
Views: 56,446
Posted By GrabTheWheel
I got the 17' bumper swap done, as well as...

I got the 17' bumper swap done, as well as mustache delete, JDL bumper bar and adding some ducting to the radiator. Not as good of a ducting job as I would of liked but without relocating some oil...
Forum: Engine Swaps 08-20-2019, 11:53 AM
Replies: 173
Views: 56,446
Posted By GrabTheWheel
I averaged 9-10 MPG in my stock ZL1. So I’m...

I averaged 9-10 MPG in my stock ZL1. So I’m already 25% plus more efficient than that. Combination of having a cam, having a heavy right foot with lots of empty country roads and most importantly is...
Forum: Engine Swaps 08-11-2019, 10:25 PM
Replies: 173
Views: 56,446
Posted By GrabTheWheel
Here is a vid from my 2nd AutoX event since the...

Here is a vid from my 2nd AutoX event since the swap. Also my first event on Hoosier A7 tires. At the last event the car was pushing in a way I hadn't felt before. The only other changes (aside from...
Forum: Engine Swaps 08-11-2019, 12:07 AM
Replies: 19
Views: 9,082
Posted By Stevemode
FBM drag car to 2JZ/CD009/FuelTech skreet car build

In 2014 I drove the Full Blown Motorsports R&D car during its FA20 engine development where we took it to the (once upon a time) FA20 record of 10.34.
After all the FA20 FBM parts were made...
Forum: Engine Swaps 07-05-2019, 08:07 AM
Replies: 36
Views: 12,214
Posted By ta7akum
So here we come back again.. Project slow...

So here we come back again..
Project slow down a bit.. but it's still moving..
We got the mounts for the gear and engine done ..
Rear is ready
And just started the turbo kit .
We used a 6.0L...
Forum: Engine Swaps 04-28-2019, 05:37 PM
Replies: 216
Views: 177,797
Posted By spitsnaugle
Video from Autocross: ...

Video from Autocross:
https://www.youtube.com/watch?v=oD94-MLDQW0[

"OMG this thing a freaking riot" from the passenger on that last pass :burnrubber:
Forum: Engine Swaps 04-17-2019, 09:45 AM
Replies: 1,305
Views: 320,066
Posted By DustinS
Got a decent amount done last night. Crank...

Got a decent amount done last night. Crank Scraper and windage tray (which needed a bit of work to fit with the Sikky Pan.

https://live.staticflickr.com/65535/40662811933_a27fc13bc0_c.jpg
...
Forum: Engine Swaps 04-16-2019, 12:49 AM
Replies: 1,305
Views: 320,066
Posted By DustinS
I ended up cutting a slot in the heads with an...

I ended up cutting a slot in the heads with an angle grinder, heating it up with a torch, and hitting it with an impact driver and it came out. Replacing with some ARP bolts with anti seize.

Got...
Forum: Engine Swaps 04-03-2019, 11:00 PM
Replies: 173
Views: 56,446
Posted By GrabTheWheel
440 WHP with conservative tune on pump gas,...

440 WHP with conservative tune on pump gas, coming to terrorize your streets and local racetrack very soon!

E85 numbers coming soon...
...
Forum: Engine Swaps 04-03-2019, 02:53 PM
Replies: 1,305
Views: 320,066
Posted By DustinS
Engine is ready to come out. Ran out of time last...

Engine is ready to come out. Ran out of time last night.

https://live.staticflickr.com/7905/46807145174_f63ddcc059_c.jpg

I don't think my current catch can is enough. Going to try and figure...
Forum: Engine Swaps 03-30-2019, 07:06 PM
Replies: 236
Views: 51,682
Posted By Ashikabi
Mounted transmission and MGW short...

Mounted transmission and MGW short shifterhttps://uploads.tapatalk-cdn.com/20190330/7e0d988a09bf4af34a383406488b39fa.jpg
Forum: Engine Swaps 03-13-2019, 03:15 PM
Replies: 173
Views: 56,446
Posted By spitfire481
T56 Magnum XL with MGW shifter and Raceseng...

T56 Magnum XL with MGW shifter and Raceseng Circuitsphere extended knob:

https://farm8.staticflickr.com/7828/32428973837_3544ee248d_c.jpg (https://flic.kr/p/RpCY7z)Untitled...
Forum: Engine Swaps 03-03-2019, 12:26 PM
Replies: 36
Views: 12,214
This is probably his 10th side hobby project lol,...

This is probably his 10th side hobby project lol, something to do on tuesday evenings
Forum: Engine Swaps 03-03-2019, 12:13 PM
Replies: 36
Views: 12,214
Posted By Trust86
Dudes from Dubai. Y’all laughing, guy wipes his...

Dudes from Dubai. Y’all laughing, guy wipes his ass with 100s lol
Forum: Engine Swaps 02-27-2019, 01:06 PM
Replies: 173
Views: 56,446
Posted By GrabTheWheel
Surge tank anyone?

Surge tank anyone?
Forum: Engine Swaps 02-20-2019, 10:18 AM
Replies: 1,305
Views: 320,066
Posted By DustinS
New Radiator Came in: ...

New Radiator Came in:

https://farm8.staticflickr.com/7884/46433183414_4d4b8336b9_c.jpg

https://farm8.staticflickr.com/7806/46433182834_76d8f068ca_c.jpg
...
Forum: Engine Swaps 02-08-2019, 01:54 PM
Replies: 23
Views: 26,705
Posted By Clash0901
You're on the forum you need to be so that's a...

You're on the forum you need to be so that's a good start. There are quite a few good threads here with pictures and instructions. Contact Pure Automotive Performance for the best parts.

Also,...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 01-16-2019, 07:13 PM
Replies: 15
Views: 5,227
Posted By brz11b
I just stalked your threads and your car is...

I just stalked your threads and your car is insane man. I love it.

Ok i will have to look into it. I have never been good with tires, this is the fastest cars I've owned right now so I've never...
Forum: Engine Swaps 01-14-2019, 02:03 AM
Replies: 207
Views: 82,720
Posted By kurty85
Got the intercooler and piping in. Need to weld...

Got the intercooler and piping in. Need to weld one pipe to the throttle body piping and put the clamps on. Next i need to put the new balancer on, belt, and remove all piping to make beaded ends on....
Forum: Engine Swaps 12-22-2018, 09:45 PM
Replies: 19
Views: 5,476
Posted By vijay.dy06
Got everything installed and fired up and running...

Got everything installed and fired up and running Dec 18th. As I'm now I'm just trying to street tune the car. I have 2 leaks; 1 at the tail shaft and 1 at the oil pan sensor ports. Will fix those...
Forum: Engine Swaps 12-17-2018, 02:36 AM
Replies: 207
Views: 82,720
Posted By kurty85
Got the headers back and test fitted everything....

Got the headers back and test fitted everything. Already knew i am going to have to make a raised portion of the hood but i am ok with that. Everything else fit pretty well with exception of one...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -4. The time now is 08:48 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.