follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 2 1 2
Showing results 1 to 30 of 31
Search took 3.00 seconds. Search: Posts Made By: d1ck
Forum: Engine Swaps 12-19-2014, 05:51 PM
Replies: 49
Views: 21,087
Posted By Manji
Thinking of doing an engine swap? Read here first.

.
For Someonewhoisntme
Forum: Software Tuning 08-14-2014, 02:08 AM
Replies: 1,062
Views: 330,201
Posted By clintavo
It has been fully warm each time it happened. I...

It has been fully warm each time it happened. I don't floor it at low rpm as a matter of course, but every once in a while, a situation calls for it; no time for a clutch pop when you're about to be...
Forum: Software Tuning 08-05-2014, 08:37 AM
Replies: 1,088
Views: 445,699
Posted By steve99
New Stock ROMs for Japanese BRZ/86 attached to...

New Stock ROMs for Japanese BRZ/86 attached to Original post
ZA1JA02A
ZA1JA02B

Europe/Australia/South Africa

ZA1JD00G

USA/Canada
Forum: Tracking / Autocross / HPDE / Drifting 07-21-2014, 11:15 AM
Replies: 25
Views: 5,069
Posted By SubiePig
That is a 75% increase in front roll stiffness...

That is a 75% increase in front roll stiffness and none in the rear so the car will be a bit pushy. I ran the same setup, on RS3's, for a while this season and it was not fun to drive. I run an 18mm...
Forum: Tracking / Autocross / HPDE / Drifting 07-21-2014, 10:28 AM
Replies: 25
Views: 5,069
Posted By DarkSunrise
As these guys have said, stock front bar and/or...

As these guys have said, stock front bar and/or zero rear toe would be the easiest places to start.
Forum: Tracking / Autocross / HPDE / Drifting 07-21-2014, 10:16 AM
Replies: 25
Views: 5,069
Posted By wparsons
Why so much rear toe in? Before swapping out...

Why so much rear toe in? Before swapping out parts I'd zero the rear toe and see if that helps enough. If not, you'll either need more rear spring rate or a softer front bar (stock?).
Forum: Tracking / Autocross / HPDE / Drifting 07-21-2014, 10:11 AM
Replies: 25
Views: 5,069
Posted By Racecomp Engineering
Stiffer front rates with a big front bar can do...

Stiffer front rates with a big front bar can do that. Is it adjustable? Putting that back to stock or increasing your rear rates (if you must have that extra roll stiffness). I'd probably lean...
Forum: Software Tuning 07-09-2014, 06:14 PM
Replies: 37
Views: 22,565
Posted By Td-d
Try this: FFF8DBD0 Ram_Fuel_Air_Commanded

Try this:

FFF8DBD0 Ram_Fuel_Air_Commanded
Forum: Software Tuning 06-13-2014, 05:33 PM
Replies: 9
Views: 4,914
Posted By Kodename47
Yes

Yes
Forum: Software Tuning 06-11-2014, 09:37 PM
Replies: 9
Views: 4,914
Posted By ML
Yes, I've done it and it works perfect

Yes, I've done it and it works perfect
Forum: Software Tuning 06-10-2014, 01:19 PM
Replies: 9
Views: 4,914
Posted By Kodename47
Yes. Most people who edit maps on the OFT...

Yes. Most people who edit maps on the OFT platform use RomRaider. RomRaider is just a map editing tool. I'd suggest vgi's java tool for viewing log stats and MAF scaling.
Forum: Engine, Exhaust, Transmission 03-12-2014, 10:32 AM
Replies: 799
Views: 317,968
Posted By ATL BRZ
After searching the internet far and wide, I've...

After searching the internet far and wide, I've finally found a picture of one of the Crawford Billet Power Blocks

Behold:

http://blog.thingm.com/wp-content/uploads/2011/04/companion_cube1.jpg
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 03-11-2014, 04:27 AM
Replies: 7
Views: 1,847
Posted By SilverSkyline210
i've tried at work, doesnt fit at all

i've tried at work, doesnt fit at all
Forum: Forced Induction 01-16-2014, 10:59 AM
Replies: 281
Views: 296,167
Posted By tendogy
Hello all. I made these charts and have been...

Hello all. I made these charts and have been waiting for my account to activate so I could pop in and say hello.

First of all, thank you CSG_Mike for posting them here. This forum is the...
Forum: Forced Induction 01-14-2014, 11:52 AM
Replies: 281
Views: 296,167
Posted By CSG Mike
Supercharger Comparison: Innovate, Jackson, Kraftwerks, Vortech *Updated March 9 2014

I take no credit for these; all data compiled by @tendogy (http://www.ft86club.com/forums/member.php?u=70170)

http://imgur.com/a/F4D7w
*edit*

Source dynos:

Innovate Intercooled...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 12-16-2013, 04:31 PM
Replies: 11
Views: 9,682
Posted By Captain Snooze
I like the idea. Though if you were going to the...

I like the idea. Though if you were going to the trouble of fitting them you should get the camo ones so that if anyone was intent of stealing your struts/coilovers they wouldn't be able to find them.
Forum: Engine, Exhaust, Transmission 11-20-2013, 02:46 AM
Replies: 95
Views: 27,413
Posted By Captain Snooze
.

.
Forum: Engine, Exhaust, Transmission 11-19-2013, 03:23 PM
Replies: 95
Views: 27,413
Posted By Captain Snooze
.

.
Forum: Forced Induction 08-14-2013, 05:04 PM
Replies: 576
Views: 227,146
Posted By Foobar
While the flex fuel kit has been known to have...

While the flex fuel kit has been known to have fitment issues and subsequent fuel leaks, until the investigators come out with their findings, nobody can really be blamed as the source of the fire.
...
Forum: Forced Induction 08-14-2013, 04:46 PM
Replies: 576
Views: 227,146
Posted By Nightbringer
I will agree that the recent behavior/responses...

I will agree that the recent behavior/responses in regards to this situation have been unnerving, but I think it's premature to commence a witch hunt. This situation is truly demoralizing, and if the...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 07-10-2013, 08:41 PM
Replies: 39
Views: 13,752
Posted By DarrenDriven
What it takes to update the Wheel Directory

Hey guys, for some reason I thought it might be interesting to show you what it takes to update the Wheel Directory. It's BORING. :)

Updating the FT86 Wheel Directory - YouTube
Forum: Forced Induction 06-20-2013, 05:13 PM
Replies: 1,191
Views: 292,863
Posted By Anaxilus
A positive displacement supercharger should be...

A positive displacement supercharger should be much easier to calculate than any turbo rig. The prior posts make good points but I think some of you might be over thinking it in this case. I'd say...
Forum: BRZ First-Gen (2012+) -- General Topics 05-01-2013, 11:20 AM
Replies: 91
Views: 133,758
Posted By Trap63
Arrow BRZ Subaru 2013 Service Manual [Full Download]

http://www.ft86club.com/forums/third/car3.png (http://www.ft86club.com)
FT86CLUB Homepage Featured Story (http://www.ft86club.com)



Hi, dear all!

I am a newbie...coming from Italy and...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 04-30-2013, 01:29 AM
Replies: 60
Views: 33,545
Posted By Jenson May
Per requested I had the chance to dyno a BRZ /...

Per requested I had the chance to dyno a BRZ / FT86 shock after work.

Here is a PVP graph of a front shock (500 series). The red line represents jet open or full soft and the green line...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 04-08-2013, 08:55 PM
Replies: 15
Views: 8,489
Posted By Racecomp Engineering
The trick is this: When reinstalling the top...

The trick is this:

When reinstalling the top nut in the rear the best way to prevent the shaft from spinning is to put a LONG screw driver thru the bottom eyelet of the shock. Have a friend(...
Forum: Forced Induction 02-27-2013, 04:55 PM
Replies: 1,987
Views: 676,716
Posted By connor_lol
posted not sure if this is on here yet?? ...

posted
not sure if this is on here yet??

Visconti ran this dyno pull on his youtube channel .. WOW

Innovate SuperCharge - YouTube
Forum: Engine, Exhaust, Transmission 02-03-2013, 07:24 PM
Replies: 872
Views: 577,686
Posted By andreyiv
Torque Oil Temperature PID

Hey guys,

I found the Oil Temperature PID using TorqueScan and verified it by driving, as well as heating up only the oil temperature sensor area with the engine cold (and not running).

Without...
Forum: Engine, Exhaust, Transmission 11-11-2012, 11:24 PM
Replies: 123
Views: 51,754
Posted By zooki
Depends on how fast your talking about. I had a...

Depends on how fast your talking about. I had a ram air setup on my Mustang, with a scoop that bolted under the leading edge of the bumper. I hooked a U tube manometer up to the airbox, and at 100...
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 10-29-2012, 01:04 AM
Replies: 37
Views: 10,495
Posted By TuxedoCartman
Hate. Really, really hate. Can't stand seeing...

Hate. Really, really hate. Can't stand seeing these used on the road, as they're painful to look at. No, really, I've let people running these pass me before, and flipped my brights on, I hate...
Forum: Cosmetic Modification (Interior/Exterior/Lighting) 10-12-2012, 12:02 AM
Replies: 39
Views: 27,050
Posted By Pete156
Tinted lights are Unsafe and illegal

Call me old fashioned, call me a safety nut.


Tinting headlights and tinting tail lights may look cool, but it is unsafe. FMVSS ( federal motor vehicle safety standards) stipulate that headlights...
Showing results 1 to 30 of 31
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -4. The time now is 04:21 PM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.