follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 2 1 2
Showing results 1 to 30 of 42
Search took 1.33 seconds. Search: Posts Made By: Bodalenko
Forum: Forced Induction 10-08-2022, 04:44 AM
Replies: 1,372
Views: 389,408
Posted By grumpysnapper
I changed my plugs about 2000km ago as a belts...

I changed my plugs about 2000km ago as a belts and braces thing when I put in new Ignition Projects coil packs.
Just used the recommended OEM plugs, and they are fine.

I use the dual Radium kit...
Forum: Engine, Exhaust, Transmission 09-03-2021, 07:43 PM
Replies: 6
Views: 1,203
Posted By StraightOuttaCanadaEh
With any aftermarket driveshaft, diff and...

With any aftermarket driveshaft, diff and subframe bushings cause a change in pinion angle and vibration at around 80 mph. Stock cars don't seem to have this issue.
Forum: Forced Induction 02-15-2021, 08:29 PM
Replies: 1,372
Views: 389,408
Posted By CSG Mike
low speeds or low load? At very low load,...

low speeds or low load?

At very low load, all the driving is on DI.

The moment where it transitions to DI + PI, with minimal PI, is when the 1050X really shines.
Forum: Forced Induction 01-23-2021, 12:16 AM
Replies: 1,372
Views: 389,408
Posted By Irace86.2.0
I suppose, but the ports could be off or mixed...

I suppose, but the ports could be off or mixed with the direct injectors in a way where, when they are at short pulses, they are contributing just a fraction of the total fuel quantity.

It is...
Forum: Forced Induction 01-22-2021, 09:06 PM
Replies: 1,372
Views: 389,408
Posted By Irace86.2.0
I don't have experience with this, but I would...

I don't have experience with this, but I would imagine it would depend on the tuner as well. For instance, DW700s could be worse at low load like Mike said, but if the tuner doesn't use them that...
Forum: Forced Induction 01-10-2021, 01:06 AM
Replies: 1,372
Views: 389,408
Posted By Irace86.2.0
He was referring to oil and blowby gases getting...

He was referring to oil and blowby gases getting into the supercharger and getting trapped in the heat exchangers. The Harrop kit routes the PCV to the front of the supercharger, so there will be oil...
Forum: Forced Induction 07-07-2020, 11:49 AM
Replies: 1,372
Views: 389,408
Posted By Irace86.2.0
It was aesthetics. I routed them under the...

It was aesthetics. I routed them under the supercharger to the back then they follow the same path as the Edelbrock kit. I also mounted the coolant pump next to my battery to better position the pump...
Forum: Forced Induction 06-27-2020, 06:32 AM
Replies: 1,372
Views: 389,408
Posted By grumpysnapper
I just went with the alloy Whiteline, but had it...

I just went with the alloy Whiteline, but had it powder coated black. Plenty of room for the Harrop.
But as was pointed out above, the existing diagonal braces do the real work...and the strut brace...
Forum: Forced Induction 06-26-2020, 10:29 PM
Replies: 1,372
Views: 389,408
Posted By Kiske
Here is Sti's sales pitch on their flexible bars....

Here is Sti's sales pitch on their flexible bars. The tS BRZ models also include flexible V-braces.
https://www.sti.jp/en/parts/feature/flexibletowerbar.html
Forum: Forced Induction 06-25-2020, 09:09 AM
Replies: 1,372
Views: 389,408
Posted By Irace86.2.0
STI is suppose to be best but whatever you like....

STI is suppose to be best but whatever you like. They are cosmetic with a little effect.
Forum: Forced Induction 06-23-2020, 07:59 PM
Replies: 1,372
Views: 389,408
Posted By Kiske
Tanabe/Revell make a dual before/after temp gauge...

Tanabe/Revell make a dual before/after temp gauge for iat. It includes 2 bungs. You could tap the blower runner and intake piping to get a live before and after air temps.



There are quote a...
Forum: Forced Induction 06-21-2020, 08:33 PM
Replies: 1,372
Views: 389,408
Posted By grumpysnapper
Just to be clear I have had zero vibration...

Just to be clear I have had zero vibration problems with either the alloy or carbon driveshafts, they have both functioned perfectly. Noise transfer has been the complicating factor.

During many...
Forum: Forced Induction 06-18-2020, 11:16 PM
Replies: 1,372
Views: 389,408
Posted By 86TOYO2k17
Bodalenko My zeitronix FF kit is only wired to...

Bodalenko
My zeitronix FF kit is only wired to the rear o2 plug in, and one extra wire to a ground.
Forum: Forced Induction 06-18-2020, 11:10 PM
Replies: 1,372
Views: 389,408
Posted By 86TOYO2k17
Bodalenko Zero added NVH with my DSS carbon...

Bodalenko
Zero added NVH with my DSS carbon fiber DS, both before and after engine mounts, trans insert, rear diff inserts, na, and fi.

I think i did fluidampr crank pulley at same time. As well...
Forum: AUSTRALIA 08-28-2019, 08:59 PM
Replies: 22
Views: 6,379
Posted By fuddbutter
They suggested the exeedy, offered me that or the...

They suggested the exeedy, offered me that or the stock, it was not much more than stock so thought i'd go with it.
I could have gotten away with not changing it, my throwout bearing had collapsed,...
Forum: Issues | Warranty | Recalls / TSB 07-15-2019, 07:08 PM
Replies: 21
Views: 4,677
Posted By solidONE
Appreciate the input. I keep seeing the UREA...

Appreciate the input. I keep seeing the UREA grease that Honda uses for the throwout bearings being mentioned after doing some search for information on lubrication for this. Seems a lot of guys out...
Forum: Forced Induction 05-14-2019, 05:10 PM
Replies: 33
Views: 9,949
Posted By tomm.brz
depeding how hard you drive it, and how good the...

depeding how hard you drive it, and how good the tune is, you could benefit from a bigger coolant radiator too
Once you drive it really hard, oil, coolant, charge temp and Egt can go really high
Forum: AUSTRALIA 05-09-2019, 01:27 PM
Replies: 44
Views: 12,893
Posted By EAGLE5
Meh. Stock twins have had the same issues as...

Meh. Stock twins have had the same issues as post recall cars. The factory isn't magical. As for a Z, get a used one. Much cheaper and the same car.
Forum: Engine, Exhaust, Transmission 01-19-2019, 10:48 AM
Replies: 53
Views: 18,827
Posted By bhmax
It’s been written elsewhere here, but a lot of us...

It’s been written elsewhere here, but a lot of us including myself have left out the bushings (of the total Whiteline setup) closest to the head of the vertical diff bolts. It surprisingly removed a...
Forum: Engine, Exhaust, Transmission 01-18-2019, 05:53 PM
Replies: 53
Views: 18,827
Posted By justinco
I did not. So keep in mind my install...

I did not.



So keep in mind my install might not apply to absolutely everyone. If it seems out of wack, you should probably go through the full process to be sure.

My OS Giken contact (who...
Forum: Forced Induction 12-14-2018, 08:34 PM
Replies: 1,372
Views: 389,408
Posted By Trefoil
I went to a Jackson Racing dual radiator cooler...

I went to a Jackson Racing dual radiator cooler and experience extremely solid values from IAT sensor, OTS, and CTS. It has been a functional upgrade for driving in both cold and heat in a high...
Forum: Engine, Exhaust, Transmission 12-11-2018, 08:23 PM
Replies: 1
Views: 765
Posted By soundman98
it's a purely aesthetic/design choice. the...

it's a purely aesthetic/design choice. the overall pipe sizing, header style, midpipe style, and muffler is going to affect the sound.
Forum: Forced Induction 12-09-2018, 12:47 PM
Replies: 1,372
Views: 389,408
Posted By Irace86.2.0
For daily spirited driving and canyon carving you...

For daily spirited driving and canyon carving you will be fine. All I have is an OEM oil cooler/regulator. An upgrade to a better oil cooleris commonly recommended for more aggressive driving, but I...
Forum: Software Tuning 08-01-2018, 10:13 PM
Replies: 51
Views: 16,520
Posted By vtekdis
I see that now in the section 1.2 STARTER LOAD...

I see that now in the section 1.2 STARTER LOAD LIMITS. Thanks for the help freerunner! I'll report later when the tune is loaded and it's got some miles on it.
Forum: DIY (Do-It-Yourself) Guides 06-19-2018, 07:36 PM
Replies: 31
Views: 17,939
Posted By BellaItalia
non-E

...and now to muddy the water (and you can collectively yell at me, DON'T DO IT, WHAT A MAROON)...what do you think is the difference (in burning/ignition at the plug) between 87 E10 vs. 87 non-E ? ...
Forum: Software Tuning 06-06-2018, 04:24 PM
Replies: 10
Views: 2,740
Posted By steve99
Very small loads like cameras are ok. It stuff...

Very small loads like cameras are ok. It stuff like audio power amps window motors that draw high current or are transient loads
Forum: Software Tuning 07-25-2017, 09:25 PM
Replies: 110
Views: 72,044
Posted By steve99
AFAIK the ecu hardware is same for all ecu...

AFAIK the ecu hardware is same for all ecu 2012-2016 regardless if auto/manual or which country. I have not tested every combination but done a few now no problems.

The ECU will always accept...
Forum: Software Tuning 04-12-2017, 11:28 PM
Replies: 118
Views: 54,721
Posted By steve99
EcuTek How the system Works

Ecutek Cable kit Tunes licensing explained


Ecutek Tuning system consists of several components

Basic ProECU Kit Retail - (OBD cable and DESKEY, mst people refer to DESKEY as a dongle, note...
Forum: DIY (Do-It-Yourself) Guides 03-29-2017, 10:54 AM
Replies: 295
Views: 397,737
Posted By 2point0
I can't say for certain that the LS oil will be...

I can't say for certain that the LS oil will be BAD for the trans, but it's more expensive and there's no point in wasting it there. If you're uncertain, just use the regular Gear300 for both trans...
Forum: DIY (Do-It-Yourself) Guides 03-26-2017, 04:16 PM
Replies: 295
Views: 397,737
Posted By Exrald
It's because the oil had to warm up a bit. After...

It's because the oil had to warm up a bit. After 2-3 minutes, it gets pretty smooth. Once fully warmed up, it's hella smooth. It's worth it!

2013 SCION FRS (Argento)
Instagram: theunforgottenfrs
Showing results 1 to 30 of 42
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -4. The time now is 06:02 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.