follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Showing results 1 to 29 of 29
Search took 2.24 seconds. Search: Posts Made By: Tonrogs
Forum: Forced Induction 04-01-2021, 03:21 PM
Replies: 18
Views: 3,255
Posted By Tonrogs
Just noticed you are looking at atmospheric...

Just noticed you are looking at atmospheric pressure.
Talk with your tuner. They can show you which value you should be looking at.
Forum: Engine, Exhaust, Transmission 02-02-2021, 06:21 PM
Replies: 29
Views: 5,058
Posted By Tonrogs
this.

this.
Forum: Engine, Exhaust, Transmission 07-18-2020, 06:33 PM
Replies: 439
Views: 184,625
Posted By Tonrogs
Just move your upper bracket forward

Simply move your 2 upper radiator brackets forward for an extra half inch of clearance. You will end up putting 1 bolt in each bracket. Move the bracket forward and align the rear bracket hole with...
Forum: DIY (Do-It-Yourself) Guides 04-29-2020, 06:02 PM
Replies: 35
Views: 4,385
Posted By Tonrogs
if you heard a "ting" that could be one of your...

if you heard a "ting" that could be one of your tob clips. Definitely pull it apart and take a peek.
I also recommend to zip tie the fork to a bolt outside the trans when putting the trans back in....
Forum: DIY (Do-It-Yourself) Guides 04-26-2020, 09:07 AM
Replies: 35
Views: 4,385
Posted By Tonrogs
Double check your new clutch disk is correct for...

Double check your new clutch disk is correct for the spline on the transmission. You will have to remove the clutch to do that. See if it slips on.
Did you replace the pilot bearing? Did you double...
Forum: Forced Induction 03-17-2020, 07:13 PM
Replies: 59
Views: 13,599
Posted By Tonrogs
E85, yes. Running about 17-18psi before storing...

E85, yes.
Running about 17-18psi before storing over winter. Working on getting the cd009 swap in currently. Any higher on boost(19-20psi) and my tires just spun recklessly. So i turned it back down...
Forum: Forced Induction 03-16-2020, 08:11 PM
Replies: 59
Views: 13,599
Posted By Tonrogs
Lower the compression to either 9/9.5/10/10.5 to...

Lower the compression to either 9/9.5/10/10.5 to 1
Get a stronger transmission if you plan to actually use the power.
You will just spin... With those tires, no grip, the power is useless. Grippier...
Forum: Issues | Warranty | Recalls / TSB 02-02-2020, 05:48 PM
Replies: 87
Views: 19,313
Posted By Tonrogs
Assuming everything works properly on startup,...

Assuming everything works properly on startup, vvt should enable within 5 seconds. Typically right away.
Id start with techstream to narrow the possibilities.
Forum: Issues | Warranty | Recalls / TSB 02-01-2020, 12:28 PM
Replies: 87
Views: 19,313
Posted By Tonrogs
I had the same issue and it was a bad cam angle...

I had the same issue and it was a bad cam angle sensor. Not the solenoid, but the actual sensor.
Forum: Issues | Warranty | Recalls / TSB 08-29-2019, 07:49 PM
Replies: 21
Views: 4,855
Posted By Tonrogs
That bolt definitely should not be sticking out...

That bolt definitely should not be sticking out like that. 14mm, tighten it up or bring it somewhere. Have whomever check all are torqued down correctly.
That bolt is helping to hold the...
Forum: Engine, Exhaust, Transmission 08-29-2019, 06:27 PM
Replies: 1
Views: 638
Posted By Tonrogs
I have spal fans and applied the gold tape to the...

I have spal fans and applied the gold tape to the cover plates on those. Also applied it to bottom of maf sensor. Only other place it is going is on the tunnel above the trans as my tunnel gets hot...
Forum: Engine, Exhaust, Transmission 08-15-2019, 07:01 PM
Replies: 42
Views: 9,159
Posted By Tonrogs
yes it would warrant it. Go 10.5:1 or 10:1 and...

yes it would warrant it. Go 10.5:1 or 10:1 and have fun knowing you have more head room for more boost.
Forum: Engine, Exhaust, Transmission 08-15-2019, 06:52 PM
Replies: 42
Views: 9,159
Posted By Tonrogs
You should seriously consider at least part of my...

You should seriously consider at least part of my offer. Take a ride in my 9:1 engine BRZ. You could also just pull the engine and have FBM build it utilizing your existing case halves and crank.
As...
Forum: Issues | Warranty | Recalls / TSB 07-28-2019, 08:13 AM
Replies: 10
Views: 1,949
Posted By Tonrogs
Was your evap solenoid disconnected for a boost...

Was your evap solenoid disconnected for a boost controller previously? Check to be sure you reconnected everything for it.
Forum: Engine, Exhaust, Transmission 07-26-2019, 05:11 PM
Replies: 21
Views: 4,190
Posted By Tonrogs
exactly. I just put in a built motor with turbo....

exactly. I just put in a built motor with turbo. OEM plugs.
Forum: Engine, Exhaust, Transmission 07-23-2019, 10:43 PM
Replies: 21
Views: 4,190
Posted By Tonrogs
Stick with OEM.

Stick with OEM.
Forum: Forced Induction 07-21-2019, 11:06 AM
Replies: 1,346
Views: 483,635
Posted By Tonrogs
did you check the aos to see if it also was full...

did you check the aos to see if it also was full of oil? If so, then the aos could be the cause, but I would still pull the charge pipe off the turbo to check for oil there. Its only 2 clamps.......
Forum: Issues | Warranty | Recalls / TSB 06-27-2019, 06:08 PM
Replies: 97
Views: 16,899
Posted By Tonrogs
I've stripped my motor apart and reassembled a...

I've stripped my motor apart and reassembled a couple times now. The biggest thing you need to worry about is cleaning the mating surface and also the inside edge surface well. That way the squeeze...
Forum: Forced Induction 06-24-2019, 11:25 PM
Replies: 37
Views: 5,995
Posted By Tonrogs
I would start by checking the ground cables. Make...

I would start by checking the ground cables. Make sure everything is connected as it should be. One below on each side of the heads. Another at the starter. Then the battery to the chassis. Check all...
Forum: Engine, Exhaust, Transmission 06-11-2019, 06:40 AM
Replies: 7
Views: 2,294
Posted By Tonrogs
yes, heads are coming off.

yes, heads are coming off.
Forum: Engine, Exhaust, Transmission 06-01-2019, 03:03 PM
Replies: 32
Views: 3,853
Posted By Tonrogs
I think the easiest way is what you already...

I think the easiest way is what you already figured out. Remove the valve cover and work it from there.
Forum: Issues | Warranty | Recalls / TSB 04-21-2019, 01:50 PM
Replies: 13
Views: 3,637
Posted By Tonrogs
Part Number: 10921AA231 Vvt control...

Part Number: 10921AA231

Vvt control solenoid. It's not a sensor.
Forum: DIY (Do-It-Yourself) Guides 03-03-2019, 10:47 AM
Replies: 31
Views: 8,108
Posted By Tonrogs
The bumper to which it attaches to has no...

The bumper to which it attaches to has no capability to hold a vertical load. You will crumple the soft areas which are meant to give under impact and bend your bumper upwards. I would not even...
Forum: Forced Induction 02-19-2019, 07:26 AM
Replies: 2
Views: 613
Posted By Tonrogs
Connects to the evap plug. Drivers side under...

Connects to the evap plug. Drivers side under intake manifold. Polarity doesn't matter. That is if you have ecutek or oft.
If you have a stand alone controller, then it connects to that.
Forum: Engine, Exhaust, Bolt-Ons 01-12-2019, 03:45 PM
Replies: 6
Views: 1,422
Posted By Tonrogs
oh yeah! I'll get that updated shortly ...

oh yeah! I'll get that updated shortly


DONE
Forum: Engine, Exhaust, Bolt-Ons 08-25-2018, 10:43 PM
Replies: 3
Views: 1,772
Posted By Tonrogs
Pm'd

Pm'd
Forum: Exterior Parts (Aero, Lighting, Etc.) 08-12-2018, 04:41 PM
Replies: 12
Views: 3,094
Posted By Tonrogs
Seller messaged not to send just as money was...

Seller messaged not to send just as money was sent. They refunded me along with my fees i paid to send the money. Honest seller! Hope other buyer enjoys the antenna!
Forum: Engine, Exhaust, Transmission 05-28-2018, 08:34 PM
Replies: 19
Views: 3,354
Posted By Tonrogs
James @ HRI does a fantastic job.

James @ HRI does a fantastic job.
Forum: Engine, Exhaust, Transmission 05-10-2018, 05:44 PM
Replies: 7
Views: 2,722
Posted By Tonrogs
TOSH86 is for manual trans TOSH87 is for auto...

TOSH86 is for manual trans
TOSH87 is for auto trans
So you have the correct part number for a manual. I would definitely check with DSS and see what they say the length should be.
Showing results 1 to 29 of 29

 
Forum Jump

All times are GMT -4. The time now is 04:50 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.