follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Members List Calendar Search Today's Posts Mark Forums Read

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 15 1 234511 Last »
Showing results 1 to 30 of 427
Search took 1.69 seconds. Search: Posts Made By: DJCarbine
Forum: Forced Induction 09-22-2019, 11:59 AM
Replies: 22
Views: 6,704
Posted By DJCarbine
I would run the 3.12 pulley right off the bat if...

I would run the 3.12 pulley right off the bat if I did it again, or possibly a smaller pulley but I think anything smaller than that will overspin the blower at high RPM
Forum: Issues | Warranty | Recalls / TSB 07-20-2019, 09:49 PM
Replies: 241
Views: 64,450
Posted By DJCarbine
One of my relatives has the new forester sport, I...

One of my relatives has the new forester sport, I dunno... I liked it.
My sister has a 2019 outback, and likes the forester sport more now as well.

Coming from an FRS/BRZ or any sporty car, its...
Forum: Software Tuning 08-08-2018, 10:41 PM
Replies: 10
Views: 2,024
Posted By DJCarbine
Newegg carries a LOT of refurbished Lenovo...

Newegg carries a LOT of refurbished Lenovo machines, search X230 and there are many to choose from and are graded by condition. They have plenty of T420 as well.

I'm seeing good deals on ebay...
Forum: Software Tuning 08-08-2018, 09:17 PM
Replies: 10
Views: 2,024
Posted By DJCarbine
Check out the X series as well, X220/x230 are...

Check out the X series as well, X220/x230 are great laptops. I used to buy a lot of off lease laptops for resale and I still have a few T420/X230t laptops around. Great logging laptops and daily...
Forum: Cosmetic Maintenance (Wash, Wax, Detailing, Body Repairs) 07-28-2018, 11:05 PM
Replies: 22
Views: 4,948
Posted By DJCarbine
I have a Griots 6" which I purchased 5 years ago....

I have a Griots 6" which I purchased 5 years ago. The speed control works great and the locking trigger feels decent.
I used it a few weeks ago on the FRS and Saab, no signs of quitting and still...
Forum: Forced Induction 02-11-2018, 11:18 AM
Replies: 340
Views: 123,124
Posted By DJCarbine
I've pretty much forgotten that it is on the car...

I've pretty much forgotten that it is on the car at this point, except when I change the oil and drain/fill the supercharger
Forum: Engine, Exhaust, Transmission 11-20-2017, 09:26 AM
Replies: 7
Views: 2,299
Posted By DJCarbine
Should he check the distributor as well? Might...

Should he check the distributor as well? Might have thrown a weight on the mechanical timing advance, or ripped the vacuum advance diaphragm causing a leak.

OP, when is the last time you adjusted...
Forum: Scion FR-S / Toyota 86 GT86 General Forum 10-03-2017, 09:32 AM
Replies: 62
Views: 10,749
Posted By DJCarbine
Honest suggestion: If you are going to...

Honest suggestion:

If you are going to modify, try envisioning an end goal so that you have a bit of direction. No offense, and its your car so you can do whatever the hell you want, but it looks...
Forum: Issues | Warranty | Recalls / TSB 08-26-2017, 11:21 AM
Replies: 13
Views: 4,440
Posted By DJCarbine
Almost sounds like the ignition/wheel lock is in...

Almost sounds like the ignition/wheel lock is in a bind. Sometimes this can prevent the key from physically turning. When it happens again, try to gently turn the key while grabbing the steering...
Forum: BRZ First-Gen (2012+) -- General Topics 07-16-2017, 09:48 AM
Replies: 70
Views: 15,377
Posted By DJCarbine
Never got waves in modded FRS Have gotten waves...

Never got waves in modded FRS
Have gotten waves and several times comments from people in FRS/BRZ when driving stock looking WRX

The closest thing to waves I get in the FRS are the random...
Forum: Scion FR-S / Toyota 86 GT86 General Forum 07-16-2017, 09:30 AM
Replies: 20
Views: 5,607
Posted By DJCarbine
I don't think this explains the Pontiac Aztek.......

I don't think this explains the Pontiac Aztek.... pretty sure that was designed after a night of drunk bets and a deep rooted hate of human existence.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 07-12-2017, 07:06 PM
Replies: 6
Views: 1,614
Posted By DJCarbine
Sometimes I miss my stock tires..... You should...

Sometimes I miss my stock tires..... You should be good to go with your setup :thumbsup:
Forum: Forced Induction 06-29-2017, 08:45 PM
Replies: 29
Views: 4,139
Posted By DJCarbine
The turbo is whats referred to as an "ebay"...

The turbo is whats referred to as an "ebay" turbo.... I rebuilt a blown ebay turbo many years back with a real center section and ran it for 40K miles with no issue. Would not do it again, probably...
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 06-17-2017, 03:39 PM
Replies: 29
Views: 9,074
Posted By DJCarbine
I remove the entire tube assembly. A single 10mm...

I remove the entire tube assembly. A single 10mm bolt and 25 seconds has it out. I shove the biggest hose I can in the remaining hole and pump away. When the oil is almost completely evacuated out...
Forum: Forced Induction 06-11-2017, 04:25 PM
Replies: 31
Views: 7,740
Posted By DJCarbine
Not sure how your tuner has it set up, maybe its...

Not sure how your tuner has it set up, maybe its the switch from DI/PORT or hybrid? Port injectors can be loud if aftermarket

Longshot, no clue what the injector strategy is on our system
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 03-24-2017, 10:50 PM
Replies: 7
Views: 1,948
Posted By DJCarbine
Those arbor type presses are handy and easily...

Those arbor type presses are handy and easily found, for a few hundred (or less) you can also get a 12 ton hydraulic press that works fine for removing wheel bearings from hubs from your local...
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 03-24-2017, 10:46 PM
Replies: 7
Views: 1,948
Posted By DJCarbine
Get some 3/4 or inch steel plate Get...

Get some 3/4 or inch steel plate

Get threaded rod in whatever diameter you choose (check the load capacity of different sizes to get your rough capacity)

Drill holes in plate near the corners
...
Forum: Scion FR-S / Toyota 86 GT86 General Forum 03-19-2017, 02:05 PM
Replies: 9
Views: 1,958
Posted By DJCarbine
Any local members generous enough to rent/lend...

Any local members generous enough to rent/lend you a set of all seasons? If you can drop the cash, a cheap set of all seasons may not be too expensive. You could get them mounted at a local shop...
Forum: Scion FR-S / Toyota 86 GT86 General Forum 03-10-2017, 09:43 AM
Replies: 46
Views: 9,855
Posted By DJCarbine
That and they had a hole saw from princess...

That and they had a hole saw from princess auto/harbor freight they have been wanting to try out
Forum: Engine, Exhaust, Transmission 02-18-2017, 11:18 AM
Replies: 67
Views: 13,572
Posted By DJCarbine
Don't leave us hanging, what other factors?

Don't leave us hanging, what other factors?
Forum: Engine, Exhaust, Transmission 02-13-2017, 09:46 AM
Replies: 62
Views: 12,398
Posted By DJCarbine
My ej has lightweight crank pulley and flywheel,...

My ej has lightweight crank pulley and flywheel, I always thought those were just rumors. Been 20k miles so far at around 300 whp, on an engine with 80k since rebuild
Forum: Engine, Exhaust, Transmission 01-25-2017, 10:52 PM
Replies: 15
Views: 5,484
Posted By DJCarbine
You will not fail in cook county. Ecutek or...

You will not fail in cook county. Ecutek or openflash? Doesn't matter, either one will allow you to pass with flying carpets
Forum: FR-S & 86 Photos, Videos, Wallpapers, Gallery Forum 01-21-2017, 01:41 PM
Replies: 51
Views: 15,274
Posted By DJCarbine
I loaned him the tool to do the DI injector...

I loaned him the tool to do the DI injector seals, he seemed fine in person.

I do not agree with his views on the supercharger install, way too dramatic for my tastes. Haven't seen the video in...
Forum: Engine, Exhaust, Transmission 12-20-2016, 02:37 PM
Replies: 49
Views: 9,203
Posted By DJCarbine
You could flip the carburetor air cleaner lid...

You could flip the carburetor air cleaner lid upside down and get some more induction noise too
Forum: Engine, Exhaust, Transmission 12-11-2016, 04:56 AM
Replies: 38
Views: 11,575
Posted By DJCarbine
I have never owned an automatic vehicle, and I've...

I have never owned an automatic vehicle, and I've gone through maybe 7 or so

Plenty of car enthusiasts can drive or have a willingness to learn manual, but there are a lot more people who view...
Forum: Engine, Exhaust, Transmission 12-10-2016, 02:20 PM
Replies: 38
Views: 11,575
Posted By DJCarbine
For a Dr., your bedside manner is questionable ...

For a Dr., your bedside manner is questionable


Patient: doc I broke my leg, halp me
Dr: lol rekt
Forum: Engine, Exhaust, Transmission 12-08-2016, 01:47 AM
Replies: 38
Views: 11,575
Posted By DJCarbine
I mean, he basically admitted to shifting with...

I mean, he basically admitted to shifting with the clutch not fully disengaged and slamming into gear. That is not a manufacturing defect, that is operator error. I would be lying if I said I...
Forum: Engine, Exhaust, Transmission 09-22-2016, 07:47 PM
Replies: 139
Views: 26,888
Posted By DJCarbine
You don't even need to read the entire thing,...

You don't even need to read the entire thing, just make an effort to skim it.

This will not come anywhere close to solving his problem
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 09-18-2016, 10:07 PM
Replies: 2,904
Views: 588,381
Posted By DJCarbine
http://i.imgur.com/PV3Um6w.gif

http://i.imgur.com/PV3Um6w.gif
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 08-21-2016, 03:38 PM
Replies: 264
Views: 175,628
Posted By DJCarbine
Just did mine, an hour and a half. Passenger...

Just did mine, an hour and a half. Passenger side remove ECU driver. Driver side remove fuel line plastic clip (3 lines) and injector cover. Didn't need anything special, just a 14mm deep well, 3"...
Showing results 1 to 30 of 427
Page 1 of 15 1 234511 Last »

 
Forum Jump

All times are GMT -4. The time now is 09:25 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.