follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 30 of 237
Search took 0.04 seconds.
Search: Posts Made By: Target70
Forum: Forced Induction 10-30-2022, 06:08 PM
Replies: 11,295
Views: 3,424,815
Posted By Target70
I believe the other wires were for the alt...

I believe the other wires were for the alt charger which I believe was only ever necessary if you were tracking the kit. Basically it should just be a signal wire to tell the other charger when to...
Forum: Forced Induction 09-03-2022, 07:29 PM
Replies: 11,295
Views: 3,424,815
Posted By Target70
https://i.imgur.com/e2ekopc.jpg WNDSRFR, it...

https://i.imgur.com/e2ekopc.jpg

WNDSRFR, it looks like you found your own answers about the drag reduction but I'll throw in a picture that highlights the vacuum line. It's hard to see but it goes...
Forum: Forced Induction 09-03-2022, 08:50 AM
Replies: 11,295
Views: 3,424,815
Posted By Target70
Well it's good to know it's robust enough to last...

Well it's good to know it's robust enough to last this long with that type of duty cycle. For the free spinning I am referring to the engine pulling air through the compressor without the phantom...
Forum: Forced Induction 01-13-2022, 03:07 PM
Replies: 11,295
Views: 3,424,815
Posted By Target70
I know it's dangerous to assume anything so take...

I know it's dangerous to assume anything so take this for what it is, a logical guess.

If your voltage meter has an on/off switch on it like mine does, You will have to plug it in and have it...
Forum: Forced Induction 01-12-2022, 06:42 PM
Replies: 11,295
Views: 3,424,815
Posted By Target70
I'll take a look at mine when I get a chance. I'm...

I'll take a look at mine when I get a chance. I'm not sure if they are in the same locations in different versions but maybe it will help

just checked and I only have a single 4 pin connector...
Forum: Forced Induction 06-24-2021, 06:26 AM
Replies: 11,295
Views: 3,424,815
Posted By Target70
I haven't done electrical theory in almost 20...

I haven't done electrical theory in almost 20 years and even that was technician level so take this with a grain of salt, but I think that yellow wire may be the low/floating ground to a pull down...
Forum: Forced Induction 12-07-2020, 08:45 PM
Replies: 11,295
Views: 3,424,815
Posted By Target70
yeah, had corrosion all over one of my terminals...

yeah, had corrosion all over one of my terminals and covering one of my buss bars. I'm back and surprised how much more powerful it is. weak batteries really do ruin the experience. Also I ended up...
Forum: Forced Induction 01-18-2020, 02:53 AM
Replies: 11,295
Views: 3,424,815
Posted By Target70
That sounds just like mine. First that melody...

That sounds just like mine. First that melody then beep, pause then 5 more beeps. It sounds like it is booting up fine

If you can't figure out anything, I would still suggest doing a bench test...
Forum: Forced Induction 01-17-2020, 01:37 AM
Replies: 11,295
Views: 3,424,815
Posted By Target70
Check all the wiring: The bullet connectors to...

Check all the wiring: The bullet connectors to the motor, the battery terminal connections for corrosion, the cabling like the voltmeter/switch cable/fuse relay through the firewall, to make sure it...
Forum: Forced Induction 09-11-2019, 12:22 PM
Replies: 1,206
Views: 359,657
Posted By Target70
it did in the past though. The original price was...

it did in the past though. The original price was $1550+ship, batteries I spent $163 for 2 sets. Even including the OFT tuning option at $500 which allowed for E85, it was a complete system under...
Forum: Forced Induction 12-02-2018, 06:48 AM
Replies: 913
Views: 326,549
Posted By Target70
The control box for the phantom is also the...

The control box for the phantom is also the battery charger. From my understanding, it was designed to shut off the charging function while operating the motor. Operating at WOT is fine but the...
Forum: Forced Induction 08-09-2017, 05:32 AM
Replies: 11,295
Views: 3,424,815
Posted By Target70
This isn't intended to be an offense, or mockery...

This isn't intended to be an offense, or mockery of any kind... it's just.. you sounded like you were writing the opening pages of his biography and it reminded me of this:
...
Forum: Forced Induction 08-08-2017, 02:47 PM
Replies: 11,295
Views: 3,424,815
Posted By Target70
But if you have the money it doesn't make a...

But if you have the money it doesn't make a difference whether it is 2k or 30k, it all comes down to price point, what you want to do and how much you're willing to spend. I may be wrong, but I don't...
Forum: Forced Induction 08-08-2017, 01:48 PM
Replies: 11,295
Views: 3,424,815
Posted By Target70
Why did you buy an FRS instead of a Porsche...

Why did you buy an FRS instead of a Porsche Cayman? Mostly price point I would guess. There are hundereds of other more personal reasons, use, maintenance, supporting mods, or ease of instillation,...
Forum: Forced Induction 08-06-2017, 06:21 PM
Replies: 11,295
Views: 3,424,815
Posted By Target70
I didn't even know it had a filter, and I think...

I didn't even know it had a filter, and I think my fan is outside the control box, this one looks like it is on the inside. It's kind of hard to figure out from the picture, but it looks like one of...
Forum: Forced Induction 08-03-2017, 02:49 AM
Replies: 11,295
Views: 3,424,815
Posted By Target70
My memory isn't the most reliable, I know I saw a...

My memory isn't the most reliable, I know I saw a post about this. I believe some aftermarket manufacturer tackled this problem for turbo applications, not sure but I want to say full blown... again,...
Forum: Forced Induction 07-18-2017, 02:52 AM
Replies: 11,295
Views: 3,424,815
Posted By Target70
I don't know the best way, but the way I would...

I don't know the best way, but the way I would try involves some candles, and salt laid out in a pentagram, and drizzled with the blood of the innocent.

*edit, sorry if my reply got your hopes up,...
Forum: Software Tuning 07-12-2017, 07:31 PM
Replies: 1,284
Views: 578,991
Posted By Target70
If it works with the comp, but not the car it...

If it works with the comp, but not the car it could likely be the cable. The connector on the Tablet side has small open square sockets, if they get stretched open they won't make contact or will...
Forum: Forced Induction 06-29-2017, 04:04 PM
Replies: 11,295
Views: 3,424,815
Posted By Target70
you posted it in the owners thread:...

you posted it in the owners thread: http://www.ft86club.com/forums/showthread.php?t=66862&page=83

you have replies on that page.

If they were "singed together" I have to stand by my oppinion...
Forum: DIY (Do-It-Yourself) Guides 04-08-2017, 04:06 PM
Replies: 9
Views: 6,373
Posted By Target70
It stopped the leak? If so, I hope it keeps...

It stopped the leak? If so, I hope it keeps working for you. I found a post similar to the one I mentioned in case anyone else has the same problem
Forum: DIY (Do-It-Yourself) Guides 04-07-2017, 08:07 PM
Replies: 9
Views: 6,373
Posted By Target70
If I remember correctly, the outer gasket has a...

If I remember correctly, the outer gasket has a void tword the outside, you could try pulling that back and stuffing some weather stripping foam or something at that trim peace. I can't remember...
Forum: Forced Induction 12-01-2016, 03:12 PM
Replies: 11,295
Views: 3,424,815
Posted By Target70
I can't see the video at work but if it is the...

I can't see the video at work but if it is the old sequential setup Rob tried, then yeah, I remember it was more boost than you could safely run stock: motor, fuel, clutch all start becoming a...
Forum: Forced Induction 11-30-2016, 10:50 PM
Replies: 11,295
Views: 3,424,815
Posted By Target70
Parallel or sequential? how are you going to...

Parallel or sequential? how are you going to handle tuning?
Max speed of the motor seems to max out boost at ~5 psi, so parallel with two you might be able to push 5psi up to redline. I have no idea...
Forum: Forced Induction 11-22-2016, 07:08 PM
Replies: 1,206
Views: 359,657
Posted By Target70
I don't know how it is put together but the motor...

I don't know how it is put together but the motor and plate shouldn't move. That plate should be keyed or splined into the compressor housing so that it can't spin, or friction/press fit at the...
Forum: Forced Induction 09-14-2016, 02:46 AM
Replies: 11,295
Views: 3,424,815
Posted By Target70
I learned that the phantom frs from a stop sign...

I learned that the phantom frs from a stop sign will flat out walk away from a strange dark SUV that follows you through 3 random turns in back roads.. at least until he turns on his flashing blue...
Forum: Forced Induction 07-13-2016, 09:00 PM
Replies: 11,295
Views: 3,424,815
Posted By Target70
I just wanted to note that this was an auto vs...

I just wanted to note that this was an auto vs manual, so different rear end gearing I believe. That being the case I don't know how much the estimated 5 to 7 second lead would change if they were...
Forum: Forced Induction 07-13-2016, 04:41 PM
Replies: 11,295
Views: 3,424,815
Posted By Target70
it comes standard with the switch, but you can...

it comes standard with the switch, but you can upgrade and buy the proceede. This lets you plot boost vs throttle %.
Forum: Forced Induction 06-08-2016, 05:12 PM
Replies: 11,295
Views: 3,424,815
Posted By Target70
wait, multi thousand watt? or multi thousand...

wait, multi thousand watt? or multi thousand volt? I don't doubt at all multi thousand Watt, as a microwave is usually at least 1500 Watt. I don't know anything about the controller and for all I...
Forum: Forced Induction 06-08-2016, 03:09 PM
Replies: 11,295
Views: 3,424,815
Posted By Target70
after thinking about it I realized I had no idea...

after thinking about it I realized I had no idea how a brushless motor works. After some youtube videos I get the basics, but without specific motor details I can't find what they typical drive...
Forum: Forced Induction 06-07-2016, 07:17 PM
Replies: 11,295
Views: 3,424,815
Posted By Target70
I'm with you but, and maybe I'm being nit-picky...

I'm with you but, and maybe I'm being nit-picky here:


that doesn't sound right to me.
Showing results 1 to 30 of 237

 
Forum Jump

All times are GMT -4. The time now is 02:34 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.