follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Members List Calendar Search Today's Posts Mark Forums Read

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 5 1 2345
Showing results 1 to 30 of 144
Search took 1.42 seconds. Search: Posts Made By: Coheed
Forum: Forced Induction 05-14-2016, 08:36 PM
Replies: 5
Views: 2,426
Posted By Coheed
I used a .035 on my garretts without issues. Too...

I used a .035 on my garretts without issues. Too much oil can leak past the seals and cause smoking.
Forum: Forced Induction 02-29-2016, 10:59 PM
Replies: 231
Views: 103,939
Posted By Coheed
After seeing an Evo with nylon zip ties holding...

After seeing an Evo with nylon zip ties holding 40psi of boost, I have faith in many other designs of clamps now lol.
Forum: Forced Induction 11-08-2015, 01:16 AM
Replies: 16
Views: 14,388
Posted By Coheed
Just my thoughts. The T30 turbine is often...

Just my thoughts. The T30 turbine is often coupled with compressors too large to work really well without relatively sluggish response. The GTX3576R is a beast. Likewise, the GTX3071R is a great...
Forum: Engine, Exhaust, Transmission 08-27-2015, 01:11 AM
Replies: 8
Views: 3,114
Posted By Coheed
I've used $20/qt redline oils, and I'd put the...

I've used $20/qt redline oils, and I'd put the Valvoline right up there with it, for a fraction of the cost. I had no issues with the GL5 rated 85w140 I used in my last project. The higher sulfur...
Forum: Engine, Exhaust, Transmission 08-14-2015, 01:43 AM
Replies: 15
Views: 17,249
Posted By Coheed
I'm partial throttle at high rpm all the time. Do...

I'm partial throttle at high rpm all the time. Do you guys every see the track? Not to say it's a regular occurrence, but every time I'm in a canyon or on the track the engine sees a lot of partial...
Forum: Issues | Warranty | Recalls / TSB 08-09-2015, 01:11 AM
Replies: 34
Views: 8,185
Posted By Coheed
Mine is a 4/13 production. 13k miles. I have a...

Mine is a 4/13 production. 13k miles. I have a strange suspension pop/clunk intermittently when pulling into my driveway. I have crickets. I have a new dashboard from the center lifting up over the...
Forum: Engine, Exhaust, Transmission 08-08-2015, 08:31 PM
Replies: 126
Views: 63,801
Posted By Coheed
Ahhhh, I reminisce of a time when everyone told...

Ahhhh, I reminisce of a time when everyone told me 270whp from an NA SR20 wasn't possible, or 300whp from a K20... It takes time, and the right combination of parts and solutions. Certainly even...
Forum: Engine, Exhaust, Transmission 08-08-2015, 07:30 PM
Replies: 31
Views: 11,431
Posted By Coheed
Car looks like it moves well. Thanks for the...

Car looks like it moves well. Thanks for the video, it is something I find strangely lacking from the community. Would love to see more acceleration videos from people.
Forum: Engine, Exhaust, Transmission 08-01-2015, 12:09 AM
Replies: 849
Views: 350,670
Posted By Coheed
It's not the issue of whether the vehicle is...

It's not the issue of whether the vehicle is tuned with the header, or not. Rather, whether or not the tune will allow the vehicle to pass an OBD2 system readiness check.
Forum: Engine, Exhaust, Transmission 07-31-2015, 02:20 AM
Replies: 849
Views: 350,670
Posted By Coheed
Testing for the 2013 model year doesn't begin...

Testing for the 2013 model year doesn't begin until next year.
Forum: Engine, Exhaust, Transmission 07-28-2015, 01:40 AM
Replies: 849
Views: 350,670
Posted By Coheed
That's exactly what I needed to know, Mike....

That's exactly what I needed to know, Mike. Thanks for the response. I know how to trick the ECU into thinking everything is ok by using spacers/capacitors etc, but I'd rather a software workaround...
Forum: Engine, Exhaust, Transmission 07-25-2015, 10:51 PM
Replies: 63
Views: 11,376
Posted By Coheed
The factory traction control already applies the...

The factory traction control already applies the brake to the slipping wheel. When you have a lifted tire going into a driveway, the ABS system takes over and does the e-brake trick for you. But who...
Forum: Engine, Exhaust, Transmission 06-23-2015, 10:19 PM
Replies: 80
Views: 28,926
Posted By Coheed
Hell ya, that's how you know your making REAL...

Hell ya, that's how you know your making REAL power bro. All the fast hondas sound just like that. Fast.

Just pokin' at ya. I love the sound of a tuned equal length, but I've been cultured into...
Forum: Forced Induction 04-29-2015, 04:24 AM
Replies: 6,004
Views: 2,048,475
Posted By Coheed
If by "filters" you mean underwear, we are on the...

If by "filters" you mean underwear, we are on the same page. :thumbsup:
Forum: Forced Induction 04-27-2015, 01:57 PM
Replies: 4,305
Views: 1,329,951
Posted By Coheed
I haven't seen too many cog belt designs for...

I haven't seen too many cog belt designs for superchargers. I figure a 6 rib belt is sufficient for all the other accessories on the vehicle, including A/C. If the drive system were a dedicated 6 rib...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 04-22-2015, 09:25 PM
Replies: 184
Views: 47,665
Posted By Coheed
Since the purpose of the sway bar isn't to...

Since the purpose of the sway bar isn't to support the weight of the vehicle, this comparison, frankly, is stupid.

I used sway bars to help fine-tune my previous race car. It was hampered by many...
Forum: Forced Induction 02-08-2015, 01:57 AM
Replies: 55
Views: 16,499
Posted By Coheed
The length of the charge tube is only one part of...

The length of the charge tube is only one part of the equation here. The charge pipe is only 2" diameter to the intercooler. So here is some simple math.
565ci is the total displacement of 15ft of...
Forum: Forced Induction 02-07-2015, 12:13 AM
Replies: 55
Views: 16,499
Posted By Coheed
Length of the pipe has little impact to lag....

Length of the pipe has little impact to lag. Volume, it could be argued, can help or hinder response. But do the math and the effect is very minimal. The charge piping is only 2", so it can be very...
Forum: Forced Induction 09-06-2014, 10:06 PM
Replies: 23
Views: 13,846
Posted By Coheed
I have extensive experience with the GT3076r, but...

I have extensive experience with the GT3076r, but the GTX is a different animal. Would love do testing on a .82 vband setup with the GTX, as the .63 housing is not my preferable choice for that...
Forum: Forced Induction 04-06-2014, 07:39 PM
Replies: 51
Views: 20,876
Posted By Coheed
There are benefits to having the pulses divided...

There are benefits to having the pulses divided and preventing reversion. However, twin scroll housings tend to be rather restrictive compared to their single-scroll counterparts. I flowbenched a .78...
Forum: Forced Induction 04-03-2014, 01:48 AM
Replies: 39
Views: 17,444
Posted By Coheed
Though 30lbs is not a lot, floating valves has a...

Though 30lbs is not a lot, floating valves has a lot to due with valve size/weight, and harmonics with the cams. Higher lift angles will float sooner. Cams with smoother ramp angles will rev higher....
Forum: Forced Induction 03-30-2014, 12:49 AM
Replies: 51
Views: 20,876
Posted By Coheed
Unless you are willing to go really big,...

Unless you are willing to go really big, twinscroll is mostly a waste of money.
Forum: Forced Induction 03-28-2014, 04:17 PM
Replies: 48
Views: 21,705
Posted By Coheed
305 is pretty good. This is slightly better than...

305 is pretty good. This is slightly better than K20s I've had flowed. Granted, those can see really amazing flow rates with a good amount of work. this looks like a very streetable setup that should...
Forum: Forced Induction 03-06-2014, 04:47 PM
Replies: 127
Views: 55,426
Posted By Coheed
I'm not too concerned about total output as long...

I'm not too concerned about total output as long as the kit can do 300whp on pump. I'm not planning on upgrading my injectors, and I don't want to go with a puck clutch.

It's a slippery slope and...
Forum: Forced Induction 03-03-2014, 09:29 PM
Replies: 127
Views: 55,426
Posted By Coheed
The price is going to be around ~5500 for a...

The price is going to be around ~5500 for a turnkey ready install. It comes with a ball bearing oil-less comp turbo capable of around 500hp (GT30r equiv). There are basic setups that are capable of...
Forum: Forced Induction 02-27-2014, 03:09 AM
Replies: 127
Views: 55,426
Posted By Coheed
As promised, I went to STS turbos to check out...

As promised, I went to STS turbos to check out the kit and I have some initial impressions. They had 2 cars there with the kit. One was manual with intercooler, they also had a customers car that was...
Forum: Forced Induction 02-21-2014, 08:46 PM
Replies: 134
Views: 33,655
Posted By Coheed
GTX3076r correct? I wonder if the GTX3576r...

GTX3076r correct?

I wonder if the GTX3576r would need the ported shroud housing? the 76mm typically comes with the ported shroud since it was mated to a small turbine. The larger turbine should...
Forum: Forced Induction 02-19-2014, 09:30 PM
Replies: 127
Views: 55,426
Posted By Coheed
I'm going to be stopping by STS next week to...

I'm going to be stopping by STS next week to check out the car if it is available. I would love to be able to drive it and give you guys my impressions. My co-worker used to work at STS and he speaks...
Forum: Forced Induction 02-19-2014, 08:47 PM
Replies: 134
Views: 33,655
Posted By Coheed
The ns111 wheel has more power potential and no...

The ns111 wheel has more power potential and no hit to response, transient or boost onset. It would be much better suited to use the .86 housing on the GTX turbos, because they flow more air than the...
Forum: Forced Induction 02-19-2014, 03:31 AM
Replies: 134
Views: 33,655
Posted By Coheed
The GTX2867r has been used by many with good...

The GTX2867r has been used by many with good results, but the ns111 turbine is best suited to the 63r compressor. The turbine starts to choke when using the larger compressors, but on some engines it...
Showing results 1 to 30 of 144
Page 1 of 5 1 2345

 
Forum Jump

All times are GMT -4. The time now is 02:55 PM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.