follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 30 of 303
Search took 0.02 seconds.
Search: Posts Made By: ptuning
Forum: Forced Induction 03-09-2022, 11:23 AM
Replies: 6,004
Views: 2,053,717
Posted By ptuning
On my personal BRZ with a JRSC on the car I moved...

On my personal BRZ with a JRSC on the car I moved the oil reservoir to the passenger side cross bar next to the battery to be able to keep our flex fuel kit unmodified.

- Tom
Forum: Mid-Atlantic 03-02-2022, 10:26 AM
Replies: 4
Views: 1,315
Posted By ptuning
Some other events in the mid atlantic area to...

Some other events in the mid atlantic area to piggyback off your post:

SCCA:

March 5/6 - Summit Point HPDE/Time trials
March 26/27 - Summit point HPDE/time trials
April 29-May 1st - Summit...
Forum: Forced Induction 02-04-2021, 09:58 AM
Replies: 7
Views: 2,186
Posted By ptuning
For grounds check the two main grounds that are...

For grounds check the two main grounds that are at the rear of the engine on the case halves as well as check the ground straps that attack to the cylinder heads underneath the vehicle.
Forum: Forced Induction 09-21-2016, 09:56 AM
Replies: 41
Views: 33,012
Posted By ptuning
Appreciate the feedback. We truly strive to make...

Appreciate the feedback. We truly strive to make the best products. Here is some reading material for those who are interested in our turbo kit:


PTUNING FR-S/BRZ/GT86 Turbo System (V2,...
Forum: Forced Induction 05-20-2016, 11:06 AM
Replies: 20
Views: 6,832
Posted By ptuning
I generally opt to stay out of threads involving...

I generally opt to stay out of threads involving another tuner's tune, but since this is regarding our turbo system, I'll give my input. It's most likely that your cam timing just isn't optimized...
Forum: Forced Induction 04-27-2016, 01:54 PM
Replies: 9
Views: 4,439
Posted By ptuning
I won't speculate about what other companies are...

I won't speculate about what other companies are doing, since I'm not following their progress. However, I can say that it would likely be tough to one up ECUTek in terms of functionality....
Forum: Engine, Exhaust, Transmission 02-18-2016, 01:08 PM
Replies: 64
Views: 23,871
Posted By ptuning
The Buetooth feature will only work with Android...

The Buetooth feature will only work with Android devices, but the ECU (ECUTek) will always be able to read the 0-5V output signal regardless. An IOS version may be available later on down the road....
Forum: Engine, Exhaust, Transmission 02-18-2016, 01:03 PM
Replies: 64
Views: 23,871
Posted By ptuning
This device will only provide the 0-5V output...

This device will only provide the 0-5V output needed to integrate with your ECU. However, like with all flex fuel kits, you will need the custom RaceROM maps available with ECUTek in order to...
Forum: Engine, Exhaust, Transmission 02-17-2016, 02:57 PM
Replies: 64
Views: 23,871
Posted By ptuning
PTUNING Flex Fuel Kit w/Bluetooth Module

After extensive R&D, we're finally ready to release our new PTUNING Bluetooth Flex Fuel System. Our kit utilizes the latest compact flex fuel sensor along with a bluetooth-capable flex fuel module....
Forum: Forced Induction 10-09-2015, 02:54 PM
Replies: 52
Views: 23,654
Posted By ptuning
Yes, we'll be offering this option for existing...

Yes, we'll be offering this option for existing customers. The good thing is that the package will only need to include a different turbo/trans mounting bracket, lower intake tube (3" inlet),...
Forum: Forced Induction 10-09-2015, 01:52 PM
Replies: 52
Views: 23,654
Posted By ptuning
PTUNING Spec-SS Turbo System with GTX2867R option

We finally got around to testing a smaller turbo option for those looking for an ultra-quick responding turbo for street or track use, especially with the stock engine.

As most turbo enthusiasts...
Forum: Scion FR-S / Toyota 86 GT86 General Forum 03-03-2015, 10:51 AM
Replies: 59
Views: 14,875
Posted By ptuning
Hi there, We're definitely for something...

Hi there,

We're definitely for something nearby, so that we can give you guys our full support. We enjoyed 86expo last year and we have a large community base here that will attend this event....
Forum: Forced Induction 03-03-2015, 10:37 AM
Replies: 121
Views: 28,186
Posted By ptuning
Yes, it will allow you to run more timing for...

Yes, it will allow you to run more timing for more power :) and for more boost down the road if you have a smaller pulley

-Peace@ptuning.com
Forum: Forced Induction 02-24-2015, 04:13 PM
Replies: 23
Views: 4,059
Posted By ptuning
http://i1382.photobucket.com/albums/ah245/PeaceatP...

http://i1382.photobucket.com/albums/ah245/PeaceatPtuning/DSC05196_zpswstlcjbp.jpg (http://s1382.photobucket.com/user/PeaceatPtuning/media/DSC05196_zpswstlcjbp.jpg.html)

-Peace@ptuning.com
Forum: Engine, Exhaust, Transmission 10-27-2014, 01:13 PM
Replies: 616
Views: 244,533
Posted By ptuning
Hello Everyone, First off, we would like to...

Hello Everyone,

First off, we would like to thank you for your purchase of the PTUNING header and for your patience on the long wait.

We would also like to address the question of the gaskets. ...
Forum: Engine, Exhaust, Transmission 10-23-2014, 03:53 PM
Replies: 616
Views: 244,533
Posted By ptuning
Our header was tested with our 3" over-pipe back...

Our header was tested with our 3" over-pipe back exhaust system. We are developing an NA specific front-pipe, mid-pipe section that will hopefully provide the same power output, but at much lower...
Forum: Engine Swaps 10-03-2014, 12:10 PM
Replies: 80
Views: 45,691
Posted By ptuning
I would not recommend doing an SR20 swap. ...

I would not recommend doing an SR20 swap.

Having tuned a gazillion different 4 cylinder cars with all different combinations of NA mods, SC's, Turbos, etc, I can say that the SR20 engine is only...
Forum: Engine, Exhaust, Transmission 09-06-2014, 04:11 PM
Replies: 616
Views: 244,533
Posted By ptuning
If we're able to develop an OTS map for the OFT...

If we're able to develop an OTS map for the OFT that doesn't require further ETuning, then I'm sure it will be something that we can offer to our header customers for free. It will likely only be...
Forum: Engine, Exhaust, Transmission 09-04-2014, 12:12 AM
Replies: 616
Views: 244,533
Posted By ptuning
I just wanted to answer a few common PM questions...

I just wanted to answer a few common PM questions we've received recently regarding tuning with our header. Although in-house dyno tuning will always be the preferred method to extract every last...
Forum: Engine, Exhaust, Transmission 08-31-2014, 05:20 PM
Replies: 616
Views: 244,533
Posted By ptuning
The primary job of a secondary O2 sensor on a...

The primary job of a secondary O2 sensor on a modern day car is to detect the presence of a cat. The ECU gets a reading from both the primary and secondary O2 sensors and compares their values with...
Forum: Engine, Exhaust, Transmission 08-30-2014, 05:59 PM
Replies: 616
Views: 244,533
Posted By ptuning
If these pieces bolt up to the factory header...

If these pieces bolt up to the factory header perfectly, then it will work with our header.

- Toan
Forum: Forced Induction 08-25-2014, 02:15 PM
Replies: 1,238
Views: 476,195
Posted By ptuning
We apologize for the delay on this item guys....

We apologize for the delay on this item guys. This is still going to happen. Truth be told, we had to shift our focus on getting the oil cooler system and header ready first, since we received so...
Forum: Engine, Exhaust, Transmission 08-23-2014, 10:12 PM
Replies: 23
Views: 8,574
Posted By ptuning
Here's our headerback 3" modular dual exhaust...

Here's our headerback 3" modular dual exhaust system. It can be converted to a driver's side exit single exhaust system for those who prefer single mufflers:
...
Forum: Forced Induction 08-22-2014, 04:47 PM
Replies: 71
Views: 28,154
Posted By ptuning
Done, shoot me a PM with details of your setup...

Done, shoot me a PM with details of your setup and we'll make it happen. :thumbup:

- Toan
Forum: Forced Induction 08-22-2014, 01:14 PM
Replies: 71
Views: 28,154
Posted By ptuning
If you're relatively local to us and are...

If you're relatively local to us and are interested in running our WMI system with the following forced induction kits, please contact us. We can offer the first customer for each FI platform a...
Forum: Engine, Exhaust, Transmission 08-22-2014, 12:05 AM
Replies: 9
Views: 5,376
Posted By ptuning
An intake leak could cause a true lean fueling...

An intake leak could cause a true lean fueling situation. An exhaust leak at the header flanges or anywhere before or near the O2 sensors will make the O2 sensors "read" lean, which will also cause...
Forum: Engine, Exhaust, Transmission 08-21-2014, 12:11 AM
Replies: 616
Views: 244,533
Posted By ptuning
This header may work fine with a quality...

This header may work fine with a quality overpipe/frontpipe combo that utilizes the factory midpipe and possibly even the muffler section. We'll try to test and tune as many exhaust combinations as...
Forum: Engine, Exhaust, Transmission 08-21-2014, 12:05 AM
Replies: 616
Views: 244,533
Posted By ptuning
We'll certainly try our best to develop a system...

We'll certainly try our best to develop a system that will fit RHD cars too. :thumbsup:

- Toan
Forum: Engine, Exhaust, Transmission 08-21-2014, 12:03 AM
Replies: 616
Views: 244,533
Posted By ptuning
We'd say run them as is for now. We do not see...

We'd say run them as is for now. We do not see radiant heat being an issue with our compact header design. Also, we will likely develop a heat shielding option later on down the road for those that...
Forum: Engine, Exhaust, Transmission 08-19-2014, 01:26 PM
Replies: 616
Views: 244,533
Posted By ptuning
That set-up would definitely be quieter than a...

That set-up would definitely be quieter than a straight 3" exhaust, but will still be louder than stock due to the lack of a cat. The header if off of the car right now, but we can give you a ride in...
Showing results 1 to 30 of 303

 
Forum Jump

All times are GMT -4. The time now is 04:56 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.