follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 30 of 500
Search took 0.71 seconds.
Search: Posts Made By: BatStig
Forum: Forced Induction 03-19-2024, 02:16 PM
Replies: 6,011
Views: 2,072,792
Posted By M0nk3y
FWIW I have an ACE Shroud Installed. Shows...

FWIW I have an ACE Shroud Installed.

Shows pretty easily what you need to do for install and drilling for IC Piping, this is Harrop Install.

The hoses are now wrapped with 1" Heater Hose so...
Forum: BRZ Second-Gen (2022+) -- General Topics 03-15-2024, 06:03 PM
Replies: 31
Views: 4,293
Posted By OldBiker
Oil Pressure Drop

Latest from 900BRZ:

https://youtu.be/Pvgg7dl-I5I?si=1-mmE6sFwRsn3CWC

Yeah!! So the best solution: large capacity oil plan + integrated baffle. Excellent video to go along with it, explaining...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 02-12-2024, 12:07 PM
Replies: 9
Views: 992
Posted By blsfrs
I want.

https://spinoff.nasa.gov/NASA_Gives_the_World_a_Brake?fbclid=IwAR1ST3F8alZY7GOX65VAK_kUsWzAjOkRq4iwTQcgqr1CIiPItsh53tZd6M8
Forum: Forced Induction 02-01-2024, 12:12 AM
Replies: 6,011
Views: 2,072,792
Posted By CSG Mike
It's easier than it may seem, as really, you only...

It's easier than it may seem, as really, you only need to do the pieces on the sides and one at the top of the radiator.

The JDL bash bar will make mounting the intercooler more challenging, but...
Forum: Forced Induction 01-30-2024, 03:55 PM
Replies: 6,011
Views: 2,072,792
Posted By CSG Mike
You can accomplish virtually the same result by...

You can accomplish virtually the same result by trimming your original factory side air guides.

Make sure all the foam around the top of your radiator is intact.

Venting your hood will have a...
Forum: Tracking / Autocross / HPDE / Drifting 06-14-2023, 09:48 AM
Replies: 14
Views: 3,274
Posted By Kelse92
Simplest/least expensive install is going to be...

Simplest/least expensive install is going to be the Brey Krause Harness bar, it's low impact on your interior (if you care about it) and space saving. No carpet to trim, pieces to cut, no drilling...
Forum: Tracking / Autocross / HPDE / Drifting 05-19-2023, 04:12 PM
Replies: 36
Views: 5,983
Posted By RedReplicant
This. I ran a 9LR on my S2000 when they first...

This. I ran a 9LR on my S2000 when they first came out, after a season my trunk lid itself was cracked about 25% of the way around the top feet.

https://i.imgur.com/hvi4fV5.jpg...
Forum: Engine, Exhaust, Transmission 05-17-2023, 08:36 PM
Replies: 69
Views: 11,304
Posted By blsfrs
My engine guy pulled the timing cover off of my...

My engine guy pulled the timing cover off of my engine. Unfortunately, he did not find anything out of the ordinary other than Element Tuning putting a restrictor on the port going to the left head....
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 05-17-2023, 05:28 PM
Replies: 121
Views: 49,982
Posted By enivid
Torque is back in business so I emailed him and...

Torque is back in business so I emailed him and asked for my order.

Sent from my Pixel 6a using Tapatalk
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 05-17-2023, 02:17 PM
Replies: 121
Views: 49,982
Posted By enivid
My order from 2015 has arrived!...

My order from 2015 has arrived! https://uploads.tapatalk-cdn.com/20230517/7b5d8173be72ab84afde4faf6c7c958d.jpg

Sent from my Pixel 6a using Tapatalk
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 05-13-2023, 09:01 AM
Replies: 3
Views: 1,827
Posted By Opie
FT86 Continental Extreme Contact Force buy 3, get 1 FREE tire offer

That’s right fellow 86 owners, I have put together a special arrangement for you to get your 4th Continental Extreme Contact Force tire free when you buy 3 from Track Day Tire...
Forum: Engine, Exhaust, Transmission 04-28-2023, 09:07 PM
Replies: 69
Views: 11,304
Posted By blsfrs
No news yet. Last week, I took the engine to...

No news yet. Last week, I took the engine to Perfect Circle. I've scoured the internet for anyone having a similar problem. I did find a post from a guy in Ireland who rigged up a direct main...
Forum: Tracking / Autocross / HPDE / Drifting 04-18-2023, 04:41 PM
Replies: 33
Views: 5,430
Posted By DocWalt
Yup! They said they were setting PBs 8 laps into...

Yup! They said they were setting PBs 8 laps into a track session. Pretty impressive.

They did say it was hard to place the car at all times and not super confidence inspiring having to drive with...
Forum: Tracking / Autocross / HPDE / Drifting 04-18-2023, 10:15 AM
Replies: 33
Views: 5,430
Posted By DocWalt
Feedback from folks other than Andy.. ...

Feedback from folks other than Andy..


"Drives like the old CR-S but takes more heat to work"
Forum: Tracking / Autocross / HPDE / Drifting 04-17-2023, 03:52 PM
Replies: 36
Views: 5,983
Posted By Opie
There is a right, and a left, upright. Are you...

There is a right, and a left, upright. Are you sure you have them on the right sides?
Forum: Tracking / Autocross / HPDE / Drifting 03-28-2023, 08:37 PM
Replies: 36
Views: 5,983
Posted By villainous_frx
I'm using doubled sided tape temporarily until I...

I'm using doubled sided tape temporarily until I wrap/paint the spare trunk the wang is on. After that I was going to use marine grade silicon to seal it off. The VHB has not been tested as that...
Forum: Tracking / Autocross / HPDE / Drifting 03-28-2023, 11:50 AM
Replies: 36
Views: 5,983
Posted By ML
Where have yall been. This is the 9lives builders...

Where have yall been. This is the 9lives builders kit I have been running for 3 years, and some other 86 track guys have been running it like this too. just uses the trunk hinges as the mounts and...
Forum: Tracking / Autocross / HPDE / Drifting 03-28-2023, 11:07 AM
Replies: 36
Views: 5,983
Posted By NoHaveMSG
I used silicone. My paint and body guy was not...

I used silicone. My paint and body guy was not happy.
Forum: Tracking / Autocross / HPDE / Drifting 03-28-2023, 10:32 AM
Replies: 36
Views: 5,983
Posted By Opie
1a: For the mounting the stands to the trunk (4...

1a: For the mounting the stands to the trunk (4 top holes): Button head allens, 304 Stainless Steel M6x1mm thread, 22mm long, with 304 Stainless steel flat washers (topside) & 304 Stainless 25MM OD...
Forum: Tracking / Autocross / HPDE / Drifting 03-23-2023, 10:19 AM
Replies: 36
Views: 5,983
Posted By Opie
So since the old trunk and Wang mounts were...

So since the old trunk and Wang mounts were damaged in December due to my wall brush, I mounted the new Wang mounts tonight, with some of your suggested improvements to reduce trunk deflection under...
Forum: Tracking / Autocross / HPDE / Drifting 03-22-2023, 07:28 PM
Replies: 33
Views: 5,430
Posted By jflogerzi
Not sure if the v730's are good in wet? I really...

Not sure if the v730's are good in wet? I really liked them on the single track day I used them. Liked them better than the 660's. Have not yet tried RE71Rs. They are closer to A052's in the sense...
Forum: Tracking / Autocross / HPDE / Drifting 03-20-2023, 04:28 PM
Replies: 33
Views: 5,430
Posted By CSG Mike
11 months? I wouldn't sweat it. Their warehouse...

11 months? I wouldn't sweat it. Their warehouse is fully climate (temp and humidity) controlled; it's not a random warehouse.
Forum: Tracking / Autocross / HPDE / Drifting 03-20-2023, 04:27 PM
Replies: 33
Views: 5,430
Posted By CSG Mike
The Conti isn't even in the same realm for...

The Conti isn't even in the same realm for performance, but will last the longest.

The RE71RS will have the best overall feedback.

A052 will be the most forgiving.
Forum: Engine, Exhaust, Transmission 03-18-2023, 11:29 PM
Replies: 12
Views: 2,208
Posted By DarkPira7e
I had mine in the freezer overnight, and the next...

I had mine in the freezer overnight, and the next day, attached them to the rail and used the rail to seat them evenly. Tightening the rail down very slowly and evenly (switch left to right every...
Forum: Tracking / Autocross / HPDE / Drifting 03-13-2023, 03:05 PM
Replies: 36
Views: 5,983
Posted By Opie
Think I'm going to implement two things to...

Think I'm going to implement two things to address this, a stand-off like redlined600 mentioned at the rear of the trunk...and a stop to the trunk hinge like ROADRACER mentioned. I didn't understand...
Forum: Tracking / Autocross / HPDE / Drifting 03-11-2023, 01:45 PM
Replies: 36
Views: 5,983
Posted By NoHaveMSG
I was looking at the trunk. The hinge bolts go...

I was looking at the trunk. The hinge bolts go through the body and stick out on the inside. I am thinking of building a brace that mounts to the bottom of the trunk hinge on the inside and runs...
Forum: Tracking / Autocross / HPDE / Drifting 03-09-2023, 11:19 AM
Replies: 36
Views: 5,983
Posted By ROADRACER
If you look at the hinge assembly there is a...

If you look at the hinge assembly there is a place to install a bolt that will support the vertical load.
That and replacing the rubber stops at the back of the trunk(as shown in previous post) will...
Forum: Tracking / Autocross / HPDE / Drifting 03-09-2023, 10:43 AM
Replies: 36
Views: 5,983
Posted By NoHaveMSG
Even my little APR GTC-200 flexes the trunk quite...

Even my little APR GTC-200 flexes the trunk quite a bit. I am running a much larger 65" from winglogic this year so I am working on a solution myself. Haven't decided if I am going to trunk mount it...
Forum: Tracking / Autocross / HPDE / Drifting 03-09-2023, 10:34 AM
Replies: 36
Views: 5,983
Posted By redlined600
I also found that it flexes/compresses, enough...

I also found that it flexes/compresses, enough that the trunk lid rubs on the top of the taillight.
I recorded this image at ~80mph, zero-ish AOA.
https://i.imgur.com/Uhb2zSn.png

While I...
Forum: Tracking / Autocross / HPDE / Drifting 03-09-2023, 09:27 AM
Replies: 36
Views: 5,983
Posted By Opie
Nine Lives Racing Wang mounting discussion

I know many 86 owners that track, TT, race, etc are using the Nine Lives Racing Wang on their cars as have I.

I have noticed, that the trunk lid actually flexes due to the design of the trunk...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -4. The time now is 04:03 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.