follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 30 of 500
Search took 0.51 seconds.
Search: Posts Made By: Teseo
Forum: Member's Car Journals Yesterday, 01:10 AM
Replies: 106
Views: 53,120
Posted By Jyn
Ran the car in time trials at NOLA Motorsports...

Ran the car in time trials at NOLA Motorsports Park this past weekend with no issues.

Fixed some minor issues Friday night trackside related to leaking oil and leaking fuel (that were unrelated...
Forum: Member's Car Journals 09-12-2024, 06:34 PM
Replies: 3
Views: 970
Posted By DustinS
Just a small update. Got the "good" engine...

Just a small update.

Got the "good" engine torn down.

https://live.staticflickr.com/65535/53666780439_a9a527af02_c.jpg

A little bit of marks on the skirts and cylinder walls.
...
Forum: Engine Swaps 09-08-2024, 08:12 PM
Replies: 34
Views: 3,937
Posted By blsfrs
Alternator and bracket

If you do one of these swaps, get the 2022+ alternator AND bracket.

You can trim the old bracket and almost make it work with a 2022+ belt but mine always had a slight squeak similar to the...
Forum: Member's Car Journals 09-05-2024, 09:21 PM
Replies: 106
Views: 53,120
Posted By Jyn
219whp and 189 wtq on e75. Didn't have time to...

219whp and 189 wtq on e75. Didn't have time to finish the e85 tune but it's close enough. My last dyno on the FA20 had me at about 198 whp and 141 wtq, so will be nice to have the extra torque.

...
Forum: Member's Car Journals 09-02-2024, 11:16 PM
Replies: 106
Views: 53,120
Posted By Jyn
I think it will become the ez button for this...

I think it will become the ez button for this car.


I'll try and update this post with some more details eventually. Just been lazy and out of the car scene for a while
Forum: Member's Car Journals 09-01-2024, 11:25 PM
Replies: 106
Views: 53,120
Posted By Jyn
Added a half cage, containment seat, and Sparco...

Added a half cage, containment seat, and Sparco wheel.


Also dropped an FA24 into my first gen chassis to celebrate 10 years with the car.
Forum: Software Tuning 08-30-2024, 02:54 PM
Replies: 17
Views: 1,102
Posted By alphasaur
eagerly following this thread in case I ever fa24...

eagerly following this thread in case I ever fa24 swap. Thanks for being a pioneer
Forum: Scion FR-S / Toyota 86 GT86 General Forum 08-26-2024, 07:29 AM
Replies: 24,673
Views: 7,529,751
Posted By Dadhawk
Or better yet, your next car.

Or better yet, your next car.
Forum: Scion FR-S / Toyota 86 GT86 General Forum 08-24-2024, 09:24 PM
Replies: 24,673
Views: 7,529,751
Posted By RToyo86
House projects indeed. Will be allocated to...

House projects indeed. Will be allocated to adulting for a bit. My car is about to cross 160k km, I figure it would be smarter to start saving for an FA24 when the time comes.
Forum: Scion FR-S / Toyota 86 GT86 General Forum 08-24-2024, 01:27 PM
Replies: 24,673
Views: 7,529,751
Posted By RToyo86
Paid off the car.

Paid off the car.
Forum: Engine Swaps 08-19-2024, 08:43 PM
Replies: 34
Views: 3,937
Posted By blsfrs
I don't have Techstream. I was hoping using...

I don't have Techstream. I was hoping using Ecktek logging would give similar information. I'm going to try my Ecutek again with a newer laptop and also check around my local car community for some...
Forum: Engine Swaps 08-18-2024, 05:27 PM
Replies: 34
Views: 3,937
Posted By blsfrs
I've driven around this week. No change in the...

I've driven around this week. No change in the P0341 code. The engine runs really well, good power. Today, I tried use my Ecutek stuff to datalog but I couldn't get it to connect to my ecu. I've...
Forum: GR86 General Topics (2nd Gen 2022+ Toyota 86) 08-18-2024, 10:44 AM
Replies: 3
Views: 1,075
Posted By blsfrs
Ebay engine cover

While I don't drive a 2nd gen, I do have a 2nd gen engine in my 2013 FRS. It came without an engine cover, so I got an aluminum off of ebay for $12. I got what I paid for. Fitment was a bit of a...
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 08-16-2024, 03:14 PM
Replies: 145
Views: 19,287
Posted By humfrz
For right now. :iono:

For right now.

:iono:
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 08-13-2024, 11:16 PM
Replies: 10,681
Views: 1,425,655
Posted By humfrz
Thanks, weederr33. I'll let you know how it...

Thanks, weederr33.

I'll let you know how it turns out.
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 08-13-2024, 03:20 AM
Replies: 10,681
Views: 1,425,655
Posted By NoHaveMSG
I just don’t have any downtime with my new job....

I just don’t have any downtime with my new job. Sitting at a desk at my old job I always had the forum open on a tab.
Forum: Engine Swaps 08-12-2024, 12:52 PM
Replies: 34
Views: 3,937
Posted By blsfrs
Still getting P0341. RSM sent a replacement...

Still getting P0341. RSM sent a replacement plug. I installed it and continuity was good on all 3 wires. Cleared codes but CEL came on when I started the engine. My Actron code reader shows 2...
Forum: Engine Swaps 08-12-2024, 12:52 PM
Replies: 34
Views: 3,937
Posted By blsfrs
Still getting P0341. RSM sent a replacement...

Still getting P0341. RSM sent a replacement plug. I installed it and continuity was good on all 3 wires. Cleared codes but CEL came on when I started the engine. My Actron code reader shows 2...
Forum: Engine, Exhaust, Transmission 08-12-2024, 11:55 AM
Replies: 6
Views: 5,895
Posted By blsfrs
Correction: That is the oil temp sensor. The...

Correction: That is the oil temp sensor. The coolant temp sensor is under the manifold. Can OP post a picture of the location of the Glowshift sensor?
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 08-07-2024, 11:46 PM
Replies: 10,681
Views: 1,425,655
Posted By p1l0t
I hope it shuts everything down again so I can...

I hope it shuts everything down again so I can just go live on my sailboat for days at a time..https://uploads.tapatalk-cdn.com/20240808/d377115a41260e302c573313a73ef869.jpg

Sent from my SM-G975U...
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 08-06-2024, 08:51 PM
Replies: 10,681
Views: 1,425,655
Posted By humfrz
UGH! I thought family reunions in Oregon...

UGH!

I thought family reunions in Oregon were to meet girls - not get sick - :iono:
Forum: Engine, Exhaust, Bolt-Ons 08-02-2024, 06:19 AM
Replies: 36
Views: 2,447
Posted By RT-BRZ
On principle, I don't sell much of anything on...

On principle, I don't sell much of anything on the internet. When I do sell something it's priced appropriately so I don't get people spamming my ad and cursing out other members...

The seller...
Forum: GR86 General Topics (2nd Gen 2022+ Toyota 86) 08-01-2024, 08:47 PM
Replies: 29
Views: 3,878
Posted By Dadhawk
The one in the photo looks like it should have a...

The one in the photo looks like it should have a big star on the door and a staff flag flying on it. You know, like this....

https://live.staticflickr.com/65535/6055481107_0615128ce3_b.jpg
...
Forum: BRZ Second-Gen (2022+) -- General Topics 07-30-2024, 06:29 PM
Replies: 17
Views: 4,761
Posted By Mcgiiver
Get some cheap cinnamon or peppermint mouthwash...

Get some cheap cinnamon or peppermint mouthwash from the Dollar Store, and pour it over the tires and around the car and engine bay. Mice hate the smell and will stay away. Maybe leave cup full of...
Forum: Other Vehicles & General Automotive Discussions 07-30-2024, 10:37 AM
Replies: 6
Views: 800
Posted By Sasquachulator
Akio Toyoda really wants all his sports cars back...

Akio Toyoda really wants all his sports cars back before Toyota fully shitcans him and turns the entire lineup into rolling iphones to "keep up with the times"

Let him cook you corporate mooks!
...
Forum: Engine Swaps 07-27-2024, 09:17 PM
Replies: 34
Views: 3,937
Posted By blsfrs
Check their FB pages. There are pictures of...

Check their FB pages. There are pictures of their cam trigger plates. All of the other pulleys look the same.
Forum: Engine Swaps 07-27-2024, 08:29 PM
Replies: 34
Views: 3,937
Posted By makinen
Are other pulleys same? I'd like to reuse my...

Are other pulleys same?
I'd like to reuse my electric water pump on FA24 so the water pump pulley might not be an issue.

My 2013 engine was blown and stock FA24 was sourced. I wonder how RS...
Forum: Engine Swaps 07-27-2024, 10:32 AM
Replies: 34
Views: 3,937
Posted By blsfrs
It is my stock 2013 ecu.

It is my stock 2013 ecu.
Forum: Engine Swaps 07-25-2024, 04:20 PM
Replies: 34
Views: 3,937
Posted By Ultramaroon
Should I ever frag my original engine, this will...

Should I ever frag my original engine, this will be my solution. It's a no-brainer.
Forum: Forced Induction 07-24-2024, 08:43 PM
Replies: 4,308
Views: 1,374,270
Posted By FTemplar
Hello, New Kraftwerks C30 owner here :) ...

Hello,
New Kraftwerks C30 owner here :)

2013 Subaru BRZ AT Transmission
243 WHP @ 9 PSI
187 LB Torque

I went for a conservative setup so that I may enjoy this car for years to come.

This...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -4. The time now is 06:11 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.