follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 22 of 22
Search took 0.30 seconds.
Search: Posts Made By: 86driftcar
Forum: Forced Induction 05-04-2020, 12:27 AM
Replies: 9,139
Views: 2,837,365
Posted By sroby
POV oil.

That’s more than like,y not POV oil seeping out the back of the charger. The front seals from sprintex are not good. They need to be Viton high gear and presure seals. Jon Bond has them. That’s...
Forum: Forced Induction 05-04-2020, 12:16 AM
Replies: 9,139
Views: 2,837,365
Posted By sroby
Jon Bond info

JonBondPergormance.com. Google your new best friend ✌️
Forum: Forced Induction 04-30-2020, 06:07 PM
Replies: 9,139
Views: 2,837,365
Posted By ls1ac
Some people have had trouble with the plastic...

Some people have had trouble with the plastic fittings on the back of the supercharger and have had to remove the unit to fix. You might look into brass before installing. I have had no trouble yet,...
Forum: Forced Induction 04-13-2020, 11:07 PM
Replies: 9,139
Views: 2,837,365
Posted By sroby
Supercharger run dry

You need to get in touch with Jon Bond performance. He is now your (John:3/16) He can give you the reasons on why these unit have an inherent issue with front seals. Especially if you let it run...
Forum: Forced Induction 04-09-2020, 02:35 PM
Replies: 9,139
Views: 2,837,365
Posted By 86TOYO2k17
He hasn’t logged in, in almost 3 years. ...

He hasn’t logged in, in almost 3 years.

Very possible. But depends a lot on how low, for how long, and how hard it was driven.
But the dmg is done if any was done.
Top her off, and keep...
Forum: Forced Induction 04-02-2020, 11:50 AM
Replies: 9,139
Views: 2,837,365
Posted By ls1ac
Do not put soap in the cooler. If you must, use...

Do not put soap in the cooler. If you must, use radiator flush but not necessary. Just change one more time.
Forum: Forced Induction 04-01-2020, 10:45 PM
Replies: 9,139
Views: 2,837,365
Posted By sam69
Will not be a problem but would suggest you add...

Will not be a problem but would suggest you add some dish detergent to the reservoir to help break the oil down before draining then top up with water and drain/flush again then you should be all...
Forum: Forced Induction 03-31-2020, 09:21 AM
Replies: 9,139
Views: 2,837,365
Posted By 86TOYO2k17
he hasn't been on in over 2 years. and i don't...

he hasn't been on in over 2 years. and i don't think he dynoed it. also i asked him a while ago and he never got custom tuned for the WMI just added it.
also all dynos read differently, you could...
Forum: Forced Induction 02-26-2020, 12:07 AM
Replies: 30
Views: 5,960
Posted By jflogerzi
I would recommend this idler pulley Dorman...

I would recommend this idler pulley

Dorman 419-610 Idler Pulley https://www.amazon.com/dp/B003QVIXYU?ref=ppx_pop_mob_ap_share

Belt I use

Gates K061015 Multi V-Groove Belt...
Forum: Forced Induction 01-19-2020, 11:26 PM
Replies: 30
Views: 5,960
Posted By jflogerzi
This is the belt I use Gates K061015 Multi...

This is the belt I use

Gates K061015 Multi V-Groove Belt
Forum: Forced Induction 01-19-2020, 07:06 PM
Replies: 30
Views: 5,960
Posted By Ultramaroon
Also with different size pulleys comes the need...

Also with different size pulleys comes the need for different length belts. To set the tensioner operating in its most effective range, select the shortest possible belt that can be fitted without...
Forum: Forced Induction 01-19-2020, 05:35 PM
Replies: 30
Views: 5,960
Posted By JDM_Import
Squeaks, weird noises, ECUTEK problems etc lol......

Squeaks, weird noises, ECUTEK problems etc lol...

Welcome to the boosted club... a car that wasn't designed to take boost

Aren't we all victims... mines been doing the same shit and Im as...
Forum: Forced Induction 01-19-2020, 02:27 PM
Replies: 30
Views: 5,960
Posted By Ultramaroon
Your sound is belt slippage. Look at how the...

Your sound is belt slippage. Look at how the squeak is timed exactly with each complete cycle of the belt movement. It's most likely slipping over the alternator pulley. Once the battery charges...
Forum: Forced Induction 01-18-2020, 08:44 PM
Replies: 30
Views: 5,960
Posted By ls1ac
To make measurement easier in the future, I went...

To make measurement easier in the future, I went through the above procedure to get the proper level, then let the car down in its normal parking place and inserted a small screwdriver and marked the...
Forum: Forced Induction 01-18-2020, 07:27 PM
Replies: 30
Views: 5,960
Posted By jflogerzi
Another good point. To get a correct reading you...

Another good point. To get a correct reading you need to jack up the rear end to get the engine at a flat level

Sent from my GM1915 using Tapatalk
Forum: Forced Induction 01-18-2020, 07:24 PM
Replies: 30
Views: 5,960
Posted By whataboutbob
I ran one of these kits for 62K miles. I'd...

I ran one of these kits for 62K miles. I'd recommend checking the gear oil in the blower on a very regular basis, it will consume oil and if it goes dry bad things will happen.
Forum: Forced Induction 01-18-2020, 04:42 PM
Replies: 30
Views: 5,960
Posted By jflogerzi
Dorman 419-610 Idler Pulley...

Dorman 419-610 Idler Pulley https://www.amazon.com/dp/B003QVIXYU/ref=cm_sw_r_sms_apa_i_yT3iEbDB97W6J

Try this. The stock one will not work as you drop the down to smaller sc pulleys

Sent from...
Forum: Forced Induction 01-16-2020, 09:48 AM
Replies: 9,139
Views: 2,837,365
Posted By ptschmidt77
I had this exact problem. Other symptoms were, no...

I had this exact problem. Other symptoms were, no flat-foot shift, and being unable to select maps with the cruise control stalk while being able to change them via the ECUtek mobile app. It turned...
Forum: Forced Induction 01-16-2020, 01:55 AM
Replies: 30
Views: 5,960
Posted By jflogerzi
Are you talking about that squeak? If so it's the...

Are you talking about that squeak? If so it's the belt. What pulley do you have? Mine did that for a bit after I switched to the 69mm from the 72.5 but it's gone away. Get a spray bottle of water and...
Forum: Forced Induction 01-13-2020, 09:37 PM
Replies: 9,139
Views: 2,837,365
Posted By 86TOYO2k17
From my understanding, you need to be fully...

From my understanding, you need to be fully stationary as LC doesn’t work if your rolling at 6+mph (although mph limit varies depending on LC settings). In first gear press clutch in 100% press...
Forum: CANADA 12-08-2019, 12:08 PM
Replies: 39
Views: 8,523
Posted By JDM_Import
I haven't done a RaceGas tune yet but I have a...

I haven't done a RaceGas tune yet but I have a buddy who did and gained +35hp and +20lb-ft
Forum: CANADA 10-11-2019, 09:16 PM
Replies: 39
Views: 8,523
Posted By Lynxis
I am always sceptical of products that make...

I am always sceptical of products that make claims like this.

The marketing literature make it seem to work like a high performance octane booster. I can find no sign that it's safe for catalytic...
Showing results 1 to 22 of 22

 
Forum Jump

All times are GMT -4. The time now is 02:15 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.