follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Members List


CSG Mike CSG Mike is offline

Trader Rating

iTrader Profile Recent Ratings
Trader Rating:
Positive Feedback:
13
100.0%
Members who left positive:
Members who left negative:
13
0
Total positive feedback: 14
View Complete Feedbacks for CSG Mike
  Past
Month
Past
6 Months
Past
12 Months
 Positive 0 0 0
 Neutral 0 0 0
 Negative 0 0 0

Visitor Messages

Showing Visitor Messages 1 to 6 of 6
  1. Brewster
    03-21-2022 02:28 PM
    Brewster
    "I'll be pulling all the injectors to be cleaned soon. The left DI fuel rail and crossover pipe are noted on Toyota's service diagram as not to be reused, but at $390, I'm tempted to."

    Mike, you thanked me for this post.... would you share your opinion ?
  2. dholloway543
    09-07-2020 03:37 PM
    dholloway543
    Back in 2013 you said this in a forum post



    I'd recommend a REALLY powerful fan.

    We actually run that setup on our ~400hp s2k; stock radiator and a 20A 12" SPAL (which we sell).

    PM me the measurements on your fan clearance, and I'll get you a recommendation.


    https://www.ft86club.com/forums/show...t=53580&page=6



    I read this in a forum from back in 2013 and I was wondering if you could find me a fan that would fit the mishimoto fan shroud.


    I have

    Mishimoto oil cooler
    Mishimoto dual thickness radiator
    Mishimoto slim fans


    on a SBD500x turbo kit and im overheating coolant bad 115C+. I need to find a solution bad before i destroy something due to heat.
  3. G_Rossney
    10-29-2018 02:18 PM
    G_Rossney
    Mike, If you still update the wheel fitment in the forum. I can confirm that the Konig Hypergram 17x8 5-100 40mm (GYMTXX) fit over the '17 Brembo package. They weigh 16.7lbs, just under 17 lbs.
  4. Keenercarguy
    12-20-2015 12:02 AM
    Keenercarguy
    So I have a very simple clarification queation, Carbotech AX6's will hold up better to an HPDE than OE brake pads, right?
  5. RedLeader
    06-23-2013 04:02 AM
    RedLeader
    Alright Mike, you routinely track your FRS/BRZ, so I have a brake question for you: I'm running DS2500 front pads on stock rotors and at the last track day here (we use a kart racing track), my rotor temps were over 1000 degrees once I got off the track. Admittedly, the track is very brake intensive and there's very little time between corners to allow them to cool normally. My question is: do I fab up some sort of brake ducting, or would slotted rotors be enough to help the heat problem? I wish one of my coworkers watching from the bleachers had taken a picture of my front rotors apparently glowing a bright orange, they were still glowing when my session was over and I'd parked the car.
  6. Pinky
    04-02-2013 01:20 PM
    Pinky
    Hi mike
    It's pinky we talk on Saturday at the long beach meet. I was the one guy that ask bout gold sticket lol.
    U think u could make me a sticker for my car saying autism speaks

About Me

  • About CSG Mike
    Car
    S2000 CR
    Location
    Orange County

Statistics

Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: Yesterday 04:17 PM
  • Join Date: 07-31-2012

Friends

Showing Friends 51 to 52 of 52
  • Xerious
    • Xerious
    • Speed Chaser Thrill Seekr
    • Xerious is offline
  • zex
    • zex
    • Senior Member
    • zex is offline

Mentions

11-05-2021
02:04 PM - CSG Mike mentioned glamcem in post Mike's 2022 BRZ
glamcem the reason I use mul...
11-04-2021
08:22 PM - jflogerzi mentioned CSG Mike in post Mike's 2022 BRZ
...TIPS ready guys :) CSG Mikes Wallets Tips Appre...
11-03-2021
02:44 PM - ayau mentioned CSG Mike in post Mike's 2022 BRZ
CSG Mike any particular reaso...
10-07-2021
09:00 PM - jkamelo mentioned CSG Mike in post Jackson Racing Supercharger Owners Thread
...BTW. Shining the CSG Mike bat signal!
09-27-2021
06:25 PM - Dylans47 mentioned CSG Mike in post GR86 upgrade stock brakes or wait for Performance Pack?
CSG Mike, will you becoming a...
05:12 PM - Calum mentioned CSG Mike in post Perrin 3" Resonated - Going Turbo
...ould have contacted CSG Mike.
12:37 PM - Dylans47 mentioned CSG Mike in post GR86 upgrade stock brakes or wait for Performance Pack?
...t dig deep enough. CSG Mike where you at? :thumb...
09-14-2021
05:07 PM - geraldjust mentioned CSG Mike in post Open Source Flex Fuel
...yone to use. EDIT: CSG Mike you may be right so ...
09-11-2021
09:19 PM - CSG Mike mentioned CounterSpace Garage in post Greddy T518Z Turbo
...u considered having CounterSpace Garage tuning your car remo...
09-08-2021
01:28 PM - Pete mentioned CSG Mike in post Edelbrock E-force Owner's thread and FAQs (Frequently Asked Questions)
...or the new cars. CSG Mike I can't wait to see...

Thread Tags

09-03-2014
02:25 PM - glamcem tagged CSG Mike in thread glamcem's Rotrex Supercharged (Krafwerks) _PART OUT
08-25-2014
04:01 PM - King Tut tagged CSG Mike in thread King Tut's Time Attack Build
04-08-2014
04:10 PM - Deleted Threads
02-26-2014
08:14 PM - OrbitalEllipses tagged CSG Mike in thread Tags not working

Quotes

12-06-2023
12:21 PM - CSG Mike quoted Griever423 in post OEM Brembo Rotors and Pads for Cheap!
Could you please shed some insi...
09:28 AM - Griever423 quoted CSG Mike in post OEM Brembo Rotors and Pads for Cheap!
Does it fit? Yes. Is it eff...
12-05-2023
05:40 PM - CSG Mike quoted ThatYeti in post OEM Brembo Rotors and Pads for Cheap!
Are those not factory replace...
01:26 PM - ThatYeti quoted CSG Mike in post OEM Brembo Rotors and Pads for Cheap!
When it's too good to be true...
12-04-2023
02:42 PM - CSG Mike quoted teppey in post Brembo BM-4 caliper
Anyone have info regarding ...
11-27-2023
05:58 PM - CSG Mike quoted Ultramaroon in post Oil weight for track only car with a lot of cooling?
You know, looking at the chart, ...
12:26 AM - CSG Mike quoted Ohio Enthusiast in post I ran CSG CP pads in AP 9660 calipers on track with my ZD8
So these are like the Carbotech AX-6...
12:25 AM - CSG Mike quoted dragoontwo in post CSG Spec Brake Compounds Review Thread
If you say so. What is the new...
11-26-2023
06:13 PM - dragoontwo quoted CSG Mike in post CSG Spec Brake Compounds Review Thread
dragoontwo two those look bas...
04:33 PM - Ohio Enthusiast quoted CSG Mike in post I ran CSG CP pads in AP 9660 calipers on track with my ZD8
The SP1 is a true street pad ...

All times are GMT -4. The time now is 06:34 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.