follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Members List


CSG Mike CSG Mike is offline

Trader Rating

iTrader Profile Recent Ratings
Trader Rating:
Positive Feedback:
13
100.0%
Members who left positive:
Members who left negative:
13
0
Total positive feedback: 14
View Complete Feedbacks for CSG Mike
  Past
Month
Past
6 Months
Past
12 Months
 Positive 0 0 0
 Neutral 0 0 0
 Negative 0 0 0

Visitor Messages

Showing Visitor Messages 1 to 6 of 6
  1. Brewster
    03-21-2022 02:28 PM
    Brewster
    "I'll be pulling all the injectors to be cleaned soon. The left DI fuel rail and crossover pipe are noted on Toyota's service diagram as not to be reused, but at $390, I'm tempted to."

    Mike, you thanked me for this post.... would you share your opinion ?
  2. dholloway543
    09-07-2020 03:37 PM
    dholloway543
    Back in 2013 you said this in a forum post



    I'd recommend a REALLY powerful fan.

    We actually run that setup on our ~400hp s2k; stock radiator and a 20A 12" SPAL (which we sell).

    PM me the measurements on your fan clearance, and I'll get you a recommendation.


    https://www.ft86club.com/forums/show...t=53580&page=6



    I read this in a forum from back in 2013 and I was wondering if you could find me a fan that would fit the mishimoto fan shroud.


    I have

    Mishimoto oil cooler
    Mishimoto dual thickness radiator
    Mishimoto slim fans


    on a SBD500x turbo kit and im overheating coolant bad 115C+. I need to find a solution bad before i destroy something due to heat.
  3. G_Rossney
    10-29-2018 02:18 PM
    G_Rossney
    Mike, If you still update the wheel fitment in the forum. I can confirm that the Konig Hypergram 17x8 5-100 40mm (GYMTXX) fit over the '17 Brembo package. They weigh 16.7lbs, just under 17 lbs.
  4. Keenercarguy
    12-20-2015 12:02 AM
    Keenercarguy
    So I have a very simple clarification queation, Carbotech AX6's will hold up better to an HPDE than OE brake pads, right?
  5. RedLeader
    06-23-2013 04:02 AM
    RedLeader
    Alright Mike, you routinely track your FRS/BRZ, so I have a brake question for you: I'm running DS2500 front pads on stock rotors and at the last track day here (we use a kart racing track), my rotor temps were over 1000 degrees once I got off the track. Admittedly, the track is very brake intensive and there's very little time between corners to allow them to cool normally. My question is: do I fab up some sort of brake ducting, or would slotted rotors be enough to help the heat problem? I wish one of my coworkers watching from the bleachers had taken a picture of my front rotors apparently glowing a bright orange, they were still glowing when my session was over and I'd parked the car.
  6. Pinky
    04-02-2013 01:20 PM
    Pinky
    Hi mike
    It's pinky we talk on Saturday at the long beach meet. I was the one guy that ask bout gold sticket lol.
    U think u could make me a sticker for my car saying autism speaks

About Me

  • About CSG Mike
    Car
    S2000 CR
    Location
    Orange County

Statistics

Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: Yesterday 10:53 PM
  • Join Date: 07-31-2012

Friends

Showing Friends 1 to 10 of 52

Mentions

07-03-2013
09:33 PM - Lonewolf mentioned CSG Mike in post Oil and tracking?
...rubber: ***We need CSG Mike in here...
07-02-2013
06:01 PM - OrbitalEllipses mentioned CSG Mike in post Has anyone had a warranty claim denied? Seized engine! Pics of teardown added 6/5
...means... CSG David CSG Mike CounterSpace Garage ...
05:57 PM - Deleted Posts
05:26 PM - OrbitalEllipses mentioned CSG Mike in post Has anyone had a warranty claim denied? Seized engine! Pics of teardown added 6/5
Y'all lawyered up, CSG Mike?
07-01-2013
01:37 AM - solidONE mentioned CSG Mike in post Best springs to go with stock dampers
...Mike. Great driving CSG Mike BTW and thanks! I wa...
06-27-2013
06:43 PM - FT-86 SpeedFactory mentioned CSG Mike in post ***FT-86 SpeedFactory's Road to the 86 Expo***
...ounterSpace Garage, CSG Mike ), and robispec were...
09:44 AM - #87 mentioned CSG Mike in post Has anyone had a warranty claim denied? Seized engine! Pics of teardown added 6/5
Any updates from CSG Mike
06-26-2013
05:07 PM - CSG Mike mentioned robispec in post Got a track related question? I'll try to answer.
...u don't want. Like robispec said... think muscle...
06-14-2013
11:12 PM - CSG Mike mentioned robispec in post Oem clutch...
is an Exedy. With robispec https://sphotos-a.x...
06-13-2013
01:03 PM - Pete mentioned CSG Mike in post Fun because drift car?
... the supercharger. CSG Mike was correct, he said...
04:50 AM - CSG Mike mentioned D1cker in post Track wheel Enkei RPF1 in 16" ??
...ge. Cheers Nathan @D1cker is the fastest non-s...
02:03 AM - SubieNate mentioned CSG Mike in post Track wheel Enkei RPF1 in 16" ??
...45's. robispec and CSG Mike should both confirm ...
06-12-2013
11:36 AM - CSG Mike mentioned robispec in post Got a track related question? I'll try to answer.
...res I've driven is @robispec's car on Hoosier A6....
11:34 AM - CSG Mike mentioned robispec in post Got a track related question? I'll try to answer.
...ires I've driven is robispec's car on Hoosier A6....
06-08-2013
04:11 AM - sw20kosh mentioned CSG Mike in post FT86Cup Round 4: WSIR 6/16/2013. Only $100 w/ timing!
...!!!!!!!!!!!!!!!!!! CSG Mike this high speed trac...
06-07-2013
02:13 AM - Anthonytpt mentioned CSG Mike in post Anthonytpt's Car Journal
... to @CSG David and @CSG Mike for getting the Weds...
06-05-2013
09:33 PM - SubieNate mentioned CSG Mike in post Direct Injector Leaking
... and in the case of CSG Mike's car resulted in a ...
11:27 AM - TemeCal mentioned CSG Mike in post Direct Injector Leaking
...d the most/first. CSG Mike - Do you recall how ...
06-04-2013
08:01 PM - CSG Mike mentioned GTM_Challenge in post Rotors, pads and fluid change
...ap times compare to GTM_Challenge's? You'll likely ne...
07:21 PM - Scrappy Jack mentioned CSG Mike in post Direct Injector Leaking
...lved ( Carwhisperer CSG Mike et al) need to copy ...

Thread Tags

09-01-2021
12:36 PM - AndMsc tagged CSG Mike in thread Tire real width on 17x9 +40
02-10-2017
03:13 PM - gramicci101 tagged CSG Mike in thread Upgrading from Essex Sprint to..?
09-05-2016
08:20 PM - gramicci101 tagged CSG Mike in thread Motul Gear Competition 75W-140 for differential?
06-30-2016
04:51 PM - gramicci101 tagged CSG Mike in thread Brake pad problem (CL Brakes RC5+)
01-14-2016
03:49 PM - KR-S tagged CSG Mike in thread F20C Swapped Brz
08-23-2015
03:07 PM - Ultramaroon tagged CSG Mike in thread Tagging is not working?
03-10-2015
11:10 AM - gramicci101 tagged CSG Mike in thread Uneven wear with AP Racing Sprint BBK
10-26-2014
12:34 AM - Ultramaroon tagged CSG Mike in thread Does the clutch fake you out?
09-17-2014
08:48 PM - Dezoris tagged CSG Mike in thread S2000 vs. FR-S BRZ Track Review Video | Part 2 of 2
09-12-2014
12:51 PM - ATL BRZ tagged CSG Mike in thread Pure Motorsport: JDL Turbo BRZ Track Build
09-03-2014
02:25 PM - glamcem tagged CSG Mike in thread glamcem's Rotrex Supercharged (Krafwerks) _PART OUT
08-25-2014
04:01 PM - King Tut tagged CSG Mike in thread King Tut's Time Attack Build
04-08-2014
04:10 PM - Deleted Threads
02-26-2014
08:14 PM - OrbitalEllipses tagged CSG Mike in thread Tags not working

Quotes

05-11-2021
01:59 PM - CSG Mike quoted ZDan in post Mechanical overrev, 9k
The issue also correlates...
05-10-2021
06:13 PM - CSG Mike quoted Tsugo in post Looking for twin scroll turbo kit
I guess I should extrapola...
05:41 PM - ZDan quoted CSG Mike in post Mechanical overrev, 9k
Interesting. How's steering ...
05:30 PM - CSG Mike quoted ZDan in post Mechanical overrev, 9k
Hmm, the only stints when...
02:26 PM - ZDan quoted CSG Mike in post Mechanical overrev, 9k
You can't starve a full tank ...
05-07-2021
07:12 PM - Joveen quoted CSG Mike in post Quoted $3,000 to install and tune a SC?
Bob has unfortunately passed,...
05-06-2021
08:35 PM - dynarun55 quoted CSG Mike in post Jackson Racing Supercharger Owners Thread
Port injectors yes, fuel pump...
06:13 PM - CSG Mike quoted dynarun55 in post Jackson Racing Supercharger Owners Thread
Thanks.. If i do go flex fuel,...
06:13 PM - BrahmaBull1990 quoted CSG Mike in post Quoted $3,000 to install and tune a SC?
Bob has unfortunately passed,...
06:11 PM - CSG Mike quoted tmaz42o in post Quoted $3,000 to install and tune a SC?
Call Bob at Drift-Office in ...
06:05 PM - dynarun55 quoted CSG Mike in post Jackson Racing Supercharger Owners Thread
1. everything you should do a...
06:00 PM - CSG Mike quoted dynarun55 in post Jackson Racing Supercharger Owners Thread
Finally decided to pull the tr...
05-04-2021
09:22 PM - dynarun55 quoted CSG Mike in post Edelbrock E-force Owner's thread and FAQs (Frequently Asked Questions)
None seem to have failed sinc...
08:32 PM - CSG Mike quoted dynarun55 in post Edelbrock E-force Owner's thread and FAQs (Frequently Asked Questions)
Hey guys, I'm relatively new...
03:44 PM - timurrrr quoted CSG Mike in post CSG Spec Tein Flex A Owners Thread
You should not be having chas...
03:39 PM - timurrrr quoted CSG Mike in post CSG Spec Tein Flex A Owners Thread
Are you using camber bolts or...
03:35 PM - timurrrr quoted CSG Mike in post CSG Spec Tein Flex A Owners Thread
Speaking of endlinks, is that...
05-02-2021
07:22 PM - CSG Mike quoted Jasper in post Oil cooler or JR Dual radiator
Edelbrock talk: The fate...
06:21 PM - Jasper quoted CSG Mike in post Oil cooler or JR Dual radiator
The former won't work with a ...
05:25 PM - CSG Mike quoted Jasper in post Oil cooler or JR Dual radiator
What are your thoughts on s...

All times are GMT -4. The time now is 10:24 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.